In this paper, zinc oxide (ZnO) nanobelts with five different indium (In) concentrations (1.98, 2.73, 3.33, 4.20, and 5.16 wt%) were prepared by simple vapor deposition with HAuCl(4) (1% solution) as catalyst. Detailed structural and compositional characterizations were performed by XRD, TEM, EDS, PL, and Raman spectroscopy. Moreover, the current-voltage (I-V) characteristics of In-doped ZnO nanobelts with different In concentrations were determined by nano-manipulation and measurement systems. The results show that the resistivity of these nanobelts decreases with increasing In concentration when the doping concentration of In is lower than 4.20%, but, on the contrary, when the In concentration is higher than 4.20% their resistivity increases. Also, all of the nanobelts keep ohmic contact very well. Simultaneously, the influence of electron beam irradiation (20 kV) on the nanobelts was studied, and it was found that electron beam irradiation can improve the conductivity of the nanobelts. Under the same voltage, the current increased gradually during irradiation until equilibrium was reached. The degree of influence of the irradiation on the resistivity of the nanobelts is the greatest when the In dopant concentration is 4.20%, which is suitable for making irradiation sensors.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1039/c1nr10018a | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Temperature-modulated sensing characteristics of ultrafine Au nanoparticle-loaded porous ZnO nanobelts for identification and determination of BTEX.
J Hazard Mater
February 2024
Information Materials and Intelligent Sensing Laboratory of Anhui Province, Institutes of Physical Science and Information Technology, Anhui University, Hefei 230601, PR China; Key Laboratory of Environmental Optics and Technology, And Environmental Materials and Pollution Control Laboratory, Institute of Solid State Physics, HFIPS, Chinese Academy of Sciences, Hefei, 230031, PR China.
The identification and determination of benzene, toluene, ethylbenzene, and xylene (BTEX) has always been a formidable challenge for chemiresistive metal oxide sensors owing to their structural similarity and low reactivity, as well as the intrinsic cross sensitivity of metal oxides. In this paper, a temperature-modulated sensing strategy is proposed for the identification and determination of BTEX using a high-performance chemiresistive sensor. Ultrafine Au nanoparticle-loaded porous ZnO nanobelts as sensing materials were synthesized through an exchange reaction followed by thermal oxidation, which exhibited high response toward BTEX.
View Article and Find Full Text PDFOn-Chip Ultralow-Threshold Tunable CdSSe Nanobelt Lasers Excited by the Emission of Linked ZnO Nanowire.
J Phys Chem Lett
April 2023
Beijing Key Lab of Nano-photonics and Ultrafine Optoelectronic Systems, School of Physics, Beijing Institute of Technology, Beijing 100081, P. R. China.
The integration of optical waveguide and on-chip nanolasers source has been one of the trends in photonic devices. For on-chip nanolasers, the integration of nanowires and high antidamage ability are imperative. Herein, we realized the on-chip ultralow-threshold and wavelength-tunable lasing from alloyed CdSSe nanobelt chip that is excited by the emission from linked ZnO nanowires.
View Article and Find Full Text PDFLaser-Induced Au Catalyst Generation for Tailored ZnO Nanostructure Growth.
Nanomaterials (Basel)
April 2023
Department of Chemistry, University of Marburg, Hans-Meerwein Str. 4, 35032 Marburg, Germany.
ZnO nanostructures, semiconductors with attractive optical properties, are typically grown by thermal chemical vapor deposition for optimal growth control. Their growth is well investigated, but commonly results in the entire substrate being covered with identical ZnO nanostructures. At best a limited, binary growth control is achieved with masks or lithographic processes.
View Article and Find Full Text PDFBuilt-in electric field boosted ionic transport kinetics in the heterostructured ZnCoO/ZnO nanobelts for high-performance supercapacitor.
J Colloid Interface Sci
January 2023
School of Chemistry and Chemical Engineering, Harbin Institute of Technology, Harbin 150001, PR China. Electronic address:
Metal oxides are promising electrode candidates for supercapacitor due to their high theoretical capacitance, good reversibility, and low cost. However, they show inferior specific capacitance and power density because of their sluggish ion diffusion kinetics and intrinsically poor electrical conductivity within the solid phase. Herein, heterostructured ZnCoO/ZnO nanobelts are successfully prepared by using self-assembled Zn/Co-based nanosized coordination polymers as the precursors.
View Article and Find Full Text PDFHighly sensitive strain sensors based on piezotronic tunneling junction.
Nat Commun
February 2022
Institute of Nanoscience and Nanotechnology, School of Materials and Energy, Lanzhou University, 730000, Lanzhou, Gansu, China.
Piezotronics with capacity of constructing adaptive and seamless interactions between electronics/machines and human/ambient are of value in Internet of Things, artificial intelligence and biomedical engineering. Here, we report a kind of highly sensitive strain sensor based on piezotronic tunneling junction (Ag/HfO/n-ZnO), which utilizes the strain-induced piezoelectric potential to control the tunneling barrier height and width in parallel, and hence to synergistically modulate the electrical transport process. The piezotronic tunneling strain sensor has a high on/off ratio of 478.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!