Mercury has various uses in nuclear fuel reprocessing and other nuclear processes, and so it is often present in radioactive and mixed (radioactive and hazardous) wastes. Compliance with air emission regulations such as the Hazardous Waste Combustor (HWC) Maximum Achievable Control Technology (MACT) standards can require off-gas mercury removal efficiencies up to 99.999% for thermally treating some mixed waste streams. Test programs have demonstrated this level of off-gas mercury control using fixed beds of granular sulfur-impregnated activated carbon. Other results of these tests include (1) the depth of the mercury control mass transfer zone was less than 15-30 cm for the operating conditions of these tests; (2) MERSORB carbon can sorb mercury up to 19 wt % of the carbon mass; and (3) the spent carbon retained almost all (98.3-99.99%) of the mercury during Toxicity Characteristic Leachability Procedure (TCLP) tests, but when even a small fraction of the total mercury dissolves, the spent carbon can fail the TCLP test when the spent carbon contains high mercury concentrations.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.3155/1047-3289.60.11.1341 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
A comprehensive review of heavy metals (Pb, Cd, Ni) removal from wastewater using low-cost adsorbents and possible revalorisation of spent adsorbents in blood fingerprint application.
Environ Technol
January 2025
Department of Chemical Sciences, University of Johannesburg, Johannesburg, South Africa.
An increasing amount of water pollution is being caused by an increase in industrial activity. Recently, a wide range of methods, including extraction, chemical coagulation, membrane separation, chemical precipitation, adsorption, and ion exchange, have been used to remove heavy metals from aqueous solutions. The adsorption technique is believed to be the most highly effective method for eliminating heavy metals from wastewater among all of them.
View Article and Find Full Text PDFExploring molecule-surface interactions of urania IR spectroscopy and density functional theory.
Phys Chem Chem Phys
January 2025
Institute of Functional Interfaces (IFG), Karlsruhe Institute of Technology (KIT), Eggenstein-Leopoldshafen, Germany.
Within the framework of surface-adsorbate interactions relevant to chemical reactions of spent nuclear fuel, the study of actinide oxide systems remains one of the most challenging tasks at both the experimental and computational levels. Consequently, our understanding of the effect of their unique electronic configurations on surface reactions lags behind that of d-block oxides. To investigate the surface properties of this system, we present the first infrared spectroscopy analysis of carbon monoxide (CO) interaction with a monocrystalline actinide oxide, UO(111).
View Article and Find Full Text PDFComparison of carbon dioxide control during pressure controlled versus pressure-regulated volume controlled ventilation in children (CoCO2): protocol for a pilot digital randomised controlled trial in a quaternary paediatric intensive care unit.
BMJ Open
January 2025
Department of Intensive Care and Neonatology and Children's Research Center, University of Zurich, University Children's Hospital Zürich, Zurich, Zurich, Switzerland.
Introduction: Digital trials are a promising strategy to increase the evidence base for common interventions and may convey considerable efficiency benefits in trial conduct. Although paediatric intensive care units (PICUs) are rich in routine electronic data, highly pragmatic digital trials in this field remain scarce. There are unmet evidence needs for optimal mechanical ventilation modes in paediatric intensive care.
View Article and Find Full Text PDFComplicated pollution characteristics (particulate matter, heavy metals, microplastics, VOCs) of spent lithium-ion battery recycling at an industrial level.
Sci Total Environ
January 2025
School of Environmental Science and Engineering, Shanghai Jiao Tong University, 200240, China.
The recycling of spent lithium-ion batteries has become a common concern of the whole society, with a large number of studies on recycling management and recycling technology, but there is relatively little study on the pollution release during the recycling process. Pollution will restrict the healthy development of the recycling industry, which makes relevant research very significant. This paper monitored and analyzed the battery recycling pretreatment process in a formal factory, and studied the pollution characteristics of particulate matter, heavy metals, and microplastics under different treatment stages.
View Article and Find Full Text PDFRecovery of Nd and Dy from E-Waste Using Adsorbents from Spent Tyre Rubbers: Batch and Column Dynamic Assays.
Molecules
December 2024
LAQV/REQUIMTE, Associated Laboratory for Green Chemistry, Department of Chemistry, NOVA School of Science and Technology, NOVA University Lisbon, 2829-516 Caparica, Portugal.
This paper investigates the use of spent tyre rubber as a precursor for synthesising adsorbents to recover rare earth elements. Through pyrolysis and CO activation, tyre rubber is converted into porous carbonaceous materials with surface properties suited for rare earth element adsorption. The study also examines the efficiency of leaching rare earth elements from NdFeB magnets using optimised acid leaching methods, providing insights into recovery processes.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!