Introduction: This study investigated the torsional properties of new and used Revo-S Shaping Universal (SU) endodontic instruments.
Methods: Torsional profiles were established following the American National Standards Institute/American Dental Association Specification No. 28. Unused SU instruments (group 1, control; n = 30) and instruments used in simulated root canals twice (group 2, n = 30) or six times (group 3, n = 30) were tested. Analysis of variance with the Bonferroni/Dunn post hoc test (α = 0.05) was used to analyze the torque and angle of rotation at fracture.
Results: The maximum torque at fracture did not differ significantly among instruments in group 1 and groups 2 and 3. The angle of rotation at fracture decreased significantly (P < .01) from group 1 to groups 2 and 3.
Conclusions: The repeated use of the SU rotary instruments significantly reduced the angle of rotation at fracture but did not reduce the torque at fracture.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1016/j.joen.2011.03.029 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Medialization of shaft of humerus to provide medial buttress and prevent varus collapse in 3- and 4-part proximal humerus fractures: review of the surgical technique.
JSES Rev Rep Tech
February 2025
Department of Orthopaedics, Krishna Institute of Medical Sciences, Secunderabad, Telanagana, India.
Hypothesis: Proximal humerus fractures present a treatment challenge due to varied fracture configurations and a lack of consensus on optimal management. Locking plate designs offer promising solutions, yet technical guidelines for successful outcomes remain elusive. Complications are common, with fixation-related failures often attributed to varus collapse.
View Article and Find Full Text PDFFully guided system for position-predictable autotransplantation of teeth: A randomized clinical trial.
Int Endod J
January 2025
Department of Oral and Maxillofacial Surgery, Guangdong Engineering Research Center of Oral Restoration and Reconstruction Guangzhou Key Laboratory of Basic and Applied Research of Oral Regenerative Medicine, Affiliated Stomatology Hospital of Guangzhou Medical University, Guangzhou, China.
Aim: Autotransplantation of teeth (ATT) is a viable biological method for addressing dental defects. The objective was to achieve occlusal reconstruction-orientated ATT to enhance functionality and obtain optimal location and adjacency. This study proposes a new concept of a guide (a fully guided system) to achieve position-predictable ATT.
View Article and Find Full Text PDFAnalysing head and trunk motion in the judo osoto-gari technique: relationship to sweeping-leg velocity.
PeerJ
January 2025
Graduate School of Humanities and Social Sciences, Hiroshima University, Higashi-Hiroshima, Japan.
Background: Osoto-gari is a leg throw technique that primarily relies on the hip extension to initiate the sweeping motion of the leg. A high sweep contact velocity is a crucial factor in efficiently executing this technique. While some literature emphasises whole-body coordination in the leg-sweeping action, the roles of trunk and head motion remain unclear.
View Article and Find Full Text PDFQuantifying structural changes in organised biomineralized surfaces using synchrotron Polarisation-induced Contrast X-ray Fluorescence.
Acta Biomater
January 2025
Faculty of Dentistry, Oral & Craniofacial Sciences, King's College London, United Kingdom.
The quantitative characterization of the structure of biomineral surfaces is needed for guiding regenerative strategies. Current techniques are compromised by a requirement for extensive sample preparation, limited length-scales, or the inability to repeatedly measure the same surface over time and monitor structural changes. We aim to address these deficiencies by developing Calcium (Ca) K-edge Polarisation Induced Contrast X-ray Fluorescence (PIC-XRF) to quantify hydroxyapatite (HAp) crystallite structural arrangements in high and low textured surfaces.
View Article and Find Full Text PDFDiscrepancies in long-leg alignment and knee joint line obliquity between two- and three-dimensional measurements under weight-bearing conditions: Effects on coronal plane alignment of the knee classification.
Knee
January 2025
Department of Radiology, Keio University School of Medicine, Shinjuku, Tokyo, Japan.
Background: Long-leg alignment and joint line obliquity have traditionally been assessed using two-dimensional (2D) radiography, but the accuracy of this measurement has remained unclear. This study aimed to evaluate the accuracy of 2D measurements of lateral distal femoral angle (LDFA) and medial proximal tibial angle (MPTA) using upright three-dimensional (3D) computed tomography (CT).
Methods: This study involved 66 knees from 38 patients (34 women, four men) with knee osteoarthritis (OA), categorized by Kellgren-Lawrence (KL) grade.
Want AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!