The sonochemical degradation kinetics of the aqueous perfluorochemicals (PFCs) perfluorobutanoate (PFBA), perfluorobutanesulfonate (PFBS), perfluorohexanoate (PFHA), and perfluorohexanesulfonate (PFHS) have been investigated. Surface tension measurements were used to evaluate chain-length effects on equilibrium air-water interface partitioning. The PFC air-water interface partitioning coefficients, KeqPF, and maximum surface concentrations, Gamma(max)PF, were determined from the surface pressure equation of state for PFBA, PFBS, PFHA, and PFHS. Relative KeqPF values were dependent upon chain length KeqPFHS approximately equal to 2.1KeqPFHA approximately equal to 3.9KeqPFBS approximately equal to 5.0KeqPFBA, whereas relative GammamaxPF values had minimal chain length dependence Gamma(max)PFHS approximately equal to Gamma(max)PFHA approximately equal to Gamma(max)PFBS approximately equal to 2.2Gamma(max)PFBA. The rates of sonolytic degradation were determined over a range of frequencies from 202 to 1060 kHz at dilute (<1 microM) initial PFC concentrations and are compared to previously reported results for their C8 analogs: perfluorooctanesulfonate (PFOS) and perfluorooctanoate (PFOA). Under all conditions, the time-dependent PFC sonolytic degradation was observed to follow pseudo-first-order kinetics, i.e., below kinetic saturation, suggesting bubble-water interface populations were significantly below the adsorption maximum. The PFHX (where X = A or S) sonolysis rate constant was observed to peak at an ultrasonic frequency of 358 kHz, similar to that for PFOX. In contrast, the PFBX degradation rate constants had an apparent maximum at 610 kHz. Degradation rates observed for PFHX are similar to previously determined PFOX rates, kapp,358PFOX approximately equal to kapp,358PFHX. PFOX is sonolytically pyrolyzed at the transiently cavitating bubble-water interface, suggesting that rates should be proportional to equilibrium interfacial partitioning. However, relative equilibrium air-water interfacial partitioning predicts that KeqPFOX 5KeqPFHX. This suggests that at dilute PFC concentrations, adsorption to the bubble-water interface is ultrasonically enhanced due to high-velocity radial bubble oscillations. PFC sonochemical kinetics are slower for PFBS and further diminished for PFBA as compared to longer analogs, suggesting that PFBX surface films are of lower stability due to their greater water solubility.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1021/jp903003w | DOI Listing |
Sci Total Environ
December 2024
Department of Wildlife, Fisheries, and Conservation Biology, University of Maine, Orono, ME, United States; U.S. Geological Survey, Maine Cooperative Fish and Wildlife Research Unit, Orono, ME, United States.
The ubiquitous occurrence and persistence of per- and polyfluoroalkyl substances (PFAS) in all environmental matrices and biota poses significant health risks to humans. Fish consumption is one of the main pathways humans are exposed to PFAS, yet general patterns in factors influencing PFAS content in fish fillets remain unknown. We assembled information on PFAS content (total quantified PFAS, PFOS, PFOA, and others) in fish fillets to assess the effect of fish origin (marine, freshwater, wild, or farmed), fillet type (skin-on or skin-off), and lipid content on PFAS variation across environments at a global scale.
View Article and Find Full Text PDFGels
November 2024
State Key Laboratory of Rice Biology, Key Laboratory of the Ministry of Agriculture and Rural Affairs for Nuclear-Agricultural Sciences, Zhejiang University, Hangzhou 310058, China.
Potato starch is widely utilized in the food industry. Gamma irradiation is a cost-effective and environmentally friendly method for starch modification. Nevertheless, there is a scarcity of comprehensive and consistent knowledge regarding the physicochemical characteristics of high-dose gamma-irradiated potato starch, retrogradation properties in particular.
View Article and Find Full Text PDFACS Appl Mater Interfaces
December 2024
Department of Industrial and Materials Science, Chalmers University of Technology, SE-412 58 Gothenburg, Sweden.
The full exploitation of the outstanding mechanical properties of cellulose nanofibrils (CNFs) as potential reinforcements in nanocomposite materials is limited by the poor interactions at the CNF-polymer matrix interface. Within this work, tailor-made copolymers were designed to mediate the interface between CNFs and biodegradable poly(butylene adipate--terephthalate) (PBAT), and their effect on extruded nanocomposite performance was tested. For this purpose, two well-defined amphiphilic anchor-tail diblock copolymer structures were compared, with a fixed anchor block length and a large difference in the hydrophobic tail block length.
View Article and Find Full Text PDFExtremophiles
December 2024
Departamento de Química Biológica, Facultad de Ciencias Exactas y Naturales, Universidad de Buenos Aires, IQUIBICEN-CONICET, 1428, Buenos Aires, Argentina.
Polyhydroxyalkanoates (PHAs) are intracellular polymers that enhance bacterial fitness against various environmental stressors. Pseudomonas extremaustralis 14-3b is an Antarctic bacterium capable of accumulating, short-chain-length PHAs (sclPHAs), composed of C3-C5 monomers, as well as medium-chain-length PHAs (mclPHAs) containing ≥ C6 monomers. Since pH changes are pivotal in bacterial physiology, influencing microbial growth and metabolic processes, we propose that accumulated PHA increases P.
View Article and Find Full Text PDFLangmuir
December 2024
State Key Laboratory of Fluorinated Functional Membrane Materials, Dongyue Fluorosilicone Technology Group, Zibo 256400, China.
Three α-alkene lubricants, differentiated by chain length, were selected as model compounds to investigate the influence of chain length on tribological properties. The novelty of this study lies in setting chain length as the sole variable to explore its impact on surface and adsorption energy. Based on the above findings, the study provides a unique explanation of the intrinsic relationship between chain length and tribological performance.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!