Effects of surface texture and etching time on roughness and bond strength to ground enamel.

J Contemp Dent Pract

Dental Research and Graduate Studies, Division of the Department of Restorative Dentistry, Faculty of Dentistry, Guarulhos University, SP, Brazil.

Published: July 2009

Aim: The aim of this study was to assess the influence of surface texture and etching technique on surface roughness (Ra) and bond strength (BS) to enamel and to determine if a correlation exists between them.

Methods And Materials: Fifty enamel blocks were either roughened with 600-grit SiC paper or polished with diamond pastes. After establishing ten test groups (n=5), the initial Ra measurements, rough (R) and smooth (S) enamel surfaces were etched according to the following protocols: Group 1(R)/Group 2(S)- 35% phosphoric acid gel (H3PO4) for 15 seconds; Group 3(R)/Group 4(S)- 35% H3PO4 for 60 seconds; Group 5(R)/Group 6(S)- Clearfil SE Bond primer for 20 seconds; Group 7(R)/Group 8(S)- self-etching primer (SEP) for 60 seconds; Group 9(R)/Group 10(S)- 35% H3PO4 for 15 seconds + SEP for 20 seconds. After treatments, a new Ra measurement was performed and enamel surfaces were bonded with either Single Bond (Group 1 to Group 4) or Clearfil SE Bond (Group 5 to Group 10). Afterwards, specimens were prepared for the microtensile test. Ra values were analyzed using repeated-measures analysis of variance (ANOVA) and the BS values were analyzed using a two-way ANOVA and Tukey test (5%). Correlation between BS and Ra values was assessed using the Pearson's test.

Results: The application of SEP produced the lowest Ra values. No significant difference was detected between the BS values of polished and rough surfaces. No correlation was observed between Ra and BS values. Even though etching enamel with the SEP resulted in a surface with less roughness, similar BS values were observed for both self-etching and etch-and-rinse techniques.

Conclusion: Within the limits of this study increasing the etching time or combining both etching techniques failed to improve the BS using SEP or etch-and-rinse systems.

Clinical Significance: Based on the findings of this study, there is no clinical justification for increasing the etching time or for combining the use of a SEP following the use of a 35% H3PO4 etchant to achieve a greater BS to ground enamel.

Download full-text PDF

Source

Publication Analysis

Top Keywords

seconds group
16
etching time
12
h3po4 seconds
12
35% h3po4
12
group
9
surface texture
8
texture etching
8
roughness bond
8
bond strength
8
ground enamel
8

Similar Publications

In this paper, we studied the diffusion characteristics and distribution patterns of gas leakage in soil from buried natural gas pipelines. The three-dimensional simulation model of buried natural gas pipeline leakage was established using Fluent software. Monitoring points of gas leakage mole fraction were set up at different locations, and the influence of buried depth and pressure factors on the mole fraction and diffusion of leaked gas was analyzed.

View Article and Find Full Text PDF

Cuproptosis, a newly identified form of cell death, has drawn increasing attention for its association with various cancers, though its specific role in colorectal cancer (CRC) remains unclear. In this study, transcriptomic and clinical data from CRC patients available in the TCGA database were analyzed to investigate the impact of cuproptosis. Differentially expressed genes linked to cuproptosis were identified using Weighted Gene Co-Expression Network Analysis (WGCNA).

View Article and Find Full Text PDF

Robust multi-source geographic entities matching by maximizing geometric and semantic similarity.

Sci Rep

December 2024

Department of Geographic Information System, Chinese Academy of Surveying and mapping, Beijing, 100036, China.

Geographic entity matching is an important means for multi-source spatial data fusion and information association and sharing. Corresponding matching methods have been designed by existing studies for different types of entity data characteristics, such as line and area. However, these approaches are often limited in the generalization ability for matching heterogeneous data from multiple sources and the accuracy for complex pattern matching.

View Article and Find Full Text PDF

Limited whole genome sequencing (WGS) studies in Asian populations result in a lack of representative reference panels, thus hindering the discovery of ancestry-specific variants. Here, we present the South and East Asian reference Database (SEAD) panel ( https://imputationserver.westlake.

View Article and Find Full Text PDF

Steering acidic oxygen reduction selectivity of single-atom catalysts through the second sphere effect.

Nat Commun

December 2024

Center of Artificial Photosynthesis for Solar Fuels and Department of Chemistry, School of Science, Westlake University, Hangzhou, China.

Natural enzymes feature distinctive second spheres near their active sites, leading to exquisite catalytic reactivity. However, incumbent synthetic strategies offer limited versatility in functionalizing the second spheres of heterogeneous catalysts. Here, we prepare an enzyme-mimetic single Co-N atom catalyst with an elaborately configured pendant amine group in the second sphere via 1,3-dipolar cycloaddition, which switches the oxygen reduction reaction selectivity from the 4e to the 2e pathway under acidic conditions.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!