On chip plasmonic monopole nano-antennas and circuits.

Nano Lett

Department of Electrical and Computer Engineering and Photonics Center, Boston University, 8 St. Mary's Street, Boston, Massachusetts 02215, United States.

Published: December 2011

Analogues of many radio frequency (RF) antenna designs such as the half-wave dipole and Yagi-Uda have been successfully adapted to the optical frequency regime, opening the door for important advances in biosensing, photodetection, and emitter control. Examples of monopole antennas, however, are conspicuously rare given the element's extensive use in RF applications. Monopole antennas are attractive as they represent an easy to engineer, compact geometry and are well isolated from interference due the ground plane. Typically, however, the need to orient the antenna element perpendicular to a semi-infinite ground plane requires a three-dimensional structure and is incompatible with chip-based fabrication techniques. We propose and demonstrate here for the first time that monopole antenna elements can be fashioned out of single element nanoparticles fabricated in conventional planar geometries by using a small nanorod as a wire reflector. The structure offers a compact geometry and the reflector element provides a measure of isolation analogous to the RF counterpart. This isolation persists in the conductive coupling regime, allowing multiple monopoles to be combined into a single nanoparticle, yet still operate independently. This contrasts with several previous studies that observed dramatic variations in the spectral response of conductively coupled particles. We are able to account for these effects by modeling the system using circuit equations from standard RF antenna theory. Our model accurately describes this behavior as well as the detailed resonance tuning of the structure. As a specific practical application, the monopole resonances are precisely tuned to desired protein absorption bands, thereby enhancing their spectroscopic signatures. Furthermore, the accurate modeling of conductive coupling and demonstrated electronic isolation should be of general interest to the design of complex plasmonic circuits incorporating multiple antennas and other current carrying elements.

Download full-text PDF

Source
http://dx.doi.org/10.1021/nl202528hDOI Listing

Publication Analysis

Top Keywords

monopole antennas
8
compact geometry
8
ground plane
8
conductive coupling
8
monopole
5
chip plasmonic
4
plasmonic monopole
4
monopole nano-antennas
4
nano-antennas circuits
4
circuits analogues
4

Similar Publications

This work presents a small four-port multiple-input multiple-output (MIMO) antenna for Ultra Wideband (UWB) applications. Four monopole radiating components make up the suggested antenna. Every monopole is positioned perpendicularly to the components that surround it.

View Article and Find Full Text PDF

A 2-D Fully Polarized Van Atta Array Based on Wide-Beam Tri-Polarized Antennas.

Micromachines (Basel)

November 2024

National Key Laboratory of Radar Detection and Sensing, Xidian University, Xi'an 710071, China.

This paper proposes a 2-D fully polarized Van Atta array, which consists of four tri-polarized antenna elements. The tri-polarized antenna element comprises a monopole antenna and a low-profile microstrip antenna that widens the beam by folding four electric walls. This configuration enables the Van Atta arrays to receive and transmit arbitrarily polarized incident waves over a wider range.

View Article and Find Full Text PDF
Article Synopsis
  • - The study introduces a circularly-polarized planar monopole antenna designed for ultra-wideband (UWB) applications, utilizing characteristic mode analysis (CMA) to achieve broader bandwidths.
  • - A crescent-shaped radiator and circular open-loop antenna initially had limited performance in achieving wideband characteristics; modifications like a triangular slit and L-shaped strip were added to improve the axial ratio bandwidth substantially.
  • - The final design boasts a compact size and impressive performance metrics, including a -10 dB S bandwidth of 5.73-10.78 GHz, a 3 dB axial ratio bandwidth of 6-11.12 GHz, and effective gain and efficiency, demonstrating strong omnidirectional radiation patterns across frequencies. *
View Article and Find Full Text PDF

Small-Size Eight-Element MIMO Metamaterial Antenna with High Isolation Using Modal Significance Method.

Sensors (Basel)

September 2024

CINVESTAV-IPN, Telecommunications Section, Av. IPN 2508, San Pedro Zacatenco, Ciudad de México 07360, Mexico.

This article presents a symmetrical reduced-size eight-element MIMO antenna array with high electromagnetic isolation among radiators. The array utilizes easy-to-build techniques to cover the n77 and n78 new radio (NR) bands. It is based on an octagonal double-negative metamaterial split-ring resonator (SRR), which enables a size reduction of over 50% for the radiators compared to a conventional disc monopole antenna by increasing the slow-wave factor.

View Article and Find Full Text PDF

Dual-Band Monopole MIMO Antenna Array for UAV Communication Systems.

Sensors (Basel)

September 2024

School of Information and Communications Engineering, Xi'an Jiaotong University, Xi'an 710049, China.

This study proposes a compact, low-profile, four-port dual-band monopole multiple-input-multiple-output (MIMO) antenna array for unmanned aerial vehicle (UAV) communication systems. Each monopole antenna of the array features a modified T-shaped radiator configuration and is printed on a Rogers RT5880 substrate with compact dimensions of 134.96 mm × 134.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!