Warren et al. (1995) reported over 90% intelligibility for everyday sentences reduced to a 1/3-octave band (center frequency 1,500 Hz, slopes 100 dB/octave, slow-rms peak levels 75 dB). To investigate the basis of this high intelligibility, Warren and Bashford (1999) partitioned the sentences. Surprisingly, the rectangular 1/3-octave passband had only 24% intelligibility, whereas the filter skirts separated by a 1/3-octave notch had an intelligibility of 83%, despite their severe spectral tilts. Experiment 1 of the present study substituted monosyllabic words for sentences. Wholeband intelligibility was 26%, the passband 4%, and the filter skirts 16%. Experiment 2 measured intelligibility for 1/3-octave sentences having peak levels ranging from 85 down to 35 dB. Whole band intelligibility ranged from 90% to 68%, and the filter skirt pairs had from two to four times the passband's intelligibility (which did not vary significantly with level). Hence, steep (100 dB/octave) filter skirts make the dominant contribution to intelligibility of nominally 1/3-octave speech across a wide range of presentation levels.
Download full-text PDF |
Source |
---|---|
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC3163505 | PMC |
http://dx.doi.org/10.1121/1.1329836 | DOI Listing |
Sci Rep
August 2023
Department of Electric, Electronic and Communication Engineering and the Institute of Smart Cities, Public University of Navarre, 31006, Pamplona, Spain.
Presented here is a reactively loaded microstrip transmission line that exhibit an ultra-wide bandgap. The reactive loading is periodically distributed along the transmission line, which is electromagnetically coupled. The reactive load consists of a circular shaped patch which is converted to a metamaterial structure by embedded on it two concentric slit-rings.
View Article and Find Full Text PDFRev Sci Instrum
March 2017
School of Electronics Engineering, Kyungpook National University, 80, Daehak-ro, Buk-gu, 41566 Daegu, South Korea.
A new high-performing PCB (Printed Circuit Board) dichroic filter, which can be used for the KSTAR (Korea Superconducting Tokamak Advanced Research) electron cyclotron emission imaging system, is proposed. The current dichroic filter consists of a triangular lattice array of circular holes on the 6-mm thick metal plate, while circular hole spacing limitation caused relatively narrow passband (∼20 GHz). On the other hand, the proposed PCB dichroic filter utilizes the inexpensive commercial PCB fabrication process with a flexible adjustment of circular hole spacing.
View Article and Find Full Text PDFwe propose and demonstrate a bandpass microwave photonic filter (MPF) with ultrahigh stopband attenuation and skirt selectivity based on a simple signal cancellation technique. By injecting two phase modulated signals located on opposite sides of two resonant gain peaks of a Fabry-Pérot semiconductor optical amplifier (FP-SOA), two microwave frequency responses can be generated by the two input signals, respectively. The two frequency responses will add together within the passband but cancel each other out within the stopband, thus generating a MPF with simultaneous ultrahigh stopband attenuation and skirt selectivity.
View Article and Find Full Text PDFNature
June 2016
Department of Biochemistry and Molecular Biophysics, Columbia University, 650 West 168th Street, New York, New York 10032, USA.
Precise regulation of calcium homeostasis is essential for many physiological functions. The Ca(2+)-selective transient receptor potential (TRP) channels TRPV5 and TRPV6 play vital roles in calcium homeostasis as Ca(2+) uptake channels in epithelial tissues. Detailed structural bases for their assembly and Ca(2+) permeation remain obscure.
View Article and Find Full Text PDFScientificWorldJournal
July 2015
RFIC Center, Department of Electronic Engineering, Kwangwoon University, 447-1 Wolgye-dong, Nowon-ku, Seoul 139-701, Republic of Korea.
This paper reports a compact bandpass filter with improved skirt selectivity using integrated passive device fabrication technology on a GaAs substrate. The structure of the filter consists of electromagnetically coupled meandered-line symmetric stepped-impedance resonators. The strength of the coupling between the resonators is enhanced by using a meandered-line stub-load inside the resonators to improve the selectivity and miniaturize the size of the filter.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!