The photocatalytic degradation of two phenolic compounds, p-coumaric acid and caffeic acid, was performed with a suspended mixture of TiO(2) and powdered activated carbon (PAC) (at pH=3.4 and 8). Adsorption, direct photolysis and photocatalytic degradation were studied under different pH and UV light sources (sunlight vs. 365nm UV lamps). The potential for reusing this catalyst mixture in sequential photocatalytic runs was examined as well. Quantum yields for the direct photolysis of caffeic acid under solar and artificial 365nm light were calculated (for the first time) as 0.005 and 0.011, respectively. A higher removal rate of contaminants by either adsorption or photocatalysis was obtained at a low pH (pH 4). Furthermore, the addition of PAC increased the removal efficiency of the phenolic compounds. Fast removal of the pollutants from the solution over three sequential runs was achieved only when both TiO(2) and PAC were present. This suggests that at medium phenolic concentrations, the presence of PAC as a co-sorbent reduces surface poisoning of the TiO(2) catalyst and hence improves photocatalysis degradation of phenolic pollutants. The adsorption equilibrium of caffeic acid or p-coumaric acid on TiO(2), PAC and the combined mixture of TiO(2) and PAC follows the Langmuir isotherm model. Experiments with PAC TiO(2) mixture and olive mill wastewater (anaerobically treated and diluted by a factor of 10) showed higher removal of polyphenols than of chemical oxygen demand (COD). 87% removal of total polyphenols, compared to 58% of COD, was achieved after 24h of exposure to 365nm irradiation (7.6W/m(2)) in the presence of a suspended mixture of TiO(2) and PAC, indicating "self-selectivity" of polyphenols.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.watres.2011.11.049DOI Listing

Publication Analysis

Top Keywords

tio2 pac
16
photocatalytic degradation
12
phenolic compounds
12
caffeic acid
12
mixture tio2
12
olive mill
8
mill wastewater
8
degradation phenolic
8
p-coumaric acid
8
suspended mixture
8

Similar Publications

The success of any drilling activity mainly depends on the characteristics of the drilling fluid. Therefore, a high-performance drilling fluid is substantial for any drilling operation. During overbalance drilling operations, the drilling mud invades the permeable formations and causes the loss of circulation, which is responsible for nonproductive time events.

View Article and Find Full Text PDF

The presence of active pharmaceutical ingredients (APIs) in wastewater effluents and natural aquatic systems threatens ecological and human health. While activated carbon-based adsorbents, such as GAC and PAC, are widely used for API removal, they exhibit certain deficiencies, including reduced performance due to the presence of natural organic macromolecules (NOMs) and high regeneration costs. There is growing demand for a robust, stable, and self-regenerative adsorbent designed for API removal in various environments.

View Article and Find Full Text PDF

Microplastics are a significant environmental threat and the lack of efficient removal techniques further amplifies this crisis. Photocatalytic semiconducting nanoparticles have the potential to degrade micropollutants, among them microplastics. The hydrodynamic effects leading to the propulsion of micromotors can lead to the accumulation of microplastics in close vicinity of the micromotor.

View Article and Find Full Text PDF

Fate of sulfamerazine by synchronous adsorption and photocatalysis dependent on natural organic matter properties.

Environ Technol

July 2024

Faculty of Architecture, Civil and Transportation Engineering, Beijing University of Technology, Beijing, People's Republic of China.

Natural organic matter (NOM) can impede the removal of organic micro-pollutants (OMPs) through several mechanisms, including inner filter effect, competition with the target OMP, and radical scavenging, during synchronous adsorption/photocatalysis of multi-functional composites. In this study, the fate and inhibitory mechanisms of sulfamerazine (SMZ, a model OMP) that occurred in presence of seven different NOM samples (i.e.

View Article and Find Full Text PDF

Low surface energy and hydrophobicity of polymethyl methactylate (PMMA) are the main disadvantages of this biomaterial. The aim of this study was to investigate the effects of a new coating process on the surface characteristics and properties of PMMA. A combination of temperature and pressure was used for deposition of titanium dioxide (TiO) on the surface of PMMA.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!