The structure of the silica supported palladium(II) complex [Pd(dppp)(S2C-NEt2)]BF4 (abbreviated as [Pd(dppp)(dtc)]BF4, where dppp is Ph2P(CH2)3PPh2) and interactions between the [Pd(dppp)(dtc)]+ cation, the BF4(-) anion, and the silica surface are studied using solid-state NMR spectroscopy. The unsupported, crystalline form of [Pd(dppp)(dtc)]BF4 is also investigated, both by X-ray diffraction and NMR. The structures of the cation and anion are found to be essentially the same in both unsupported and supported complex. The [Pd(dppp)(dtc)]BF4 loading has been determined by quantitative measurements of 11B, 19F, and 31P intensities, whereas the arrangement of anions and cations on the surface of silica has been established by two-dimensional heteronuclear correlation experiments involving 1H, 11B, 13C, 19F, 29Si, and 31P nuclei. At low coverages, the [Pd(dppp)(dtc)]+ cations are located near the BF4(-) anions, which in turn are immobilized directly on the surface near the Q4 sites. At higher loadings, which in this study corresponded to 0.06-0.15 mmol/g, the complexes stack on top of each other, despite the fact that the directly adsorbed molecules take up less than 10% of the silica surface. The relevance of these findings to heterogeneous catalysis is discussed.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1021/ja902982u | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
A Ring-Shaped Lithium Metal Anode Enables High-Performance All-Solid-State Batteries Revealed by In Situ L-Band EPR Imaging.
J Phys Chem Lett
January 2025
Shanghai Key Laboratory of Magnetic Resonance, Institute of Magnetic Resonance and Molecular Imaging in Medicine, School of Physics and Electronic Science, East China Normal University, Shanghai 200062, P. R. China.
In traditional operations of all-solid-state lithium metal batteries (ASSLMBs), a small thin lithium metal circular disk is employed as a lithium metal anode (LMA). However, ASSLMBs with a circular-disk LMA often fail in <150 cycles with low capacity retention. In this work, we developed a new ring-shaped LMA to improve cyclability.
View Article and Find Full Text PDFCarving Metal-Organic-Framework Glass Based Solid-State Electrolyte Via a Top-Down Strategy for Lithium-Metal Battery.
Angew Chem Int Ed Engl
January 2025
KU Leuven, Materials engineering, Kasteelpark Arenberg 44 bus 2450, 3001 LEUVEN Belgium, LEUVEN, BELGIUM.
Traditional polymer solid electrolytes (PSEs) suffer from low Li conductivity, poor kinetics and safety concerns. Here, we present a novel porous MOF glass gelled polymer electrolyte (PMG-GPE) prepared via a top-down strategy, which features a unique three-dimensional interconnected graded-aperture structure for efficient ion transport. Comprehensive analyses, including time-of-flight secondary ion mass spectrometry (TOF-SIMS), Solid-state 7Li magic-angle-spinning nuclear magnetic resonance (MAS-NMR), Molecular Dynamics (MD) simulations, and electrochemical tests, quantify the pore structures, revealing their relationship with ion conductivity that increases and then decreases as macropore proportion rises.
View Article and Find Full Text PDFGreen Synthesis of a New Schiff Base Linker and Its Use to Prepare Coordination Polymers.
Cryst Growth Des
January 2025
Department of Chemical Sciences, Bernal Institute, University of Limerick, Limerick V94 T9PX, Republic of Ireland.
Solid-state synthesis is an approach to organic synthesis that is desirable because it can offer minimal or no solvent waste, high yields, and relatively low energy footprints. Herein, we report the solid-state synthesis of a novel Schiff base, 4-{()-[(4-methylpyridin-3-yl)imino]methyl}benzoic acid (), synthesized through the reaction of an amine and an aldehyde. was prepared via solvent-drop (water) grinding (SDG) on a multigram scale with 97% yield and was characterized using FTIR, H NMR, and SCXRD.
View Article and Find Full Text PDFEmrE is a bacterial membrane-embedded multidrug transporter that functions as an asymmetric homodimer. EmrE is implicated in antibiotic resistance, but is now known to confer either resistance or susceptibility depending on the identity of the small molecule substrate. Here, we report both solution- and solid-state NMR assignments of S64V-EmrE at pH 5.
View Article and Find Full Text PDFA simple and highly efficient protocol for C-labeling of plant cell wall for structural and quantitative analyses via solid-state nuclear magnetic resonance.
Plant Methods
January 2025
Department of Environmental and Plant Biology, Ohio University, Athens, OH, 45701, USA.
Background: Plant cell walls are made of a complex network of interacting polymers that play a critical role in plant development and responses to environmental changes. Thus, improving plant biomass and fitness requires the elucidation of the structural organization of plant cell walls in their native environment. The C-based multi-dimensional solid-state nuclear magnetic resonance (ssNMR) has been instrumental in revealing the structural information of plant cell walls through 2D and 3D correlation spectral analyses.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!