The dispersion stability and the zeta potentials of nonspherical crystalline (beta-form) copper phthalocyanine (CuPc) particles of hydrodynamic diameter d(h) approximately = 90 nm were investigated at 25 degrees C in water and in aqueous solutions of NaNO(3). The electrolyte concentrations c ranged from 1 to 500 mM and the particle concentrations ranged from 50 to 10,000 ppm (0.005 to 1 wt %). In each case, the Fuchs-Smoluchowski stability ratio W was determined from dynamic light scattering (DLS) data and the Rayleigh-Debye-Gans (RDG) scattering theory. The data suggest that electrostatic effects play a major role in the stability of CuPc-based dispersions. The calculated particle charge z per CuPc particle based on the zeta potential data and the area of the particles (assumed to be cubical) suggests that there is preferential adsorption of NO(3)(-) ions on the uncharged CuPc surface, and the surface charge increases with increasing electrolyte concentration. Furthermore, two new models of the DLVO theory, for spheres and for parallel face-to-face cubes, were reformulated in dimensionless form. The Hamaker constant of CuPc particles was calculated by the same authors on the basis of theoretical models in J. Chem. Theory Comput. (2010, in press). The key dimensionless group is the ratio N of the electrostatic double layer energy to the Hamaker constant. The two DLVO models were used to predict the value of a dimensionless maximum potential energy Phi(max), the conditions when it may exist, and then the value of W. In water, the DLVO model for spheres overpredicted the stability, while the model for cubes underpredicted the stability. At c = 1 mM, both models overpredicted the stability. At c = 10 mM, the model for spheres underpredicted the stability, whereas the model for cubes overpredicted the stability. Hence, there seems to be some significant shape effects on the electrostatic stabilization of CuPc particle dispersions. At c = 100 and 500 mM, both models underpredicted the stability substantially, suggesting the existence of additional short-range repulsive forces, which may primarily control the stability. Simple sensitivity analysis on the calculations supported these conclusions.

Download full-text PDF

Source
http://dx.doi.org/10.1021/la904224gDOI Listing

Publication Analysis

Top Keywords

overpredicted stability
12
stability model
12
underpredicted stability
12
stability
11
dispersion stability
8
dlvo theory
8
theory spheres
8
spheres parallel
8
parallel face-to-face
8
face-to-face cubes
8

Similar Publications

A time-consistent stabilized finite element method for fluids with applications to hemodynamics.

Sci Rep

November 2023

Sibley School of Mechanical and Aerospace Engineering, Cornell University, Ithaca, NY, 14850, USA.

Several finite element methods for simulating incompressible flows rely on the streamline upwind Petrov-Galerkin stabilization (SUPG) term, which is weighted by [Formula: see text]. The conventional formulation of [Formula: see text] includes a constant that depends on the time step size, producing an overall method that becomes exceedingly less accurate as the time step size approaches zero. In practice, such method inconsistency introduces significant error in the solution, especially in cardiovascular simulations, where small time step sizes may be required to resolve multiple scales of the blood flow.

View Article and Find Full Text PDF

Retrieval uncertainty and consistency of Suomi-NPP VIIRS Deep Blue and Dark Target aerosol products under diverse aerosol loading scenarios over South Asia.

Environ Pollut

August 2023

Institute of Environment and Sustainable Development, Banaras Hindu University, Varanasi, India; DST-Mahamana Centre of Excellence in Climate Change Research, Banaras Hindu University, Varanasi, India. Electronic address:

Retrieval accuracy and stability of two operational aerosol retrieval algorithms, Deep Blue (DB) and Dark Target (DT), applied on Visible Infrared Imaging Radiometer Suite (VIIRS) on-board Suomi National Polar-orbiting Partnership (S-NPP) satellite were evaluated over South Asia. The region is reported to be highly challenging to accurate estimation of satellite-based aerosol optical properties due to variations in surface reflectance, complex aerosol system and regional meteorology. Performance of both algorithms were initially evaluated by comparing their ability to retrieve aerosol signal over the complex geographical region under specific air pollution emission scenario.

View Article and Find Full Text PDF

DARVIC: Dihedral angle-reliant variant impact classifier for functional prediction of missense VUS.

Comput Methods Programs Biomed

August 2023

Cancer Centre and Institute of Translational Medicine, Department of Public Health and Medical Administration, Faculty of Health Sciences, Ministry of Education Frontiers Science Center for Precision Oncology, University of Macau, Macao; Senior Author, Macao. Electronic address:

Background: Of the large number of genetic variants identified, the functional impact for most of them remains unknown. Mutations in DNA damage repair genes such as MUTYH, which is involved in repairing A:8-oxoG mismatches caused by reactive oxygen species, can cause a higher risk of cancer. Mutations happening in other key genes such as TP53 also pose huge health threats and risk of cancer.

View Article and Find Full Text PDF

In Vitro-In Vivo Extrapolation and Scaling Factors for Clearance of Human and Preclinical Species with Liver Microsomes and Hepatocytes.

AAPS J

April 2023

Pharmacokinetics, Dynamics and Metabolism, Pfizer Worldwide Research and Development, Groton, CT, 06340, USA.

In vitro-in vivo extrapolation ((IVIVE) and empirical scaling factors (SF) of human intrinsic clearance (CL) were developed using one of the largest dataset of 455 compounds with data from human liver microsomes (HLM) and human hepatocytes (HHEP). For extended clearance classification system (ECCS) class 2/4 compounds, linear SFs (SF) are approximately 1, suggesting enzyme activities in HLM and HHEP are similar to those in vivo under physiological conditions. For ECCS class 1A/1B compounds, a unified set of SFs was developed for CL.

View Article and Find Full Text PDF

Geometric imperfections are understood to play an essential part in the buckling of a thin shell, but how multiple defects interact to control the onset of failure remains unclear. Here, we examine the failure of real cylindrical shells by experimentally poking soda cans with a large imparted dimple. By high-speed imaging of the can's surface, the initiation of buckling from axial loading is directly observed, revealing that larger dimples tend to set the initial buckling location.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!