Background: The purpose of the present study was to compare the relative stability of five volar locking plates (all of which are available for the treatment of intraarticular fractures of the distal radius) under loading conditions simulating the physiological forces that occur during early active mobilization.
Methods: Five plating techniques were applied to surgically simulated AO type C3.2 distal radius fractures in formalin-fixed cadavers. The specimens were tested with a servohydraulic materials testing machine with 250 N of axial compression load for 3000 cycles. After cyclic loading, the specimens were loaded until they demonstrated failure in axial compression. The five fixation systems studied included a DRV locking plate (group 1), a Stellar plate (group 2), an Acu-Loc plate (group 3), AO Locking Distal Radius System 2.4 (group 4); and a Matrix SmartLock plate (group 5).
Results: None of the plate fixations tested failed during the cyclic loading. Group 2 had a higher elastic limit than groups 4 and 5. There were no significant differences among the five groups for the failure load. Failure occurred at the distal portion of the fixation system, at the ulnar side locking pin, or the locking screw was bent (groups 1, 2, 3); the ulnar side locking screw was broken (groups 3, 4); the locking screw became loose (group 4); and the ulnar side locking screw was uncoupled from the screw hole (group 5).
Conclusions: All of the five volar plate fixation systems provided sufficient stability to permit 3000 repeated motions of the digits after surgery for AO type C3 distal radius fractures.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1007/s00776-010-1466-0 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Effectiveness of a scapular exercise program on functional outcomes in patients with hand, wrist or elbow disorders: A comprehensive systematic review with meta-analysis.
J Hand Ther
January 2025
Department of Rehabilitation Sciences and Physiotherapy, Faculty of Medicine and Health Sciences, University of Antwerp, Wilrijk, Belgium.
Background: Usually, patients with hand, wrist/forearm disorders report musculoskeletal complaints in the shoulder. Although, role of scapula is fundamental for movement and functional stability across the upper limb kinetic chain; however, there are no systematic reviews and meta-analyses that have analyzed the effect of scapular exercises in these patients.
Purpose: This study aimed to determine the effectiveness of a scapular exercise program on functional outcomes in patients with hand, wrist or elbow disorders.
Acceptability and safety of 3D printed wrist-based orthoses compared to fiberglass casts for the treatment of non-surgical distal radius- and scaphoid fractures: A randomized feasibility trial.
J Hand Ther
January 2025
Department of Plastic and Hand Surgery, Inselspital Bern, University of Bern, Bern, Switzerland.
Background: Non-invasiveness and comfort are crucial in the conservative management of distal radius and scaphoid fractures. While fiberglass casts are standard, three-dimensional (3D)-printed orthoses offer a promising alternative.
Purpose: To compare patient experiences, safety perceptions, and satisfaction between a 3D orthosis and fiberglass cast for distal radius or scaphoid fractures.
Inflammatory and degenerative changes in the extensor pollicis longus muscle and tendon following ruptures caused by distal radius fractures.
BMC Musculoskelet Disord
January 2025
Department of Hand Surgery, Sahlgrenska University Hospital, Gothenburg, Sweden.
Background: Rupture of extensor pollicis longus tendon (EPL) is a known complication following a distal radius fracture (DRF). Although the precise mechanisms behind these ruptures remain unclear, vascular impairment is thought to play a significant role. Additionally, the impact of an EPL rupture on microstructure of the tendon and muscle is not well understood, but such information could be important in guiding treatment strategies.
View Article and Find Full Text PDFDoes a distal radial fracture lead to osteoarthritis? Re-examining the evidence for early treatment.
J Hand Surg Eur Vol
January 2025
University Hospital Southampton, Southampton, UK.
There are many good reasons to improve the anatomy of a distal radius fracture, such as early return to function and avoidance of sigmoid notch incongruity or ulnocarpal impaction. It is often feared by patients, and portrayed by some authors of scientific articles and medicolegal reports, that a fracture of the distal radius has a propensity to cause symptomatic osteoarthritis. This article examines some of the current evidence and shares the authors' experience.
View Article and Find Full Text PDFA retrospective analysis of quality of life domains impacted by distal radius fracture and ulnar neuropathy.
J Hand Ther
December 2024
Faculty of Health Sciences, Western University, London, Ontario, Canada; Roth McFarlane Hand and Upper Limb Centre, St. Joseph's Hospital, London, Ontario, Canada; School of Rehabilitation Science, McMaster University, Hamilton, Ontario, Canada.
Background: Distal radius fractures (DRF) and ulnar neuropathy (UNE) present with reduced motor function, restricted range of motion, pain, and reduced grip strength that may lead to similar treatment approaches. With rapid and insidious onset for DRF and UNE, respectively, the contextual factors impacting an individuals' experience with the condition can vary.
Purpose: The aim of this secondary analysis is to compare ratings of quality of life (QoL) domains prior to treatment and 3 months post treatment for DRF and UNE.
Want AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!