Background: Similar to lipid emulsion propofol, microemulsion propofol also causes a high incidence of pain during intravenous injection. Various methods have been used to minimize the incidence and severity of pain on injection of lipid emulsion propofol. In this study, we investigated the effect of a lidocaine mixture on pain induced by microemulsion propofol injection, and sought to determine the optimal dose of lidocaine that could reduce pain on injecting a propofol-lidocaine mixture.

Methods: One hundred sixty (n = 160) patients of American Society of Anesthesiologists physical status class I or II were randomly allocated to four groups: Group A, control; Group B, 20 mg lidocaine; Group C, 30 mg lidocaine; Group D, 40 mg lidocaine. In each patient, pain on microemulsion propofol solution injection was graded as none, mild, moderate, or severe.

Results: The incidence of pain in groups A, B, C, and D was 97.5%, 80%, 65%, and 50%, respectively. Increasing the lidocaine dose significantly reduced pain (P < 0.05). One patient in Group D (2.5%) had moderate to severe pain, which was significantly lower than groups B (42.5%) and C (32.5%) (P < 0.05).

Conclusions: The lidocaine and propofol mixture is effective in alleviating pain associated with microemulsion propofol injection. Within this dose range and in this patients population, increasing lidocaine dosage significantly reduced pain during injection of microemulsion propofol.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC2998649PMC
http://dx.doi.org/10.4097/kjae.2010.59.5.310DOI Listing

Publication Analysis

Top Keywords

microemulsion propofol
24
pain injection
12
group lidocaine
12
lidocaine
10
pain
10
propofol
9
injection microemulsion
8
lidocaine mixture
8
optimal dose
8
dose lidocaine
8

Similar Publications

A Simple and Noninvasive DOSY NMR Method for Droplet Size Measurement of Intact Oil-In-Water Emulsion Drug Products.

J Pharm Sci

February 2019

Division of Pharmaceutical Analysis, Office of Pharmaceutical Quality, Center for Drug Evaluation and Research, U.S. Food and Drug Administration, Silver Spring, Maryland 20993. Electronic address:

In a typical oil-in-water emulsion drug product, oil droplets with varied sizes are dispersed in a water phase and stabilized by surfactant molecules. The size and polydispersity of oil droplets are critical quality attributes of the emulsion drug product that can potentially affect drug bioavailability. More critically, to ensure accuracy in characterization of the finished drug product, analytical methods should introduce minimal physical perturbation (e.

View Article and Find Full Text PDF

Propofol solubilization and structural transformations in dilutable microemulsion.

Colloids Surf B Biointerfaces

December 2015

The Ratner Chair of Chemistry, Casali Institute of Applied Chemistry, The Institute of Chemistry, The Hebrew University of Jerusalem, Edmond J. Safra Campus, Givat Ram, Jerusalem 9190401, Israel. Electronic address:

Propofol (2,6-diisopropylphenol) is a drug for both induction and maintenance of anesthesia. Pure propofol cannot be injected because of its lipophilic character, low water-solubility, and low bioavailability. Presently, propofol is formulated in an unstable emulsion, easily oxidized, and easily contaminated with bacteria.

View Article and Find Full Text PDF

"Micro to macro (M2M)"--A novel approach for intravenous delivery of propofol.

Int J Pharm

October 2015

Department of Chemical Engineering, University of Florida, Gainesville, FL 32611, USA. Electronic address:

Purpose: Propofol emulsions have limited shelf life and safety concerns for injection. Microemulsions of propofol are thermodynamically stable and simpler to manufacture, but cause additional pain on injection. We propose a novel micro to macro (M2M) approach of destabilizing a microemulsion immediately prior to injection.

View Article and Find Full Text PDF

Objective: Pretreatment with intravenous 40 mg or 0.5 mg/kg lidocaine with venous occlusion is recommended to prevent pain following injection of lipid emulsion propofol. This approach is not sufficient to prevent pain from the injection of microemulsion propofol.

View Article and Find Full Text PDF

Purpose: To compare the incidence of endothelial injury after single-dose or continuous propofol infusion in conventional lipid-based emulsion (LE) versus microemulsion (ME).

Methods: Forty-two rabbits (2.5-4.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!