The aim of this study was to examine whether ground reaction force (GRF) side differences were transmitted and related to bar end power output asymmetries during hang power clean (HPC) performance and whether progressive loading would intensify this effect. Differences between the dominant (D) and nondominant (ND) side average GRFs (AGRFs) of both feet and average bar end power outputs were recorded simultaneously from 15 recreationally trained male volunteers at 30, 60, and 90% 1RM using 2 force platforms and 3 high-speed digital cameras, quantifying side dominance from perceived handedness (left- or right-side dominance [LRSD]), GRF side dominance (force side dominance [FSD]), and bar end power output side dominance (barbell side dominance [BSD]). With the exception of the LRSD condition, differences between the D and ND side AGRFs were significant (FSD: 1.8-4.3%; BSD: 5.1-6.4%, p < 0.05). Bar end power output side differences were significant for all conditions (LRSD: 1.5-5.4%; FSD: 0.5-3.4%; BSD: 3.9-5.6%, p < 0.05). Progressive loading did not significantly affect GRF side differences or the FSD average bar power side differences. However, during the LRSD and BSD conditions, the 60 and 90% side average bar power side differences were >the 30% equivalents. Average GRF side differences were not related to bar end power output side differences. Because of the consistent side difference of 4-6% investigators and strength and conditioning practitioners should exercise caution when interpreting changes in bar end power output.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1519/JSC.0b013e3181da77ca | DOI Listing |
Materials (Basel)
January 2025
Institute of Electric Power Engineering, Czestochowa University of Technology, Armii Krajowej 17, 42-200 Czestochowa, Poland.
During the heat treatment of round steel bars, a heated charge in the form of a cylindrically formed bundle is placed in a furnace. This type of charge is a porous granular medium in which a complex heat flow occurs during heating. The following heat transfer mechanisms occur simultaneously in this medium: conduction in bars, conduction within the gas, thermal radiation between the surfaces of the bars, and contact conduction across the joints between the adjacent bars.
View Article and Find Full Text PDFMater Horiz
January 2025
Sibley School of Mechanical and Aerospace Engineering, Cornell University, Ithaca, New York 14853, USA.
As the demand for high-power-density microelectronics rises, overheating becomes the bottleneck that limits device performance. In particular, the heterogeneous integration architecture can magnify the importance of heat dissipation and necessitate electrical insulation between critical junctions to prevent dielectric breakdown. Consequently, there is an urgent need for thermal interface materials (TIMs) with high thermal conductivity and electrical insulation to address this challenge.
View Article and Find Full Text PDFMembranes (Basel)
January 2025
Key Laboratory of Ocean Energy Utilization and Energy Conservation of Ministry of Education, School of Energy & Power Engineering, Dalian University of Technology, Dalian 116024, China.
The escalating discharge of textile wastewater with plenty of dye and salt has resulted in serious environmental risks. Membranes assembled from two-dimensional (2D) nanomaterials with many tunable interlayer spacings are promising materials for dye/salt separation. However, the narrow layer spacing and tortuous interlayer transport channels of 2D-material-based membranes limit the processing capacity and the permeability of small salt ions for efficient dye/salt separation.
View Article and Find Full Text PDFMembranes (Basel)
January 2025
Department of Chemical Engineering, University of Chemical Technology and Metallurgy, 1576 Sofia, Bulgaria.
This study explored the batch membrane filtration of 40% ethanol extracts from spent lavender, containing valuable compounds like rosmarinic acid, caffeic acid, and luteolin, using a polyamide-urea thin film composite X201 membrane. Conducted at room temperature and 20 bar transmembrane pressure, the process demonstrated high efficiency, with rejection rates exceeding 98% for global antioxidant activity and 93-100% for absolute concentrations of the target components. During concentration, the permeate flux declined from 2.
View Article and Find Full Text PDFFront Physiol
January 2025
Department of Physical Therapy, Louisiana State University Health Sciences Center- New Orleans, New Orleans, LA, United States.
Introduction: The purpose of this study was to investigate the relationships between a Power Leg Press test (PLP) with walking capacity and self-reported performance and participation in individuals with Cerebral Palsy (CP), and to compare the strength of the associations between two power tests (PLP and isokinetic (IsoK)) with walking capacity.
Methods: Ambulatory individuals with CP (n = 33; age 17.89 ± 7.
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!