This paper presents the potentials and performance of combined treatment of faecal sludge (FS) and municipal solid waste (SW) through co-composting. The objectives were to investigate the appropriate SW type, SW/FS mixing ratio and the effect of turning frequency on compost maturity and quality. Solid waste (SW, as market waste, MW, or household waste, HW) was combined with dewatered FS in mixing ratios of 2:1 and 3:1 by volume and aerobically composted for 90 days. Four composting cycles were monitored and characterised to establish appropriate SW type and mixing ratio. Another set of five composting cycles were monitored to test two different turning frequencies: (i) once in 3-4 days during the thermophilic phase and 10 days during maturation phase and (ii) once in every 10 days throughout the composting period. Samples were taken at every turning and analysed for total solids (TS), total volatile solids (TVS), total organic carbon (TOC), electrical conductivity (EC), pH, ammonium and nitrate nitrogen (NH(4)-N and NO(3)-N) and total Kjeldahl nitrogen (TKN). Temperature, C/N ratio, NO(3)-N/NH(4)-N ratio and cress planting trials were chosen as maturity indicators. Result showed a preference of MW over HW and mixing ratio of 2:1 over 3:1. There was no significant effect of different turning frequencies on the temperature changes and the quality of mature compost. The final product contained C/N ratio of 13 and NO(3)/NH(4)-ratio of about 7.8, while TVS was about 21% TS and the NH(4)-N content was reduced to 0.01%. A co-composting duration of 12 weeks was indicated by the cress test to achieve a mature and stable product. The turning frequency of 10 days is recommended as it saves labour and still reaches safe compost with fairly high nutrient content.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.watres.2009.07.021DOI Listing

Publication Analysis

Top Keywords

solid waste
12
mixing ratio
12
faecal sludge
8
appropriate type
8
ratio turning
8
turning frequency
8
days composting
8
composting cycles
8
cycles monitored
8
turning frequencies
8

Similar Publications

Alkali and sulfate effects on mechanical properties and microscopic mechanisms of slag and fly ash geopolymers.

Sci Rep

January 2025

College of Hydraulic and Civil Engineering, Xinjiang Agricultural University, Urumqi, 830052, Xinjiang, People's Republic of China.

Aiming at the problem that it is difficult to realize low-cost, high-performance and large-scale utilization of cementitious materials prepared from bulk solid wastes, this paper constructs a set of composite cementitious system based on alkaline activation of slag and fly ash (FA) by calcium carbide slag (CCS) and synergistic activation of sodium sulfate (NaSO) as a chemical dopant. The influence of factors such as solid waste type, mixing ratio, and NaSO content on the mechanical properties of composite cementitious systems was investigated by assessing compressive strength and analyzing microstructure using XRD, SEM-EDS, and FTIR. The test results indicate that CCS and NaSO exert significant influences on the strength of the composite cementitious system.

View Article and Find Full Text PDF

As a result of the current high throughput of the fast fashion collections and the concomitant decrease in product lifetime, we are facing enormous amounts of textile waste. Since textiles are often a blend of multiple fibers (predominantly cotton and polyester) and contain various different components, proper waste management and recycling are challenging. Here, we describe a high-yield process for the sequential chemical recycling of cotton and polyester from mixed waste textiles.

View Article and Find Full Text PDF

Cofactor-directed co-immobilization of dual-enzyme on functionalized montmorillonite with enhanced catalytic performance.

Int J Biol Macromol

January 2025

School of Environment and Resource, Key Laboratory of Solid Waste Treatment and Resource Recycle of Ministry of Education, Southwest University of Science and Technology, Mianyang, Sichuan 621010, China.

Recently, multi-enzyme cascade catalysis has attracted increasing attention due to the advantages of integrating multiple enzymes, few side reactions and high catalytic efficiency. Herein, a novel dual-enzyme cascade system (GOx-FMt-HRP) was developed through cofactor-directed orientational co-immobilization of glucose oxidase (GOx) and horseradish peroxidase (HRP) onto functional montmorillonite (FMt). The presented method realizes the reconstitution of cofactors and apo-enzymes (enzymes without cofactors), which enables enzymes to be immobilized in specific orientations on the support, thereby effectively reducing changes in their conformation.

View Article and Find Full Text PDF

Estimating wastewater emissions and environmental levels of typical organic contaminants based on regionalized modelling.

Environ Res

January 2025

The Key Laboratory of Environmental Pollution Health Risk Assessment, Research Center of Emerging Contaminants, South China Institute of Environmental Sciences, Ministry of Ecology and Environment, Guangzhou 510655, P.R. China.

Organic contaminants (OCs) are released into the environment through effluent discharges from wastewater treatment plants (WWTP), posing risks to environment health. However, emissions from various source, particularly large-scale investigations across different industries, remain poorly understood. Based on both sampling and statistical data, this study estimates the emissions of 10 OCs, including perfluorooctane acid (PFOA), perfluorooctane sulfonate (PFOS), 4-nonylphenol (4-NP), 4-tert-octylphenol (4-t-OP), dibutyl phthalate (DBP), di-iso-butyl phthalate (DIBP), dimethyl phthalate (DMP), butyl benzyl phthalate (BBP), di(2-ethylhexyl) phthalate (DEHP), and bisphenol A (BPA), from the effluents of 160 factories across 8 industries, 541 municipal wastewater treatment plants (MWWTPs), and 8 waste treatment plants (WTPs) in the upper Yangtze River Basin.

View Article and Find Full Text PDF

Comprehensive evaluation of low-carbon cementitious materials prepared with industrial by-product calcium carbide residue (CCR) as alkali source.

Environ Res

January 2025

Science and Technology Innovation Center of Smart Water and Resource Environment, Northeastern University, Shenyang 110819, China; School of Resources and Civil Engineering, Northeastern University, Shenyang 110819, China; Liaoning Institute of Technological Innovation in Solid Waste Utilization, Northeastern University, Shenyang 110819, China.

The preparation of low-carbon cementitious materials through the synergistic coupling of multiple solid wastes has great potential for development, which can improve the problems of resource shortage and environmental pollution. In this paper, a new type of supersulfated cement was developed by using calcium carbide residue (CCR) as an alkaline activator. The effects of CCR content on the mechanical properties and hydration behaviors of the samples under steam curing conditions were discussed.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!