Analyses of stable isotope ratios of chlorine and oxygen in perchlorate can, in some cases, be used for mapping and source identification of groundwater perchlorate plumes. This is demonstrated here for large, intersecting perchlorate plumes in groundwater from a region having extensive groundwater perchlorate contamination and a large population dependent on groundwater resources. The region contains both synthetic perchlorate derived from rocket fuel manufacturing and testing activities and agricultural perchlorate derived predominantly from imported Chilean (Atacama) nitrate fertilizer, along with a likely component of indigenous natural background perchlorate from local wet and dry atmospheric deposition. Most samples within each plume reflect either a predominantly synthetic or a predominantly agricultural perchlorate source and there is apparently a minor contribution from the indigenous natural background perchlorate. The existence of isotopically distinct perchlorate plumes in this area is consistent with other lines of evidence, including groundwater levels and flow paths as well as the historical land use and areal distribution of potential perchlorate sources.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1111/j.1745-6584.2011.00802.x | DOI Listing |
Ground Water
July 2021
Nestlé Waters North America, Inc., 19275 8 Mile Road, Stanwood, MI, 49346, USA.
Perchlorate was detected in a municipal wellfield in Evart, Michigan in April 2015. Perchlorate concentrations were detected initially in six of the City's wells at concentrations ranging up to 20 μg/L. An investigation to identify the source determined that the perchlorate was from fireworks launched during the annual 4th of July show held at the fairgrounds located upgradient from the wellfield.
View Article and Find Full Text PDFJ Hazard Mater
March 2019
Aptim Federal Services, 17 Princess Road, Lawrenceville, NJ 08648, United States.
Hexahydro-1,3,5-trinitro-1,3,5-triazine (RDX), octahydro-1,3,5,7-tetranitro-1,3,5,7-tetrazocine (HMX), and perchlorate (ClO) are common, and often co-mingled, contaminants at military ranges worldwide. This project investigated the feasibility of using a passive emulsified oil biobarrier plus a slow release pH buffering reagent to remediate RDX, HMX, and ClO in a low pH aquifer at an active range. A 33 m biobarrier was emplaced perpendicular to the contaminant plumes, and dissolved explosives, perchlorate, and other relevant parameters were monitored.
View Article and Find Full Text PDFAtmos Environ (1994)
October 2017
U.S. Environmental Protection Agency, Office of Research and Development, National Risk Management Research Laboratory, Research Triangle Park, NC 27711, USA.
An emission sensor/sampler system was coupled to a National Aeronautics and Space Administration (NASA) hexacopter unmanned aerial vehicle (UAV) to characterize gases and particles in the plumes emitted from open burning of military ordnance. The UAV/sampler was tested at two field sites with test and sampling flights spanning over 16 hours of flight time. The battery-operated UAV was remotely maneuvered into the plumes at distances from the pilot of over 600 m and at altitudes of up to 122 m above ground level.
View Article and Find Full Text PDFSci Total Environ
February 2017
BRGM, Water, Environment and Ecotechnologies Division, F45060 Orléans, France.
The identification of the sources of contaminants present in groundwater at industrial sites is primordial to address environmental and industrial issues. However, available tools are often inadequate or expensive. Here, we present the data of stable isotopes (δO and δH) of the water molecule at an industrial site where electrochemistry plant occurs impacting the groundwater quality.
View Article and Find Full Text PDFWe apply ultrafast pure-rotational coherent anti-Stokes Raman scattering (CARS) for temperature and relative oxygen concentration measurements in the plume emanating from a burning, aluminized ammonium-perchlorate propellant strand. Combustion of these metal-based propellants is a particularly hostile environment for laser-based diagnostics, with intense background luminosity and scattering from hot metal particles as large as several hundred micrometers in diameter. CARS spectra that were previously obtained using nanosecond pulsed lasers in an aluminum-particle-seeded flame are examined and are determined to be severely impacted by nonresonant background, presumably as a result of the plasma formed by particulate-enhanced laser-induced breakdown.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!