Storage media effect on bond strength of orthodontic brackets.

Am J Orthod Dentofacial Orthop

Department of Orthodontics, School of Dentistry, University of Colorado at Denver and Health Sciences Center, Aurora, CO 80045, USA.

Published: July 2009

Introduction: In testing bond strengths, various storage media are used. The purpose of this study was to determine the effect of 6 storage media and rinsing on the shear bond strength of bonded orthodontic brackets.

Methods: Bovine teeth were stored in 6 storage media for 7 months before bonding: dry (no medium), filtered water, 10% formalin, 1% chloramine T, 10% chloramine T, isotonic saline solution, and 70% ethanol. These teeth were further subdivided into 2 groups; 1 group was rinsed with oil-free air and water spray before bonding orthodontic brackets, and the other group not rinsed. All specimens were tested in the shear-peel mode to failure.

Results: The 10% formalin rinsed sample had statistically significantly higher bond strength (16.9 +/- 6.56 MPa), and storage in ethanol (rinsed, 9.04 +/- 5.61 MPa; not rinsed, 9.08 +/- 3.5 MPa) and dry (8.34 +/- 3.80 MPa) produced significantly lower bond strengths. No difference was found between the other modes of storage or rinsing. The adhesive remnant index values showed no statistically significant difference between any groups.

Conclusions: For bond strength studies, storage media can have an effect on bond strength results. Dry, formalin, and ethanol storage should be avoided. Water, isotonic saline solution, and chloramine T storage produced comparable bond strengths. Rinsing or not rinsing had no effect on bond strength with these storage media.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.ajodo.2007.07.028DOI Listing

Publication Analysis

Top Keywords

storage media
24
bond strength
24
bond strengths
12
storage
10
bond
9
media bond
8
orthodontic brackets
8
10% formalin
8
isotonic saline
8
saline solution
8

Similar Publications

Objective: This study investigated the fungal contamination profile of cocoa beans from cocoa-growing regions in Ghana, with particular emphasis on the potential impact of ochratoxigenic species.

Methods: A total of 104 fermented and dried cocoa beans were randomly collected from farmers for analysis. Fungal isolation was conducted using potato dextrose agar and malt extract agar media.

View Article and Find Full Text PDF

Strong coupling FeVO nanoparticles/3D N-doped interconnected porous carbon derived from MOFs by confined adsorption-assembly-pyrolysis for greatly boosting oxygen reduction.

J Colloid Interface Sci

January 2025

Key Laboratory of the Ministry of Education for Advanced Catalysis Materials, College of Chemistry and Materials Science, College of Geography and Environmental Sciences, Zhejiang Normal University, Jinhua 321004 PR China. Electronic address:

Low-cost and effective electrocatalysts are critical for energy storage and conversion. Herein, iron(III) and vanadium(III) acetylacetonates were first adsorbed and confined in porous zeolitic imidazolate framework-8 (ZIF-8), which further cross-linked together by the methanol-induced-assembly. Following the pyrolysis, the FeVO nanoparticles were efficiently encapsulated within three-dimensional (3D) N-doped interconnected porous carbon, termed FeVO/NIPC.

View Article and Find Full Text PDF

Peptides are widely used in biomaterials due to their ease of synthesis, ability to signal cells, and modify the properties of biomaterials. A key benefit of using peptides is that they are natural substrates for cell-secreted enzymes, which creates the possibility of utilizing cell-secreted enzymes for tuning cell-material interactions. However, these enzymes can also induce unwanted degradation of bioactive peptides in biomaterials, or in peptide therapies.

View Article and Find Full Text PDF

Sub-cellular organelle anomalies are frequently observed in diseases such as cancer. Early and precise diagnosis of these alterations can be crucial for patient outcomes. However, current diagnostic tools using conventional organic dyes or metal quantum dots face limitations, including poor biocompatibility, stringent storage conditions, limited solubility in aqueous media, and slow staining speeds.

View Article and Find Full Text PDF

Prospects of cowpea protein as an alternative and natural emulsifier for food applications: Effect of pH and oil concentration.

Int J Biol Macromol

January 2025

Department of Food Engineering and Technology, Institute of Biosciences, Humanities and Exact Sciences, São Paulo State University (UNESP), Street Cristóvão Colombo, 2265, São José do Rio Preto 15054-000, Brazil. Electronic address:

In response to the growing need to expand the knowledge base on novel, more sustainable protein sources, this study investigated the effectiveness of cowpea protein concentrate (CPC) as a natural emulsifying agent, examining the relationships between pH (3-11), oil concentration (2-10 %), and emulsion stability. pH and oil concentration significantly impacted droplet size distribution, with uniformity decreasing in the order of pH 9 > pH 11 > pH 7, which was attributed to droplet coalescence and flocculation. As evidenced by circular dichroism, alkalinity induced a slight increase in the beta-sheet content of CPC, while simultaneously reducing the alpha-helix content.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!