The objective of the revised NIOSH (National Institute for Occupational Safety and Health) lifting equation is to prevent or reduce lifting-related injuries. The coupling component of the equation relates to quality of the grip (i.e., hand-to-object interface) and can be rated good, fair, or poor. Good coupling is theorized to reduce lifting stress, whereas poor coupling is theorized to increase lifting stress. This study compared the physiological and psychophysical stress between a lifting task with identical weight but different coupling factors. Subjects (n = 21; 26 +/- 6 years; 177.8 +/- 7.8 cm; 73.9 +/- 10.7 kg) transferred a milk crate or bag of dog food each weighing 12.5 kg back and forth from the floor to a table for 2, paced, 5-minute work bouts. Steady-state metabolic data were used to compare the lifting tasks. Results showed significantly higher oxygen consumption, caloric cost, heart rate, and rating of perceived exertion during the lifting task using the milk crate vs. the bag of dog food (p < 0.05). No difference in respiratory exchange ratio was observed (p > 0.05). In conclusion, a significantly higher metabolic cost and perceived exertion was observed when subjects performed a paced two-handed lifting task with good coupling factors than when using an object with poor coupling factors. When lifting stress is measured by metabolic cost and perceived exertion, these results are in contrast to expectations that a poor quality grip (i.e., poor coupling) would increase stress of a lifting task. Results of this study may help the work-place practitioner make decisions related to the use of the revised NIOSH lifting equation in the design and pacing of lifting-related tasks. Improved decision making may benefit productivity and enhance injury prevention in the workplace.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1519/JSC.0b013e3181c8c84e | DOI Listing |
Ind Health
January 2025
Department of Social and Preventive Medicine, Faculty of Medicine, Universiti Malaya, Malaysia.
Low back pain (LBP) is a commonly encountered medical disorder in Malaysia's primary care setting, though establishing a direct connection between LBP and the workplace environment in adults is challenging. This case presents a clinic nurse who developed LBP due to a prolapsed intervertebral disc and her clinical management from an Occupational Health Doctor perspective. Her occupational management involved a walk-through survey at an urban hospital, which identified bone marrow aspiration as her most physically demanding task.
View Article and Find Full Text PDFLife (Basel)
January 2025
Occupational Medicine Unit, Department of Medical and Surgical Sciences, Alma Mater Studiorum University of Bologna, 40138 Bologna, Italy.
Musculoskeletal disorders are the most prevalent occupational health problem and are often related to biomechanical risk factors. Over the last forty years, observational methods for exposure assessment have been proposed. To apply them effectively in the field, an in-depth knowledge of each methodology and a solid understanding of their actual predictive value and limitations are required.
View Article and Find Full Text PDFAppl Microbiol Biotechnol
January 2025
Department of Microbiology and Biochemistry, Hochschule Geisenheim University, Von-Lade-Straße 1, 65366, Geisenheim, Germany.
Improving ale or lager yeasts by conventional breeding is a non-trivial task. Domestication of lager yeasts, which are hybrids between Saccharomyces cerevisiae and Saccharomyces eubayanus, has led to evolved strains with severely reduced or abolished sexual reproduction capabilities, due to, e.g.
View Article and Find Full Text PDFJACC Adv
December 2024
Department of Clinical and Experimental Cardiology, Amsterdam University Medical Center, University of Amsterdam Amsterdam, the Netherlands.
J Appl Biomech
January 2025
Woodruff School of Mechanical Engineering, Georgia Institute of Technology, Atlanta, GA, USA.
Repetitive manual labor tasks involving twisting, bending, and lifting commonly lead to lower back and knee injuries in the workplace. To identify tasks with high injury risk, we recruited N = 9 participants to perform industry-relevant, 2-handed lifts with a 11-kg weight. These included symmetrical/asymmetrical, ascending/descending lifts that varied in start-to-end heights (knee-to-waist and waist-to-shoulder).
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!