AI Article Synopsis
- The study explores the synthesis of zirconium phosphate materials using a deep eutectic solvent (DES) but finds that this solvent does not effectively template the desired structures on its own.
- The addition of organic amines, like 1,4-dimethylpiperazine, successfully helps create a new layered compound, ZrPO(4)-DES8, which is characterized using techniques such as X-ray diffraction.
- These novel materials demonstrate superior lubrication properties in comparison to traditional additives, significantly enhancing load-bearing and antiwear performance in liquid lubricants.
Article Abstract
In an attempt to synthesize novel zirconium phosphate materials, a series of syntheses have been performed in a deep eutectic solvent (DES), composed of tetrapropylammonium bromide (TPABr) and oxalic acid. As a result, this DES does not act as a template provider in reaction probably owing to the steric effects of the longer chains of the TPA cation, and only the α-Zr(HPO(4))(2)·H(2)O (α-ZrP) phase has been achieved. However, after organic amine was added to the initial reaction mixture in a normal way, the additives did act as a template to induce the zirconium phosphate framework. For example, with 1,4-dimethylpiperazine as an additive, a novel layered compound, [C(6)H(16)N(2)](0.5)Zr(H(0.5)PO(4))(2)·H(2)O (denoted as ZrPO(4)-DES8) was obtained. Its structure was determined from single-crystal X-ray diffraction (XRD) data and consists of zirconium phosphate layers with the protonated 1,4-dimethylpiperazine and water molecules in between. Interestingly, the two layered materials as additives in a liquid lubricant exhibit excellent friction behavior with higher load-carrying and antiwear capacities in comparison to typical lubricant additives such as MoS(2) and graphite, increase the P(B) value of the base oil by 27.2% and 8.5%, and decrease the wear scar diameter of the base oil by 43% and 36%, respectively. Scanning electron microscopy, XRD, and energy-dispersive X-ray spectrometry are used to investigate the lubricant behavior of those materials.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1021/ic100657a | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Phosphate-adsorbed metal organic framework as a recycled material for catalytic degradation of ceftriaxone sodium via peroxymonosulfate activation.
J Colloid Interface Sci
January 2025
School of Pharmaceutical Engineering, Shenyang Pharmaceutical University, Benxi, Liaoning Province 117004, PR China. Electronic address:
In this study, the zirconium-based metal organic framework (Zr-MOF) was applied as the adsorbent for phosphorus (P) pollution in water. Then the phosphate-adsorbed metal organic frameworks (MOFs) were used as a recycled raw material and calcined to obtain P-doped MOFs-derived carbon material (ZrP@Zr-BTC). Next, the ZrP@Zr-BTC was used for peroxymonosulfate (PMS) activation for the ceftriaxone sodium degradation.
View Article and Find Full Text PDFTitanium(IV), Zirconium(IV), and Cerium(IV) Phosphates Synthesized Under Mild Conditions-Composition Characteristics and Evaluation of Sorption Properties Towards Copper Ions in Comparison to Commercially Available Ion-Exchange Resins.
Materials (Basel)
December 2024
Cracow University of Technology, Faculty of Chemical Engineering and Technology, Warszawska 24, 31-155 Krakow, Poland.
The removal of copper from wastewater of mine origin requires the use of an appropriate method. Sorption methods are considered to be one of the best solutions for removing copper from industrial wastewater at low levels. Metal(IV) phosphates have been reported as excellent sorption materials that can be highly selective for copper.
View Article and Find Full Text PDFDABCO-Intercalated α-Zirconium Phosphate as a Latent Thermal Catalyst in the Reaction of Urethane Synthesis.
Molecules
November 2024
Department of Applied Chemistry, Osaka Institute of Technology, 5-16-1 Omiya, Ashahi-ku, Osaka 535-8585, Japan.
The mixture of hexamethylene diisocyanate (HDI) and butanol (BuOH) with the intercalation compound of 1,4-diazabicyclo[2.2.2]octane (DABCO) with α-zirconium phosphate (α-ZrP) has been evaluated as a latent thermal catalyst at varying temperatures.
View Article and Find Full Text PDFEffect of Acidulated Phosphate Fluoride Gel on Zirconia Intaglio Surface: An Study.
J Int Soc Prev Community Dent
October 2024
Department of Basic Dental Science, College of Dentistry, University of Mosul, Mosul, Iraq.
Aim: To evaluate the micro-shear bond strength (µ-SBS) of resin-modified glass ionomer cement and to assess the chemical and topographical changes in the zirconia fitting surface induced by acidulated phosphate fluoride (APF) gel using scanning electron microscope (SEM) analysis and Fourier transform infrared (FTIR) spectroscopy.
Materials And Methods: Thirty-two samples were prepared from two zirconia materials, UPCERA HT White and BruxZir Solid Zirconia, milled by a computer-aided design/computer-aided manufacturing system. From each zirconia sample, six plates were prepared for FTIR and SEM testing.
Sustainable Antibacterial Surface of Transparent PMMA Membranes with α-ZrP Nanosheets Adsorbing Tetraalkylammonium Ions.
ACS Appl Bio Mater
December 2024
Graduate School of Engineering, Nagasaki University, 1-14 Bunkyo-machi, Nagasaki 852-8521, Japan.
We fabricated composite membranes containing inorganic nanosheets (NSs) and polymers and demonstrated their outstanding antibacterial performance against several opportunistic pathogens. Layered α-zirconium phosphate [Zr(HPO), α-ZrP] as a pristine compound of NS was exfoliated by ion-exchanging protons in the interlayer space of α-ZrP with bulky tetraalkylammonium ions (TRA: R = butyl, hexyl, and octyl). During the exfoliation process, TRA was electrostatically adsorbed onto α-ZrP NS with a negative surface charge (ZrP-TRA-NS).
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!