Background And Purpose: Use of planning 4-dimensional CT (4DCT) scans often permits use of smaller target volumes for thoracic tumors but this assumes a reproducible pattern of motion during radiotherapy. We compared cranio-caudal (CC) motion on MV cine-images acquired during treatment with that seen on planning 4DCT.
Methods And Materials: A pre-programmable respiratory motion phantom and a software tool for motion assessment were used to validate the use of MV cine-images for motion detection. MV cine-images acquired in 20 patients with node-positive lung cancer were analyzed using the same software. Intra-fraction CC motion on 6 MV cine-images from each patient was compared with CC motion on their planning 4DCT.
Results: Software-based motion measurement on MV cine-images from the phantom corresponded to actual motion. Mean CC motion of primary tumor, carina and hilus on 4DCT was 7.3mm (range 2-13.8mm), 6.8mm (1.8-21.2) and 11.0mm (4.2-15.1), respectively. Corresponding intra-fraction motion on MV cine was 4.1mm (0.6-13.6mm); 2.7mm (0-10mm) and 6.0mm (1.8-14.4mm), respectively. The tumor, hilus and carina could be tracked in 95%, 88% and 38% of the MV cine-images, respectively.
Conclusions: Intra-fraction motion can be reliably measured using MV-cine images from a phantom. Motion discrepancies identified on MV cine-images can identify patients in whom planning 4DCT scans are not representative.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1016/j.radonc.2011.05.037 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Three-Plane Calcaneal Osteotomy With Joint Preservation vs Subtalar Arthrodesis to Treat Painful Calcaneal Fracture Malunions.
Foot Ankle Int
January 2025
Foot and Ankle Surgery Department, Honghui Hospital of Xi'an Jiaotong University, Xi'an, China.
Background: Calcaneal fracture malunion (CFM) commonly occurs with multiple pathologic changes and progressive pain and difficulty walking. The purpose of this study was to propose a modified 3-plane joint-preserving osteotomy for the treatment of CFM with subtalar joint incongruence, and to compare its efficacy to subtalar arthrodesis.
Methods: A retrospective comparative analysis of the data of 56 patients with CFM admitted from January 2017 to December 2022 was performed.
Background: Total ankle replacement (TAR) has evolved in the last decade from a procedure rife with complication and failure to a promising alternative to arthrodesis. The ability to maintain ankle joint range of motion is showing great promise in patient-reported outcomes, postsurgical pain, as well as long-term sequalae of joint fusion. Although TAR can be performed via either an anterior or lateral approach both with their own sets of benefits and potential complications, the consensus seems to be that one is no better than the other when performed by high-volume surgeons.
View Article and Find Full Text PDFPreserving Cervical Mobility: A Novel Robot-Assisted Approach for Atlas Fracture Fixation.
Am J Case Rep
January 2025
Department of Orthopedic Surgery, Sichuan Provincial People's Hospital, School of Medicine, University of Electronic Science and Technology of China, Chengdu, Sichuan, China.
BACKGROUND The management of unstable atlas fractures remains a subject of ongoing debate and controversy. The conservative surgical treatment commonly involves fusion, resulting in severe loss of cervical spine mobility, and a large incisions and extensive tissue dissection are required. We aim to introduce a novel concept and surgical approach for treating atlas fracture, one that involves minimizing trauma while maintaining mobility of the upper cervical spine without resorting to fusion.
View Article and Find Full Text PDFInteractive Coupling Relaxation of Dipoles and Wagner Charges in the Amorphous State of Polymers Induced by Thermal and Electrical Stimulations: A Dual-Phase Open Dissipative System Perspective.
Polymers (Basel)
January 2025
Rheology Department, Polymat Institute, University of the Basque Country, 20018 Donostia-San Sebastian, Euskadi, Spain.
This paper addresses the author's current understanding of the physics of interactions in polymers under a voltage field excitation. The effect of a voltage field coupled with temperature to induce space charges and dipolar activity in dielectric materials can be measured by very sensitive electrometers. The resulting characterization methods, thermally stimulated depolarization (TSD) and thermal-windowing deconvolution (TWD), provide a powerful way to study local and cooperative relaxations in the amorphous state of matter that are, arguably, essential to understanding the glass transition, molecular motions in the rubbery and molten states and even the processes leading to crystallization.
View Article and Find Full Text PDFDevelopment of Thermoplastic Bi-Component Electrodes for Triboelectric Impact Detection in Smart Textile Applications.
Polymers (Basel)
January 2025
Department of Mechanical Engineering, Faculty of Engineering, University of Porto, 4200-465 Porto, Portugal.
Smart textiles provide a significant technological advancement, but their development must balance traditional textile properties with electronic features. To address this challenge, this study introduces a flexible, electrically conductive composite material that can be fabricated using a continuous bi-component extrusion process, making it ideal for sensor electrodes. The primary aim was to create a composite for the filament's core, combining multi-walled carbon nanotubes (MWCNTs), polypropylene (PP), and thermoplastic elastomer (TPE), optimised for conductivity and flexibility.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!