Comparative in vitro evaluation of apheresis platelets stored with 100% plasma or 65% platelet additive solution III/35% plasma and including periods without agitation under simulated shipping conditions.

Background: A comparative study evaluated the retention of apheresis platelet (A-PLT) in vitro properties prepared with PLT additive solution (PAS)-III or 100% plasma and stored with continuous agitation (CA) and without continuous agitation (WCA).

Study Design And Methods: PLTs collected with the Amicus cell separator (Fenwal, Inc.) were utilized to prepare two matched components, each with approximately 4 × 10(11) PLTs. In the primary study, one component contained 65% PAS-III/35% plasma and the other 100% plasma. Four storage scenarios were used, one with CA and three with periods without agitation under simulated shipping conditions. In vitro assays were used early and after 5 days of storage.

Results: pH levels after 5 days with CA were less with PAS-III components than 100% plasma components, with levels always above 6.6 in any component. With CA, a number of other variables were reduced even early during storage with PAS-III including morphology, extent of shape change, hypotonic stress response, adhesion, and aggregation. Storage WCA resulted in only a limited increase in the magnitude of the assay differences between PAS-III and 100% plasma components. Periods WCA did not reduce the pH below 6.6. The thromboelastograph variable associated with the strengthening of clots by PLTs was essentially comparable with PAS-III and plasma components throughout storage with CA or WCA.

Conclusion: The data indicate that a 100% plasma medium provides for better retention of specific in vitro PLT properties, with CA and WCA, although the clinical significance of these in vitro decrements due to PAS-III is unknown.