This paper presents a simple way of controlling the wettability of a structured surface with ZnO nanorods on a transparent substrate. A combination of ZnO nanostructures and stearic acid was used to create superhydrophobic surfaces with the potential properties of being self-cleaning, waterproof, and antifog. ZnO nanorods were uniformly covered on glass substrates through a simple hydrothermal method with varying growth time which affects the surface morphology. When a substrate is dipped into 10 mM stearic acid in ethanol for 24 h, chemisorption of the stearic acid takes place on the ZnO nanorod surface, after which the hydrophilic ZnO nanorod surfaces are modified into hydrophobic ones. The contact angle of a water droplet on this superhydrophobic ZnO nanorod surface increased from 110 degrees to 150 degrees depending on the growth time (from 3 to 6 h) with a high transparency of above 60%. In addition, the water contact angle can be made to as low as 27 degrees after exposing the substrate to 10-mW/cm2 UV for 1 h.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1166/jnn.2011.4409 | DOI Listing |
Sci Rep
December 2024
Advanced Physics Laboratory, Department of Physics, Savitribai Phule Pune University, Pune, Maharashtra, 411007, India.
The present study demonstrates the synthesis of compact ZnO layers using CdS sensitized on ZnO as a photoanode with copper sulfide (CuS) and carbon as a counter electrode (CE). In this study, a compact ZnO layer was fabricated using the simple and low-cost successive ionic layer adsorption and reaction (SILAR) method, and CuS CE films were synthesized using the chemical bath deposition method. Various characterizations, such as X-ray diffraction (XRD) and X-ray photoelectron spectroscopy (XPS), confirmed the formation of ZnO and CdS sensitizations on the ZnO .
View Article and Find Full Text PDFSci Rep
December 2024
Department of Physics, Faculty of Science, Islamic University of Madinah, Madinah 42351, Saudi Arabia.
Modifying ZnO nanorods with graphene oxide (GO) is crucial for enhancing photocatalytic degradation by boosting the concentration of reactive oxygen species (ROS) in the reaction medium. In this study, we present a straightforward chemical synthesis of ZnO nanorods embedded on GO, forming a novel nanocomposite, GOZ. This composite serves as an efficient photocatalyst for the sunlight-driven degradation of methylene blue (MB) and ciprofloxacin (CIP).
View Article and Find Full Text PDFBiosensors (Basel)
December 2024
Department of Semiconductor Systems Engineering, Convergence Engineering for Intelligent Drone, Institute of Semiconductor and System IC, Sejong University, 209, Neungdong-ro, Gwangjin-gu, Seoul 05006, Republic of Korea.
NO is a toxic gas that can damage the lungs with prolonged exposure and contribute to health conditions, such as asthma in children. Detecting NO is therefore crucial for maintaining a healthy environment. Carbon nanotubes (CNTs) are promising materials for NO gas sensors due to their excellent electronic properties and high adsorption energy for NO molecules.
View Article and Find Full Text PDFACS Nanosci Au
December 2024
Department of Physics, Malaviya National Institute of Technology Jaipur, Jaipur 302017, Rajasthan, India.
The development of supercapacitors is pivotal for sustainable energy storage solutions, necessitating the advancement of innovative electrode materials to supplant fossil-fuel-based energy sources. Zinc oxide (ZnO) is widely studied for use in supercapacitor electrodes because of its beneficial physicochemical properties, including excellent chemical and thermal stability, semiconducting characteristics, low cost, and environmentally friendly nature. In this study, ZnO nanorods were synthesized using a simple hydrothermal method and then combined with various Ni-based layered double hydroxides (LDHs) [NiM'-LDHs (M' = Mn, Co, and Fe)] to improve the electrochemical performance of the ZnO nanorods.
View Article and Find Full Text PDFACS Appl Mater Interfaces
December 2024
Faculty of Advanced Science and Technology, Kumamoto University, Kumamoto 860-8555, Japan.
ZnO nanorods have attracted much attention owing to their outstanding properties for chemical gas sensors. Although they show greater sensing properties than conventional nanoparticulate ZnO, high operation temperature (>250-350 °C) is required for them to work even if precious metals are deposited on them to sensitize their sensing properties. Light irradiation is one solution for overcoming the high operation temperature and the gas selectivity because it assists the oxidation activity on the surface that affects the sensor response.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!