The acceleration of electrons to approximately 0.8 GeV has been observed in a self-injecting laser wakefield accelerator driven at a plasma density of 5.5x10(18) cm(-3) by a 10 J, 55 fs, 800 nm laser pulse in the blowout regime. The laser pulse is found to be self-guided for 1 cm (>10zR), by measurement of a single filament containing >30% of the initial laser energy at this distance. Three-dimensional particle in cell simulations show that the intensity within the guided filament is amplified beyond its initial focused value to a normalized vector potential of a0>6, thus driving a highly nonlinear plasma wave.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1103/PhysRevLett.103.035002 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Laser surface nanoalloying of Fe, Si, and C on aluminum substrates with excellent optical and electronic properties.
Nanoscale Adv
January 2025
Energy Masteries Laboratory, Physics Department, School of Sciences and Engineering, The American University in Cairo New Cairo 11835 Egypt
Laser surface alloying of Fe, Si, and C on aluminium is demonstrated using a Q-switched Nd:YAG laser as the source of energy. The fundamental wavelength of the laser beam was 1064 nm with an output energy of 100 mJ and a pulse duration of 10 ns. The exposure was conducted in repetitive mode with a frequency rate of 1 Hz.
View Article and Find Full Text PDFImplementation of multiple soliton state fiber laser using a promising saturable absorber of silver indium phosphorus sulfide.
iScience
January 2025
School of Science, Beijing University of Posts and Telecommunications, Beijing 100876, China.
Based on the nonlinear broadband saturation absorption, ultrafast carrier recovery rate, and ultrashort recovery time of new low dimensional materials, ultrafast photonics has rapidly developed as an interdisciplinary field. We have demonstrated multiple solitons state output in an erbium-doped fiber laser based on saturable absorption characteristic of AgInPS. By preparing AgInPS with a modulation depth of 10.
View Article and Find Full Text PDFIn situ quantification of fungicide residue on wheat leaf surfaces using matrix-assisted laser desorption/ionization time-of-flight mass spectrometry imaging technology.
Food Chem X
January 2025
State Environmental Protection Key Lab of Environmental Risk Assessment and Control on Chemical Processes, School of Resources & Environmental Engineering, East China University of Science and Technology, Shanghai 200237, China.
To overcome the time-consuming off-site limitations in conventional pesticide detection, this contribution presents an in situ quantitative analysis detection strategy for pesticides on leaf surfaces using matrix-assisted laser desorption/ionization time-of-flight mass spectrometry imaging technology. Taking fungicide metrafenone as a representative, we initially screened seven commonly used matrices, and identifying α-cyano-4-hydroxycinnamic acid as the most effective one in positive mode. Subsequently, coating the matrix using sublimation spraying method resulted in the highest mass intensity.
View Article and Find Full Text PDFGreen light-responsive photoelectrochemical sensing nanoplatform based on copper cobaltite nanorods for ultrasensitive detection of furazolidone antibiotic residue in food samples.
RSC Adv
January 2025
Phenikaa University Nano Institute (PHENA), PHENIKAA University Hanoi 12116 Vietnam
In this research, the preparation of copper cobaltite (CuCoO) nanorods and its potential application in photoelectrochemical sensing platform towards ultrasensitive detection of furazolidone are reported. X-ray diffraction, Raman spectra, scanning electron microscopy, and UV-visible spectroscopy have been performed to confirm the formation, morphology, phase composition, and optical properties of CuCoO synthesized by a microwave-assisted hydrothermal method. The electrochemical characteristic parameters were calculated electrochemical impedance spectroscopy, cyclic voltammetry, differential pulse voltammetry, and chronoamperometry techniques in the absence and presence of laser light irradiation.
View Article and Find Full Text PDFA systematic review on whole-body photobiomodulation for exercise performance and recovery.
Lasers Med Sci
January 2025
Cornell University, Ithaca, USA.
Purpose: Photobiomodulation (PBM) is a non-invasive therapeutic procedure that consists of irradiating a local area of the skin with red and near-infrared lasers or light emitting diodes (LEDs). Local PBM has been studied as a method to improve exercise performance and recovery. This review aims to evaluate the efficacy of whole-body PBM for exercise performance and recovery, comparing its findings to the established effects of localized PBM.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!