The growth mechanism and crystallization phase state were investigated by the methods of atomic force microscopy (AFM) and X-ray diffraction (XRD). The pentacene films were deposited with a self-assembling monolayer by thermal evaporation on p(+)-Si wafer substrates at room temperature and annealed at a constant temperature (80 degrees C) for 120 min. The experimental results show that pentacene films were grown with terraces island structure with the diameter of island of about 100 nm and constituted a layer consisting of faceted grains with a average step height between terraces of 1.54 nm x s(-1), which were accord with the long axis length of pentacene molecule, and the film were vertically grown on the substrate surface. The crystallization of pentacene thin films is shown in XRD pattern. The increase in the thin film thickness introduced a second set of diffraction peaks, which were attributed to the pentacene triclinic bulk phase. The critical thickness of both phases is 150 and 80 nm, respectively. At a film thickness of 150 nm, the triclinic phase diffraction peaks become the dominant phase. This is contrast to the XRD spectrum of very thin film of 80 thickness, where the thin film phase is the only contribution.

Download full-text PDF

Source

Publication Analysis

Top Keywords

thin film
12
film thickness
12
growth mechanism
8
mechanism crystallization
8
crystallization phase
8
phase state
8
pentacene thin
8
thin films
8
pentacene films
8
diffraction peaks
8

Similar Publications

Solution-Gated Thin Film Transistor Biosensor-Based SnO Amorphous Film for Label-Free Detection of Epithelial Cell Adhesion Molecules.

ACS Sens

January 2025

Ministry of Education Key Laboratory for the Green Preparation and Application of Functional Materials, Hubei Key Laboratory of Polymer Materials, School of Materials Science and Engineering, Hubei University, Wuhan 430062, China.

Epithelial cell adhesion molecule (EpCAM) was considered to be an important marker of multiple tumors, and its high expression is closely related to the early diagnosis and treatment of tumors. At present, metal oxide semiconductors have become a key component of biosensor and bioelectronics technology. Tin oxide shows great potential for development because of its nontoxic, nonpolluting, low price, and excellent electrical properties.

View Article and Find Full Text PDF

High-Efficiency Y6 Homojunction Organic Solar Cells Enabled by a Secondary Hole Transport Layer.

Small

January 2025

Centre for Organic Photonics & Electronics, School of Chemistry and Molecular Biosciences, The University of Queensland, Brisbane, QLD, 4072, Australia.

Y6 homojunction solar cells are prepared using the exciton/electron-blocking material poly[9,9-di-n-octylfluorene-alt-N-(4-sec-butylphenyl)diphenylamine] (TFB) as a secondary hole transport layer material in conjunction with PEDOT:PSS. Using this device architecture, a maximum power conversion efficiency (PCE) of 2.57% is achieved, which is the highest reported thus far for a solution-processed small molecule homojunction organic photovoltaic (OPV) device.

View Article and Find Full Text PDF

Facilitating Charge Separation and CO2 Adsorption in g-C3N4 by Fe Single Atoms on 2D Nitro-Oxygeneous Carbon for Efficient Artificial Photosynthesis.

Chem Asian J

January 2025

National Science and Technology Development Agency, National Nanotechnology Center (NANOTEC), 111 Innovation Cluster 2 B, Thailand Science Park, Phahonyothin Rd, Khlong Nueng, Khlong Luang, 12120, Pathum Thani, THAILAND.

Photocatalytic reduction of carbon dioxide (CO2), so-called artificial photosynthesis, has been regarded as the future technology with high potential to sustainably address global warming. However, the efficiency and stability of the catalysts used in this frontier technology are substantially lower than the requirement for practical application, especially for gas-phase reactions. In this work, the composites of iron single-atom catalysts (Fe-SACs) supported on N/O-doped carbon and graphitic carbon nitride (g-C3N4) were fabricated to promote the gas-solid phase photocatalytic CO2 reduction under the simulated sunlight.

View Article and Find Full Text PDF

Light and Carrier Transportation Management in Transparent Electrode for Achieving over 30% Efficiency Perovskite/Silicon Tandem Solar Cells.

ACS Appl Mater Interfaces

January 2025

Institute of Photoelectronic Thin Film Devices and Technology, Renewable Energy Conversion and Storage Center, State Key Laboratory of Photovoltaic Materials and Cells, Nankai University, Tianjin 300350, P. R. China.

Perovskite/silicon tandem solar cells have drawn widespread attention owing to their higher power conversion efficiency (PCE). However, reducing the reflection and parasitic absorption as much as possible in the transparent electrode is of considerable interest to promote the tandem device to obtain higher circuit current density (). Furthermore, the carrier vertical and lateral transport capability of transparent electrodes also affects the electrical performance of solar cells.

View Article and Find Full Text PDF

The influence of high-intensity electric fields on the stability of polymeric materials is a problem of interest in the design of next-generation energy storage and electronic devices, and for understanding the limits of stability of polymer films exposed to large electric fields generally. Here, we show that the dielectric strength of entangled glassy polymer films increases as an inverse power-law of the film thickness for "ultrathin" films below a micron in thickness. The dielectric strength enhancement in these polymer films becomes as large as ≈2 GV/m in films thinner than 100 nm, but in this thickness regime, the increase of the dielectric strength depends strongly on the polymer mass, sample aging time, and the method of film preparation.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!