Influence of anaerobiosis and low temperature on Bacillus cereus growth, metabolism, and membrane properties.

Appl Environ Microbiol

INRA, UMR408 Sécurité et Qualité des Produits d’Origine Végétale, Avignon, France.

Published: March 2012

The impact of simultaneous anaerobiosis and low temperature on growth parameters, metabolism, and membrane properties of Bacillus cereus ATCC 14579 was studied. No growth was observed under anaerobiosis at 12°C. In bioreactors, growth rates and biomass production were drastically reduced by simultaneous anaerobiosis and low temperature (15°C). The two conditions had a synergistic effect on biomass reduction. In anaerobic cultures, fermentative metabolism was modified by low temperature, with a marked reduction in ethanol production leading to a lower ability to produce NAD(+). Anaerobiosis reduced unsaturated fatty acids at both low optimal temperatures. In addition, simultaneous anaerobiosis and low temperatures markedly reduced levels of branched-chain fatty acids compared to all other conditions (accounting for 33% of total fatty acids against more 71% for low-temperature aerobiosis, optimal-temperature aerobiosis, and optimal-temperature anaerobiosis). This corresponded to high-melting-temperature lipids and to low-fluidity membranes, as indicated by differential scanning calorimetry, 1,6-diphenyl-1,3,5-hexatriene (DPH) fluorescence anisotropy, and infrared spectroscopy. This is in contrast to requirements for cold adaptation. A link between modification in the synthesis of metabolites of fermentative metabolism and the reduction of branched-chain fatty acids at low temperature under anaerobiosis, through a modification of the oxidizing capacity, is assumed. This link may partly explain the impact of low temperature and anaerobiosis on membrane properties and growth performance.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC3298147PMC
http://dx.doi.org/10.1128/AEM.06410-11DOI Listing

Publication Analysis

Top Keywords

low temperature
24
anaerobiosis low
16
fatty acids
16
membrane properties
12
simultaneous anaerobiosis
12
low
8
bacillus cereus
8
metabolism membrane
8
anaerobiosis
8
fermentative metabolism
8

Similar Publications

Enhancing biofuel pellet quality using torrefaction and co-pelletization of palm kernel shell and empty fruit bunch.

Environ Sci Pollut Res Int

January 2025

Faculty of Chemical & Process Engineering Technology, Universiti Malaysia Pahang Al-Sultan Abdullah, Lebuh Persiaran Tun Khalil Yaakob, 26300, Kuantan, Pahang, Malaysia.

Palm kernel shell (PKS) and empty fruit bunch (EFB) are potential biomass resources for producing solid biofuel for energy applications. However, raw EFB and PKS are not uniform in size and pose rotting behavior. Torrefaction and co-pelletization are both effective methods to improve their combustion and mechanical characteristics.

View Article and Find Full Text PDF

Lattice defect engineering advances n-type PbSe thermoelectrics.

Nat Commun

January 2025

School of Chemistry and Physics, ARC Research Hub in Zero-emission Power Generation for Carbon Neutrality, and Centre for Materials Science, Queensland University of Technology, Brisbane, QLD, Australia.

Te-free thermoelectrics have garnered significant interest due to their immense thermoelectric potential and low cost. However, most Te-free thermoelectrics have relatively low performance because of the strong electrical and thermal transport conflicts and unsatisfactory compatibility of interfaces between device materials. Here, we develop lattice defect engineering through Cu doping to realize a record-high figure of merit of ~1.

View Article and Find Full Text PDF

Enhanced Prediction of CO-Brine Interfacial Tension at Varying Temperature Using a Multibranch-Structure-Based Neural Network Approach.

Langmuir

January 2025

Key Laboratory of Ocean Energy Utilization and Energy Conservation of Ministry of Education, School of Energy and Power Engineering, Dalian University of Technology, Dalian 116023, P. R. China.

Interfacial tension () between CO and brine depends on chemical components in multiphase systems, intricately evolving with a change in temperature. In this study, we developed a convolutional neural network with a multibranch structure (MBCNN), which, in combination with a compiled data set containing measurement data of 1716 samples from 13 available literature sources at wide temperature and pressure ranges (273.15-473.

View Article and Find Full Text PDF

Water Activity as an Indicator for Antibody Storage Stability in Lyophilized Formulations.

Mol Pharm

January 2025

Laboratory of Thermodynamics, Department of Biochemical and Chemical Engineering, TU Dortmund University, Emil-Figge-Street 70, Dortmund 44227, Germany.

Lyophilization remains a key method for preserving sensitive biopharmaceuticals such as monoclonal antibodies. Traditionally, stabilization mechanisms have been explained by vitrification, which minimizes molecular mobility in the lyophilized cake, and water replacement, which restores molecular interactions disrupted by water removal. This study proposes a novel design strategy that combines water activity and glass-transition temperature as the main indicators to predict long-term stability in lyophilized formulations.

View Article and Find Full Text PDF

Poly (lactic acid) (PLA) is a widely produced bio-based polymer known for its biodegradability and renewability, but its brittleness, low heat resistance, and weak mechanical properties limit its broader use. To address these challenges, TEMPO-oxidized cellulose nanofibers (TOCNF) were extracted from dissolving pulp using TEMPO oxidation and high-pressure homogenization. These TOCNF were modified with silane to reduce hydrophilicity and improve compatibility with PLA.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!