Introduction: The purpose of this study was to determine the relationship between the length of the lingual frenulum and craniofacial morphology and test the hypothesis that skeletal Class III malocclusion is related to tongue-tie, in which the lingual frenulum is short and restricts the mobility of the tongue.
Methods: The sample consisted of 50 skeletal Class I patients (0° < ANB angle < 4°), 50 skeletal Class II patients (ANB angle > 4°), and 50 skeletal Class III patients (ANB angle <0°). Direct and indirect measuring methods were used to quantify the length of the lingual frenulum. The median lingual frenulum length was measured directly with a lingual frenulum ruler. It was evaluated indirectly by measuring the differences between the maximum mouth opening with and without the tip of the tongue touching the incisive papilla. A lateral cephalogram was taken for each subject and a computerized cephalometric analysis was used to assess the cranial morphology. Analysis of variance (ANOVA) was used to compare the differences among the 3 groups. The Pearson correlation analysis was used to detect any relationship between the lingual frenulum length and cephalometric variables.
Results: The median lingual frenulum length was significantly longer in the skeletal Class III subjects compared with the skeletal Class I and Class II subjects. The maximum opening of the mouth was significantly reduced in the skeletal Class III subjects compared with Class I and Class II subjects. Significant correlations were also found among the median lingual frenulum length, maximum mouth opening reduction, and the cephalometric variables such as the SNB and ANB angles, Wits appraisal, mandibular length, and the interincisal angle.
Conclusions: The present study supports the hypothesis that skeletal Class III malocclusion is related to long median lingual frenulum or a tongue-tie tendency. Patients diagnosed with tongue-tie might have a tendency toward skeletal Class III malocclusion.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1016/j.ajodo.2009.07.017 | DOI Listing |
Cureus
December 2024
Department of Orthodontics, Kothiwal Dental College and Research Centre, Moradabad, IND.
Introduction The role of the condylar position in the correct functioning of the stomatognathic system has been the center of the study. Using cone-beam computed tomography (CBCT), this study looked at the three-dimensional (3D) position of the condylar bone in patients from Class I, Class II, Division 1, and Division 2. Materials and methods This cross-sectional, retrospective study was conducted using 102 CBCT records, with 34 records allocated to each category of malocclusion classification, such as dentoskeletal Class I, skeletal Class II, and dental Class II, Division 1 and 2.
View Article and Find Full Text PDFSci Rep
January 2025
Department of Orthodontics, Faculty of Dentistry, University of Damascus, Damascus, Syria.
Twin block appliances are commonly used to treat skeletal class II malocclusion. However, many adverse effects, such as lower incisor protrusion and a bulky nature, can be observed. To overcome these effects, a modified twin block was designed, which uses vacuum-formed hard plates (VFPs) instead of acrylic plates.
View Article and Find Full Text PDFCureus
December 2024
Department of Orthodontics, Kothiwal Dental College and Research Centre, Moradabad, IND.
Introduction: The temporomandibular joint (TMJ) is one of the most intricate anatomical entities within the human body and is clinically relevant in the field of dentistry. Therefore, the present study aimed to conduct a three-dimensional (3D) volumetric comparison of the TMJ space in skeletal Class I and II patients using cone-beam computed tomography (CBCT).
Materials And Methods: This cross-sectional, retrospective study was conducted on 40 CBCT records divided into skeletal Class I and skeletal Class II patients.
Case Rep Dent
January 2025
Department of Orthodontics, School of Dentistry, Sefako Makgatho Health Sciences University, Pretoria, South Africa.
Class III malocclusion remains the most challenging occlusal problem to treat due to the complexity of the interrelationships of the underlying skeletal and dental structures. Camouflage orthodontic treatment is a preferred alternative method used to manage mild to moderate Class III malocclusion in nongrowing patients. The aim of this article was to demonstrate a camouflage orthodontic treatment of a 22-year-old female patient diagnosed as having a severe skeletal Class III malocclusion characterized by a straight facial profile, reverse overjet, crowded maxillary incisors, retrognathic maxilla, prognathic mandible, and a hypodivergent facial pattern.
View Article and Find Full Text PDFJ Stomatol Oral Maxillofac Surg
January 2025
Department of Orthodontics, Hubei-MOST KLOS & KLOBM, School & Hospital of Stomatology, Wuhan University, Wuhan, China.. Electronic address:
Objectives: This study aims to assess the alterations in condylar positioning in adult skeletal Class I patients with unilateral posterior crossbite after microimplant-assisted rapid palatal expansion (MARPE) treatment.
Methods: This retrospective study involving 30 participants (10 males, 20 females) average age 22.9 ± 4.
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!