Photocatalytic removal of cyanide with illuminated TiO(2).

Water Sci Technol

Environmental Health Research Center, Kurdistan University of Medical Science, Sanandaj, Kurdistan, Iran.

Published: April 2012

Effects of TiO(2) dosage, pH and initial cyanide concentration on the removal efficiency of cyanide from aqueous solutions with illuminated TiO(2) have been investigated. Adsorption and oxidation were recognized as significant processes for the elimination of cyanide. From the Langmuir isotherm, the maximum adsorption capacity was determined as 17.24 mg/g at pH 7. Adsorbed amount of cyanide slightly increased as the TiO(2) dosage increased. However, as no significant increase was observed above 1 g/L TiO(2), an optimum TiO(2) dosage was determined as 1 g/L. Photocatalytic oxidation efficiency of cyanide was greatly affected by the solution pH. It increased as the solution pH decreased. The photocatalytic oxidation efficiency after 120 min was 80.4% at pH 3 while it was only 20.4% at pH 11. Photocatalytic oxidation of cyanide was well described by the second-order kinetics. Photocatalytic reaction with illuminated TiO(2) can be effectively applied to treat industrial wastewater contaminated with cyanide.

Download full-text PDF

Source
http://dx.doi.org/10.2166/wst.2011.738DOI Listing

Publication Analysis

Top Keywords

illuminated tio2
12
tio2 dosage
12
photocatalytic oxidation
12
cyanide
8
efficiency cyanide
8
oxidation efficiency
8
tio2
7
photocatalytic
5
photocatalytic removal
4
removal cyanide
4

Similar Publications

The utilisation of implantable medical devices has become safer and more prevalent since the establishment of sterilisation methods and techniques a century ago. Nevertheless, device-associated infections remain a significant and growing concern, particularly in light of the continued rise in the number of medical device implantations. This underscores the imperative for the development of efficacious prevention and treatment strategies for device-associated infections, as well as further investigation into the design of innovative antibacterial surfaces for medical device applications.

View Article and Find Full Text PDF

Visible light induced photocatalytic degradation of norfloxacin using xC-TiO.

Heliyon

January 2025

Institute of Chemical Sciences, University of Swat, Swat, 19120, Khyber Pakhtunkhwa, Pakistan.

In recent years, antibiotic pollution has become a major environmental concern. The extensive production and widespread use of prescribed antibiotics have significantly impacted ecosystems. The main objective of the present study is to investigate the photocatalytic degradation of the antibiotic norfloxacin (NFX) under visible light.

View Article and Find Full Text PDF

Mesoporous Fe2O3-TiO2 Integrated with Plasmonic Ag Nanoparticles for Enhanced Solar H2 Production.

Chem Asian J

January 2025

CSIR-National Chemical Laboratory: CSIR National Chemical Laboratory, Catalysis and Inorganic Chemistry Division, Dr. Homi Bhabha Road, 411 008, Pune, INDIA.

Present work describes a sol-gel assisted one-pot synthesis of mesoporous Fe₂O₃-TiO₂ nanocomposites (TiFe) with different Ti:Fe ratios, and fabrication of Ag-integrated with TiFe nanocomposites (TiFeAg) by a chemical reduction method and demonstrated for high solar H2 generation activity in direct sunlight. Enhanced solar H2 production is attributed to the light absorption from entire UV+Visible region of solar spectrum combined with Schottky (Ag-semiconductor) and heterojunctions (TiO2-Fe2O3), as evidenced from HRTEM and various characterization studies.  TiFeAg-2 thin film (1 wt% Ag-loaded TiFe-4) displayed the highest activity with a solar H2 yield of 7.

View Article and Find Full Text PDF

A Review of Laboratory Studies on the Heterogeneous Chemistry of NO: Mechanisms and Uptake Kinetics.

J Phys Chem A

January 2025

State Key Joint Laboratory of Environment Simulation and Pollution Control, Research Center for Eco-Environmental Sciences, Chinese Academy of Sciences, Beijing 100085, China.

NO is a significant primary atmospheric pollutant that plays a key role in atmospheric chemistry. It serves as a crucial precursor to photochemical smog, acid rain, and secondary particulate matter and is instrumental in determining the atmospheric oxidation capacity. In this review, we focus on the heterogeneous chemistry of NO, which has been demonstrated to significantly influence the sources and sinks of various nitrogen-containing species through field measurements and model simulations.

View Article and Find Full Text PDF

Expression of Concern for 'Photo-induced reduction of CO using a magnetically separable Ru-CoPc@TiO@SiO@FeO catalyst under visible light irradiation' by Pawan Kumar , ., 2015, , 4546-4553, https://doi.org/10.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!