Pre-stenting with a bare metal stent before percutaneous pulmonary valve implantation: acute and 1-year outcomes.

Objectives: To determine the feasibility and safety of pre-stenting with a bare metal stent (BMS) before percutaneous pulmonary valve implantation (PPVI), and to analyse whether this approach improves haemodynamic outcomes and impacts on the incidence of PPVI stent fractures.

Design: Retrospective analysis of prospectively collected data.

Setting: Tertiary paediatric and adult congenital heart cardiac centre.

Patients And Interventions: 108 consecutive patients with congenital heart disease underwent PPVI between September 2005 and June 2008 (54 with PPVI alone, 54 with BMS pre-stenting before PPVI).

Results: There were no significant differences in procedural complication rates. Acutely, there was no difference in haemodynamic outcomes. Serial echocardiography revealed that in the subgroups of 'moderate' (26-40 mm Hg) and 'severe' (>40 mm Hg) right ventricular outflow tract (RVOT) obstruction, patients with pre-stenting showed a tendency towards lower peak RVOT velocities compared to patients after PPVI alone (p=0.01 and p=0.045, respectively). The incidence of PPVI stent fractures was not statistically different between treatment groups at 1 year (PPVI 31% vs BMS+PPVI 18%; p=0.16). However, pre-stenting with BMS was associated with a lower risk of developing PPVI stent fractures (HR 0.35, 95% CI 0.14 to 0.87, p=0.024). The probability of freedom from serious adverse follow-up events (death, device explantation, repeat PPVI) was not statistically different at 1 year (PPVI 92% vs BMS+PPVI 94%; p=0.44).

Conclusions: Pre-stenting with BMS before PPVI is a feasible and safe modification of the established implantation protocol. Pre-stenting is associated with a reduced risk of developing PPVI stent fractures.