In the past few years, strong efforts have been devoted to improving the frequency of optical-fiber communications. In particular, the use of a special kind of integrated optoelectronic device called an electroabsorption modulated laser (EML) allows communication at 10 Gb s(-1) or higher over long propagation spans (up to 80 km). Such devices are realized using the selective area growth (SAG) technique and are based on a multiple quantum well (MQW) distributed-feedback laser (DFB) monolithically integrated with a MQW electroabsorption modulator (EAM). Since the variation in the chemical composition between these two structures takes place on the micrometer scale, in order to study the spatial variation of the relevant parameters of the MQW EML structures, the X-ray microbeam available at the ESRF ID22 beamline is used. The effectiveness of the SAG technique in modulating the chemical composition of the quaternary alloy is proven by a micrometer-resolved X-ray fluorescence (μ-XRF) map. Here, reported micrometer-resolved extended X-ray absorption fine structure (μ-EXAFS) spectra represent the state of the art of μ-EXAFS achievable at third-generation synchrotron radiation sources. The results are in qualitative agreement with X-ray diffraction (XRD) and micrometer-resolved photoluminescence (μ-PL) data, but a technical improvement is still crucial in order to make μ-EXAFS really quantitative on such complex heterostructures.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1002/smll.201001229 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
We demonstrate externally modulated widely tunable lasers co-integrated with semiconductor optical amplifiers (SOAs) heterogeneously integrated on silicon. The widely tunable laser enables continuous single-mode operation over a tuning range of approximately 40 nm, with a side-mode suppression ratio (SMSR) of at least 50 dB and an average waveguide-coupled optical power of 5 mW. The integrated electro-absorption modulator (EAM) exhibits an extinction ratio (ER) of 16 dB when reversed biased at -2 V.
View Article and Find Full Text PDFThe optical single sideband (SSB) transmitter based on dual modulation of an electro-absorption modulation laser (D-EML) has attracted considerable attention for its capability of monolithic integration and high output power. A model-based modulation method has been developed recently for generating high-quality optical SSB signals with this D-EML scheme. However, this method requires accurate characterization of the EML's chirps and pre-compensation for frequency responses of all-optical/electrical components, as well as the path difference between two driving signals.
View Article and Find Full Text PDFMeasuring the Electro-Optical Kerr Effect Against the Background of Electro-Absorption Modulation in Liquids.
Materials (Basel)
October 2024
Institute of Physics, Lodz University of Technology, Wólczańska 217/221, 93-005 Łódź, Poland.
A new approach to the dynamic polarimetric method is proposed, which allows for the decoupling of electro-optical Kerr effect measurements from the electro-absorption effect in partially transparent liquids. The method is illustrated by using the results of engine oil measurements as a function of temperature and modulating field frequency. It was shown that the birefringence induced in the sample, the modulation of the ordinary wave transmission, and the modulation of the extraordinary wave transmission in the sample can be shifted in phase with respect to the square of the applied alternating modulating field.
View Article and Find Full Text PDFIII-nitride multi-quantum well (MQW) diodes can modulate the light emitted by another diode with the same MQW structure by varying the bias voltage owing to the spectral overlap between the electroluminescence spectrum and spectral responsivity curve of the MQW diodes. Here, we investigate bias-controlled modulation by monolithically integrating an optical transmitter, waveguide, electro-absorption modulator (EAM), and slot grating coupler on a silicon-based III-nitride platform using compatible fabrication processes. The modulated light is coupled into a fiber, which is direct to a photodiode for characterization.
View Article and Find Full Text PDFA bandwidth-efficient coherent analog IFoF approach is proposed, employing a twin optical sideband (twin-OSSB) modulation of intermediate frequency-over-fiber (IFoF) signals in a dually modulated electroabsorption modulated laser (EML), demonstrating stable modulations without complex bias drifts and polarization control. The receiver (Rx) utilizes heterodyne detection with phase noise canceling (PNC) techniques for channel recovery. Successful demonstrations include an 8 Gbps aggregated twin-OSSB of two QPSK channels, with measurements covering optical back-to-back (btb) and 25 km of a standard single-mode fiber (SSMF), revealing sensitivities of -30 dBm and -25 dBm for QPSK-twin-OSSB and 16-QAM single user, respectively.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!