A pyrolysis source coupled to a supersonic expansion has been used to produce the CH3 radical from two precursors, iodomethane CH3I and nitromethane CH3NO2. The relative ionization yield of CH3 has been recorded at the SOLEIL Synchrotron Radiation source in the range 9.0-11.6 eV, and its ionization threshold has been modeled by taking into account the vibrational and rotational temperature of the radical in the molecular beam. The relative photoionization yield has been normalized to an absolute cross section scale at a fixed wavelength (118.2 nm, sigma(i)(CH3) = 6.7(-1.8)(+2.4) Mb, 95% confidence interval) in an independent laboratory experiment using the same pyrolysis source, a vacuum ultraviolet (VUV) laser, and a carefully calibrated detection chain. The resulting absolute cross section curve is in good agreement with the recently published measurements by Taatjes et al., although with an improved signal-to-noise ratio. The absolute photoionization cross section of CH3I at 118.2 nm has also been measured to be sigma(i)(CH3I) = (48.2 +/- 7.9) Mb, in good agreement with previous electron impact measurements. Finally, the photoionization yield of the iodine atom in its ground state 2P(3/2) has been recorded using the synchrotron source and calibrated for the first time on an absolute cross section scale from our fixed 118.2 nm laser measurement, sigma(i)(I2P(3/2)) = 74(-23)(+33) Mb (95% confidence interval). The ionization curve of atomic iodine is in good agreement, although with slight variations, with the earlier relative ionization yield measured by Berkowitz et al. and is also compared to an earlier calculation of the iodine cross section by Robicheaux and Greene. It is demonstrated that, in the range of pyrolysis temperature used in this work, all the ionization cross sections are temperature-independent. Systematic care has been taken to include all uncertainty sources contributing to the final confidence intervals for the reported results.

Download full-text PDF

Source
http://dx.doi.org/10.1021/jp909414dDOI Listing

Publication Analysis

Top Keywords

pyrolysis source
12
absolute cross
12
good agreement
12
absolute photoionization
8
photoionization cross
8
cross sections
8
vacuum ultraviolet
8
relative ionization
8
ionization yield
8
photoionization yield
8

Similar Publications

The increasing global population and urbanization have led to significant challenges in waste management, particularly concerning vacuum blackwater (VBW), which is the wastewater generated from vacuum toilets. Traditional treatment methods, such as landfilling and composting, often fall short in terms of efficiency and sustainability. Anaerobic digestion (AD) has emerged as a promising alternative, offering benefits such as biogas production and digestate generation.

View Article and Find Full Text PDF

Plastic pollution, particularly from microplastics (MPs) and nanoplastics (NPs), has become a critical environmental and health concern due to their widespread distribution, persistence, and potential toxicity. MPs and NPs originate from primary sources, such as cosmetic microspheres or synthetic fibers, and secondary fragmentation of larger plastics through environmental degradation. These particles, typically less than 5 mm, are found globally, from deep seabeds to human tissues, and are known to adsorb and release harmful pollutants, exacerbating ecological and health risks.

View Article and Find Full Text PDF

As global demand for fossil fuels rises amidst depleting reserves and environmental concerns, exploring sustainable and renewable energy sources has become imperative. This study investigated the pyrolysis of corncob, a widely available agricultural waste, using urea as a catalyst to enhance bio-oil production. The aim was to determine the optimum urea concentration and pyrolysis temperature for bio-oil yield from corncob.

View Article and Find Full Text PDF

Co-pyrolysis is an efficient approach for municipal sewage sludge (SS) treatment, facilitating the production of biochar and promoting the stabilization and removal of heavy metals, particularly when combined with chlorinated materials. This study explores the impact of pyrolysis temperatures (400 °C and 600 °C) and chlorinated additives (polyvinyl chloride (PVC) as an organic chloride source and ferric chloride (FeCl) as an inorganic chloride source) at 10% and 20% concentrations, on the yield, chemical speciation, leachability, and ecological risks of arsenic (As), chromium (Cr), and zinc (Zn) in biochar derived from SS. The results revealed that increasing the pyrolysis temperature from 400 to 600 °C significantly reduced biochar yield due to enhanced volatilization of organic components, as well as the removal of heavy metals in interaction with chlorinated materials.

View Article and Find Full Text PDF

In this study, a pyrolysis-gas chromatography/mass spectrometry method was established to quantify microplastics (MPs) released from plastic food containers during rinsing and migration. The inner surface of actual samples was rinsed with deionized water, and the MPs in rinse water were collected through a glass fiber membrane with pore size of 1 μm. Subsequently, thoroughly cleaned polypropylene (PP) food packaging containers were selected for migration tests under different simulants, migration temperatures, and migration times.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!