We report an efficient synthesis of cyclotris[(E)-3'-(biphenyl-3-yldiazenyl)] compounds (CTBs). An unsubstituted CTB molecule is accessible in four steps in 10% yield overall, whereas a hexa(methoxymethyl ether) CTB analogue was prepared in nine steps (26% yield). The final macrocyclization step was accomplished in up to 80% yield by using a metal-template effect. Furthermore, the photochromic properties were investigated, and all four isomers were detected and characterized by NMR spectroscopy. A strong influence from the solvent and the irradiation wavelength on the switching process was observed. Irradiation in pyridine yielded the highest amount of the all-Z isomer in the photostationary state. For a full conversion to the all-E isomer, the reaction has to be heated to 45 °C. The isomerization to the all-E isomer is slow at room temperature, with a half-life time of the all-Z isomer of more than nine days in dimethyl sulfoxide (DMSO). Conditions were established to access each possible isomer as the major component in the photostationary state.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1002/chem.201002671 | DOI Listing |
J Am Chem Soc
January 2025
School of Natural Sciences, Department Chemie, and Catalysis Research Center (CRC), Technische Universität München, Lichtenbergstrasse 4, 85747 Garching, Germany.
By coupling a photochemical and a thermal step, a single chiral catalyst can establish a photostationary state in which the enantiopure form of a chiral compound is favored over its racemate. Following this strategy, 3-substituted 4,7-diaza-1-isoindolones were successfully deracemized (74-98% yield, 86-99% ) employing 2.5 mol % of a photocatalyst.
View Article and Find Full Text PDFChem Sci
November 2024
LCM, CNRS, Ecole Polytechnique, Institut Polytechnique de Paris Route de Saclay 91120 Palaiseau France
The cyclononatetraenyl (Cnt) ligand is a large monoanionic ligand. It is easily synthesized by ring expansion after cyclopropanation of the cyclooctatetraenyl (Cot) ligand. The Cnt ligand can be reported as the --- () isomer, where the aromatic ring is flat, and all carbon atoms form a homogenous ring, and as the --- () isomer, where one carbon places itself inside the ring.
View Article and Find Full Text PDFJ Am Chem Soc
November 2024
Department of Chemistry, Molecular Sciences Research Hub, Imperial College London, 82 Wood Lane, London W12 0BZ, U.K.
The incorporation of photoresponsive groups into porous materials is attractive as it offers potential advantages in controlling the pore size and selectivity to guest molecules. A combination of computational modeling and experiment resulted in the synthesis of two azobenzene-derived organic cages based on building blocks identified in a computational screen. Both cages incorporate three azobenzene moieties, and are therefore capable of 3-fold isomerization, using either ditopic or tetratopic aldehydes containing diazene functionality.
View Article and Find Full Text PDFChemistry
December 2024
Centre for Systems Chemistry, Stratingh Institute, University of Groningen, Nijenborgh 3, Groningen, 9747 AG, The Netherlands.
Due to thermal E/Z isomerization, hydrazones in solution typically exist in thermodynamic equilibria between their isomers. Irradiation of such solutions leads to photostationary states that may differ from the equilibrium distribution. Operating such switchable hydrazones in a biphasic system of two immiscible solvents introduces three new degrees of freedom: the E/Z equilibrium in the second solvent and two equilibria for distribution of each of the isomers between the solvents.
View Article and Find Full Text PDFJ Org Chem
October 2024
Department of Chemistry, University of Florida, PO Box 117200, Gainesville, Florida 32611, United States.
A series of oligothiophenes singly and doubly functionalized with dicyanorhodanine (RCN) units have been investigated to understand their / photoisomerization behavior upon structural modulation. Monotopic RCN target molecules (-) were designed to observe the consequences of π-conjugation, solubilizing group substitution, and formylation of the thiophene units. In all cases, the isomer is obtained from synthesis as the thermodynamically stable isomer, whereas the isomer is achieved through selective irradiation (including red light, λ = 628 nm) as a / mixture in solution.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!