Influence of flue gas sparging on the performance of high rate algae ponds treating agro-industrial wastewaters.

J Hazard Mater

Department of Chemical Engineering and Environmental Technology, University of Valladolid, C/Dr. Mergelina s/n, 47011, Valladolid, Spain.

Published: July 2010

The influence of flue gas sparging (7% CO(2)) on the performance of two 465 L High-Rate Algal Ponds (HRAPs) treating diluted swine manure at 10 days of hydraulic retention time was evaluated under continental climatic conditions (Castilla y León, Spain). COD, NH(4)(+), and PO(4)(3-) removal efficiencies were not significantly affected by flue gas input (at 2.2 and 5.5 L min(-1)), which suggests that CO(2) sparging does not compromise wastewater treatment in HRAPs. In this particular study, COD and NH(4)(+) removal efficiencies of 56+/-31% (near to maximum swine manure biodegradability) and 98+/-1%, respectively, were consistently maintained, regardless of the environmental and operational conditions. CO(2) sparging resulted however in lower pH values (approximately 2 units lower) and an enhanced NH(4)(+) nitrification (higher NO(3)(-) and NO(2)(-) concentrations) compared to the system operated in the absence of flue gas supply. Biomass concentration was only higher (approximately 30% than in the control HRAP) when flue gases were supplied at 5.5 L min(-1), probably due to the fact that the higher irradiances and temperatures prevailing within this experimental period resulted in an inorganic carbon-limited scenario in the control HRAP. Therefore, it can be concluded that CO(2) assimilation would be ultimately dependent on the occurrence of inorganic carbon limitation and will never occur in light, COD or nutrients-limited scenarios.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.jhazmat.2010.03.112DOI Listing

Publication Analysis

Top Keywords

flue gas
16
influence flue
8
gas sparging
8
swine manure
8
cod nh4+
8
removal efficiencies
8
co2 sparging
8
control hrap
8
gas
4
sparging
4

Similar Publications

Cobalt-Cluster-Based Metal-Organic-Framework-Catalyzed Carboxylative Cyclization of Propargylic Amines with CO from Flue Gas.

Inorg Chem

January 2025

Frontiers Science Center for New Organic Matter, Key Laboratory of Advanced Energy Materials Chemistry (MOE), College of Chemistry, Nankai University, Tianjin 300071, China.

The fixation of carbon dioxide (CO) directly from flue gas into valuable chemicals like 2-oxazolidinones is of great significance for economic and environmental benefits, which is typically catalyzed by noble-metal catalysts and under harsh conditions. Herein, a novel 2-fold interpenetrated framework {[Co(μ-O)(TCA)(HDPTA)]·2HO·2DMF} [Co(II)-based metal-organic framework ()] containing [Co] clusters and highly dense amino groups (-NH) dispersed in the channel was prepared, exhibiting high solvent/pH stability and CO adsorption capacity (24.9 cm·g).

View Article and Find Full Text PDF

The sequestration of carbon dioxide using carbonic anhydrase (CA) is one of the most effective methods for mitigating global warming. The burning of fossil fuels releases large quantities of flue gas; because of its high temperature and of the alkaline conditions required for CaCO precipitation in the mineralization process, thermo-alkali-stable CAs are needed. In this context, Manyumwa et al.

View Article and Find Full Text PDF

This perspective work examines the current advancements in integrated CO capture and electrochemical conversion technologies, comparing the emerging methods of (1) electrochemical reactive capture (eRCC) though amine- and (bi)carbonate-mediated processes and (2) direct (flue gas) adsorptive capture and conversion (ACC) with the conventional approach of sequential carbon capture and conversion (SCCC). We initially identified and discussed a range of cell-level technological bottlenecks inherent to eRCC and ACC including, but not limited to, mass transport limitations of reactive species, limitation of dimerization, impurity effects, inadequate generation of CO to sustain industrially relevant current densities, and catalyst instabilities with respect to some eRCC electrolytes, amongst others. We followed this with stepwise perspectives on whether these are considered intrinsic challenges of the technologies - otherwise recommendations were disclosed where appropriate.

View Article and Find Full Text PDF

The objective of this study was to evaluate the effect of injecting flue gas (CO, N, and O) originating from coal-fired power plants into a coal seam on CH extraction and CO geological storage. To this end, a multifield thermal-fluid-solid-coupled mathematical model of flue gas injection extraction was established. The results showed that with the increase in time increase, the volume concentration of CH decreased, but the CO, N, and O increased.

View Article and Find Full Text PDF

This work studies the influence of flue gas composition, its moisture and ash content, on the efficiency of a CO adsorption/desorption process to capture the CO from flue gases along with its subsequent reuse in greenhouse CO enrichment (Patent ES2514090). The influence of the inlet flow rate, moisture, and ash content were analysed. The experimental conditions were based on those that are achievable under real operating conditions, namely an inlet flow rate from 1.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!