Rehabilitating acid soils for increasing crop productivity through low-cost liming material.

Sci Total Environ

Directorate of Research, Bidhan Chandra Krishi Viswavidyalaya, Kalyani-741 235, West Bengal, India.

Published: September 2010

Productivity of red and lateritic soils is low because of their acidity and deficiencies in few essential nutrients viz., nitrogen, phosphorus, calcium, zinc, boron, molybdenum etc. We compared the effectiveness of basic slag, a low-cost liming material, with that of calcite as an ameliorant for these soils using mustard followed by rice as test crops. Experiments were conducted with three levels of each of basic slag and calcite along with a control on farmers' fields at 14 different locations. Influence of farmyard manure (FYM) and poultry manure (PM) on the effectiveness of the slag was also tested. On an average, basic slag performed better than calcite in increasing yields of both mustard and rice and left over higher amounts of available Ca, Si and Zn in residual soils. The slag also improved N, P, K and Ca nutrition of mustard and Si and Zn nutrition of rice with a favorable benefit:cost (B:C) ratio over the calcite (4.82 vs. 1.44). Effectiveness of the basic slag improved when it was applied in combination with FYM or PM (B:C, 5.83 and 6.27). Basic slag can, therefore, be advocated for use in the acidic red and lateritic soils for economically improving their productivity.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.scitotenv.2010.07.011DOI Listing

Publication Analysis

Top Keywords

basic slag
20
low-cost liming
8
liming material
8
red lateritic
8
lateritic soils
8
effectiveness basic
8
mustard rice
8
slag improved
8
slag
7
soils
5

Similar Publications

Fluidity influences the use of backfill materials in the mining industry. A new backfill material-modified magnesium slag-based backfill materials (MFPB)-is made from solid waste from coal and metallurgy. We focus on the compatibility of polycarboxylate water reducing agent (SP) with MFPB and its effect on MFPB performance.

View Article and Find Full Text PDF

The article demonstrates the effectiveness of the mechanochemical activation of a cement-ash binder by increasing the specific surface area of the ash and introducing a sodium fluorosilicate additive (NaSiF). It has been experimentally proved that the introduction of a NaSiF additive makes it possible to increase the degree of cement hydration, as well as the intensity of free CaO binding when heating the cement-ash binder in the range of 500 °C to 800 °C. Mechanochemical activation prevents a decrease in the strength of the preheated cement-ash binder.

View Article and Find Full Text PDF

Fly ash (FA) is the main solid waste emitted from coal-fired power plants. Due to its high yield, low utilization rate, and occupation of a large amount of land, it exerts enormous pressure on the Earth's environment. With the deepening of the concept of sustainable development, exploring the reuse of industrial waste such as FA has become a key strategy.

View Article and Find Full Text PDF

Is It Possible to Make Magnesia-Based Cement Environmentally Friendly?

ACS Sustain Chem Eng

November 2024

Department of Engineering, University of Cambridge, Cambridge CB3 0FA, United Kingdom.

Article Synopsis
  • - This paper evaluates the environmental impact of magnesia-based cements using a life cycle assessment approach, focusing on four types of MgO and ten magnesia-based cements.
  • - Results show that using Salt Lake magnesium residue in MgO production can cut CO emissions by over 60% compared to traditional methods, and incorporating alternative materials like fly ash can further reduce emissions by 16-45% in certain cements.
  • - Among the cements studied, carbonation-reactive magnesium cement (CRMC) emerged as the most eco-friendly option, achieving a very low overall environmental impact indicator of 0.00078.
View Article and Find Full Text PDF

The scarcity of conventional aggregates with tremendous growth in highway construction and the indiscriminate dumping of industrial waste materials in precious landfills has become a huge global concern. This study is aimed at utilizing wastes from various industries, including coalmine overburden (OB) dump, basic oxygen furnace (BOF) slag, and fly ash to produce suitable and sustainable cement-treated subbase/base course layers (CBSB/CTB) for flexible pavement construction. Response surface methodology was used to optimize the composition of the blended material considering unconfined compressive strength (UCS) and Poisson's ratio.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!