A molecularly imprinted polymer (MIP) for selective adsorption of carbamazepine (CBZ) in aqueous solution was synthesized by precipitation polymerization using CBZ as a template molecule and methacrylic acid (MAA) as a functional monomer. The performance of the CBZ-MIP was evaluated in terms of selectivity, adsorption capacity, binding characteristics, loading volume, and elution volume. The CBZ-MIP exhibited a high affinity for CBZ over the competitive compound (Diclofenac) and was more suitable to remove low concentrations of CBZ in large-volume water samples. A binding performance experiment indicated that the adsorption of CBZ-MIP was characterized by both specific and non-specific binding interactions. Moreover, the regenerability of the MIP was affirmed in ten sequential cycles of adsorption/desorption without a significant loss in recovery. Finally, the CBZ-MIP was applied to enrich CBZ in environmental water samples, and the CBZ concentrations were subsequently determined using HPLC-UV. The results were in good agreement with corresponding LC-MS/MS data.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1016/j.jhazmat.2010.08.018 | DOI Listing |
Int J Biol Macromol
January 2025
Guangxi Key Laboratory of Clean Pulp & Papermaking and Pollution Control, School of Light Industry and Food Engineering, Guangxi University, Nanning 530004, China. Electronic address:
Lignocellulosic nanofibers (LCNF), blending nano-scale cellulose and lignin, were carboxylated and integrated with PVA and baicalin to create a molecularly imprinted membrane (CLCNF-MINM). This innovation, leveraging reactive deep eutectic solvent technology and electrospinning, boosts adsorption capacity by 12.3-21.
View Article and Find Full Text PDFACS Sens
January 2025
Department of Chemistry, Massachusetts Institute of Technology, 77 Massachusetts Avenue, Cambridge, Massachusetts 02139, United States.
Herein, we present the development and evaluation of a molecularly imprinted polymer (MIP) sensor for the sensitive and selective detection of -nitrosodimethylamine (NDMA) in aqueous environments. MIP coatings over electrochemically active electrodes enable NDMA detection with a notably low detection limit of 1.16 ppb.
View Article and Find Full Text PDFAnal Chem
January 2025
The Education Ministry Key Lab of Resource Chemistry, Joint International Research Laboratory of Resource Chemistry, Ministry of Education, Shanghai Frontiers Science Center of Biomimetic Catalysis, Shanghai Key Laboratory of Rare Earth Functional Materials, College of Chemistry and Materials Science, Shanghai Normal University, Shanghai 200234, China.
Conventional dual-signal electrochemiluminescence (ECL) sensors feature high sensitivity and reliability, but the involvement of coreactants inevitably results in a complex configuration and shows reproducibility risk. Here, we propose an exogenous coreactant-free dual-signal platform, comprising luminol (anodic luminophore), CdSe quantum dots (cathodic luminophore), and CoO/TiC electrocatalyst (coreaction promoter). At different redox potentials, CoO/TiC induces water oxidation and oxygen reduction to produce OH and O radicals, which subsequently drive cathodic and anodic ECL emission, respectively.
View Article and Find Full Text PDFMikrochim Acta
January 2025
Department of Chemistry and Center of Excellence for Innovation in Chemistry, Faculty of Science, Ubon Ratchathani University, Ubon Ratchathani, 34190, Thailand.
Carcinoembryonic antigen (CEA) and C-reactive protein (CRP) are biomacromolecules known as cancer and inflammatory markers. Thus, they play a crucial role in early cancer diagnosis, post-treatment recurrence detection, and tumor risk assessment. This paper describes the development of an ultrasensitive and selective imprinted paper-based analytical device (PAD) as impedance sensor for determination of CEA and CRP in serum samples for point-of-care testing (POCT).
View Article and Find Full Text PDFFood Chem
January 2025
Key Laboratory of Photochemical Biomaterials and Energy Storage Materials, Heilongjiang Province, College of Chemistry and Chemical Engineering, Harbin Normal University, Harbin 150025, PR China. Electronic address:
In this study, we designed a molecularly imprinted electrochemical sensor based on the reduced graphene oxide/polydopamine@Mxene (RPM) and FeCu-MOF for the detection of antiviral drug ribavirin (RBV). The RPM composite enhances the active surface area and electron transport capacity of the sensor, and the incorporation of FeCu-MOF can not only further improve the catalytic performance of the material, but also enables the sensor to harness the electrical reduction signal of HO. Furthermore, we developed an optimized molecularly imprinted polymer via density functional theory (DFT) to enhance the sensor's specificity and sensitivity for RBV detection.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!