Objectives: We evaluated the inflammatory reactions induced by three commonly used nonabsorbable suture materials in a rabbit model.

Methods: Three suture materials were tested: braided polyester suture (Ethibond), braided blend of polyester and polyethylene suture (FiberWire), and monofilament polypropylene suture (Polypropylene). Thirty-six rabbits were randomly allocated to three suture groups, equal in number. Each suture type was placed bilaterally in the quadriceps muscle, patellar tendon, knee joint capsule, and Achilles tendon. Six animals in each group were sacrificed in the third and sixth weeks. The inflammation induced by each suture was assessed using light microscopy and the width of the inflammation zone (WIZ) was measured.

Results: Ethibond was found to cause the most severe reaction in the muscle and tendon in the third week; in the sixth week, however, it showed the lowest inflammatory reaction in all tissue types. Reaction to Propylene was moderate in the third week, whereas it caused the largest WIZ in all tissue types in the sixth week, such that the eventual size of the WIZ induced by Propylene (6.6 + or - 2.1 mm) was significantly greater than that of Ethibond (1.6 + or - 0.9 mm) in muscle specimens (p<0.05). Except for the largest WIZ seen in joint capsule specimens in the third week, inflammatory reactions associated with FiberWire were low or moderate in all tissue specimens throughout the study. FiberWire was associated with some necrotic areas in two muscle and one tendon specimens.

Conclusion: The extent of inflammatory reaction to nonabsorbable suture materials depends on the type of suture material, tissue type, and the duration of postoperative time.

Download full-text PDF

Source
http://dx.doi.org/10.3944/AOTT.2009.366DOI Listing

Publication Analysis

Top Keywords

suture materials
12
suture
9
nonabsorbable suture
8
materials rabbit
8
three suture
8
third week
8
sixth week
8
tissue types
8
[evaluation soft
4
soft tissue
4

Similar Publications

colorectal cancer is a common and serious condition, with surgical resection being the primary treatment for localized cases. Anastomotic dehiscence (AD) remains a significant postoperative complication, and anastomoses are typically created using either manual suturing or mechanical stapling, each with specific benefits and challenge. Material and this retrospective study analyzed outcomes in 100 rectal cancer patients who underwent surgical resection, with anastomoses performed via manual suturing (n=50) or mechanical stapling (n=50).

View Article and Find Full Text PDF

Purpose: The objective was to use cyclic tensile loading to compare the gap formation at suture site of three different suture materials to repair bovine radial meniscal tears: (1) polyglactin sutures, (2) tough adhesive puncture sealing (TAPS) sutures and (3) ultra-high molecular weight polyethylene (UHMWPE) sutures.

Methods: Twelve ex vivo bovine knees were dissected to retrieve the menisci. Complete radial tears were performed on 24 menisci, which were then separated into three groups and repaired using either pristine 2-0 polyglactin sutures, TAPS sutures (2-0 polyglactin sutures coated with adhesive chitosan/alginate hydrogels) or 2-0 UHMWPE sutures with a single stitch.

View Article and Find Full Text PDF

Background/aim: Cesarean section (CS) is a widely performed operation worldwide but data about uterine closure are lacking. We aimed to evaluate scar niches and compare single-layer and double-layer uterine closure at 6 months following CS.

Materials And Methods: This prospective randomized trial assessed 56 women undergoing single- or double-layer uterine closure.

View Article and Find Full Text PDF

[Cancellous bone harvesting from the distal radius for reconstruction of bone defects in the hand].

Oper Orthop Traumatol

December 2024

Unfall‑, Hand- und Ellenbogenchirurgie, Klinik und Poliklinik für Orthopädie und Unfallchirurgie, Universitätsklinikum zu Köln, Köln, Deutschland.

Objective: Extraction of cancellous bone from the distal radius for reconstructive procedures on the hand.

Indications: All reconstructive procedures on the hand for which a corticocancellous and/or vascularized bone graft or a large amount of cancellous bone is not required.

Contraindications: Acute distal radius fracture, osteosynthesis material embedded in the distal radius, e.

View Article and Find Full Text PDF

Three-dimensional (3D) printing is an advanced technology for accurately understanding anatomy and supporting the successful surgical management of complex congenital heart disease (CHD). We aimed to evaluate whether our super-flexible 3D heart models could facilitate preoperative decision-making and surgical simulation for complex CHD. The super-flexible heart models were fabricated by stereolithography 3D printing of the internal and external contours of the heart from cardiac computed tomography (CT) data, followed by vacuum casting with a polyurethane material similar in elasticity to a child's heart.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!