This paper reports corrections and improvements of the previously reported direct force balance method (DFBM) developed for lateral calibration of atomic force microscopy. The DFBM method employs the lateral force signal obtained during a force-distance measurement on a sloped surface and relates this signal to the applied load and the slope of the surface to determine the lateral calibration factor. In the original publication [Rev. Sci. Instrum. 77, 043903 (2006)], the tip-substrate contact was assumed to be pinned at the point of contact, i.e., no slip along the slope. In control experiments, the tip was found to slide along the slope during force-distance curve measurement. This paper presents the correct force balance for lateral force calibration.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1063/1.3142243 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Elucidation of the interaction between apo-transferrin and indisulam via multi-spectroscopic techniques and molecular modeling.
Spectrochim Acta A Mol Biomol Spectrosc
December 2024
School of Chemistry and Chemical Engineering, Nanchang University, Nanchang 330031, Jiangxi, China. Electronic address:
Apo-transferrin (apo-TRF) is a vital protein for maintaining iron balance in the body, which is produced by the liver. Indisulam (IDM) has been extensively used to treat cancer in clinical study and has been identified as a molecular glue. Iron imbalances in the body are believed to encourage the growth and spread of cancer cells.
View Article and Find Full Text PDFPedicle Screw Pull-Out Strength Between the Jamshidi Needle and Pedicle Probe Techniques in an Osteoporotic Cancellous Bone Model: A Biomechanical Study.
Cureus
November 2024
Aerospace Engineering, Universiti Putra Malaysia, Kuala Lumpur, MYS.
Introduction Spinal fusion surgery with pedicle screws is commonly performed to stabilize the spine of osteoporotic patients. However, securing a strong screw fixation in osteoporotic bone presents significant challenges due to the reduced bone density. This study aimed to compare the biomechanical performance in an osteoporotic bone model of pedicle screws inserted using two different techniques, the Jamshidi needle technique and the pedicle probe technique, as well as the influence of tapping on both these techniques.
View Article and Find Full Text PDFHigh sacral slope, lumbar lordosis, and sacral slope-to-pelvic incidence ratio are associated with new bone formation in ankylosing spondylitis.
Turk J Med Sci
December 2024
Department of Rheumatology, Faculty of Medicine, Marmara University, İstanbul, Turkiye.
Background/aim: Syndesmophyte formation appears to be site-specific in ankylosing spondylitis (AS) and new bone formation seems to occur in regions of microtrauma that are prone to tensile forces. Pelvic and spinal parameters are unique for each individual. Pelvic tilt and sacral slope are important anatomical features that compensate in harmony in keeping the sagittal balance.
View Article and Find Full Text PDFProposal for a quantum mechanical test of gravity at millimeter scale.
Sci Rep
December 2024
Tsung-Dao Lee Institute and School of Physics and Astronomy, Shanghai Jiao Tong University, Shanghai, China.
The experimental verification of the Newton law of gravity at small scales has been a longstanding challenge. Recently, torsion balance experiments have successfully measured gravitational force at the millimeter scale. However, testing gravity force on quantum mechanical wave function at small scales remains difficult.
View Article and Find Full Text PDFThe time-course changes in postural control variability between neck pain and asymptomatic dental students.
Sci Rep
December 2024
Neuromuscular Research Lab, Interdisciplinary Centre for the study of Human Performance (CIPER), Faculty of Human Kinetics, University of Lisbon, 1499-002, Oeiras, Portugal.
Changes in postural control associated with clinical practice or specific conditions such as the presence of neck pain remain unexplored in dental students. Therefore, this study aimed to explore the time-course changes in postural control complexity among dental students enrolled in clinical practice, comparing those with and without neck pain. We used an online Nordic Musculoskeletal Questionnaire for group allocation and center of pressure (CoP) oscillations with a tri-axial Bertec force plate.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!