Dunaliella salina could survive in media containing a wide range of NaCl concentrations ranging from about 0.05 M to saturation (around 5.5 M). Glycerol is an important osmolyte when Dunaliella survive in various salt environments, and G3pdh is a key enzyme in glycerol metabolism. The osmotic response of D. salina was investigated by studying its cell growth, glycerol content change, and isozyme activity of glycerol-3-phosphate dehydrogenase (G3pdh) in different salinities. Results showed that 2.0 M NaCl was the optimal salinity for the growth of D. salina, in which condition the highest glycerol content of 64.02 +/- 3.21 (mean +/- SD) microg/mL was detected. D. salina could rapidly increase or decrease glycerol contents to adapt to hypoosmotic or hyperosmotic environments. The glycerol content declined 52.05% when salinity was changed from 2.0 to 0.5 M NaCl, and the glycerol content increased 43.61% when salinity was increased from 2.0 to 5.0 M NaCl. In the isozyme electrophoresis assay two kinds of isozymes, G3pdh and superoxide dismutase (Sod), were detected synchronously. Interestingly, it was first found that there are five isozymes of G3pdh in D. salina. G3pdh-2 mainly takes effect in moderate to high salinities, whereas the other four isozymes take effect in low salinities, which may provide an important clue for future research on osmoregulation mechanisms.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1021/jf900447r | DOI Listing |
Polymers (Basel)
December 2024
State Key Laboratory of Organic-Inorganic Composites, Beijing Laboratory of Biomedical Materials, College of Life Science and Technology, Beijing University of Chemical Technology, Beijing 100029, China.
A series of polyurethanes (PU-GT) were prepared using polyglycolide-block-polytetrahydrofuran-block-polyglycolide (PGA-PTHF-PGA), polytetrahydrofuran homopolymer (PTHF), glycerol, and hexamethylene diisocyanate (HDI) by a one-pot synthesis method. The non-isothermal crystallization and subsequent heating curves showed that the PTHF component in these polyurethanes could crystallize in a temperature range of -11.5~2.
View Article and Find Full Text PDFPolymers (Basel)
December 2024
N.N. Semenov Federal Research Center for Chemical Physics Russian Academy of Sciences, 119991 Moscow, Russia.
Glycerol-(9,10-trioxolane) trioleate (OTOA) is a promising material that combines good plasticizing properties for PLA with profound antimicrobial activity, which makes it suitable for application in state-of-the-art biomedical and packaging materials with added functionality. On the other hand, application of OTOA in PLA-based antibacterial materials is hindered by a lack of knowledge on kinetics of the OTOA release. In this work, the release of glycero-(9,10-trioxolane) trioleate (OTOA) from PLA films with 50% OTOA content was studied during incubation in normal saline solution, and for the first time, the kinetics of OTOA release from PLA film was evaluated.
View Article and Find Full Text PDFMolecules
December 2024
Department of Inorganic Chemistry, Institute of Chemical Sciences, Faculty of Chemistry, Maria Curie-Sklodowska University in Lublin, Maria Curie-Sklodowska Sq. 3, 20-031 Lublin, Poland.
Hydrophobization could improve the moisture resistance of biopolymer-based materials, depending on the methods and materials used, providing benefits for packaging applications. The aim of this study was to compare the effect of increasing concentrations (0-2.0%) of candelilla wax (CW) and oleic acid (OA) on the structural and physicochemical properties, including water affinity, of glycerol-plasticized pea protein isolate (PPI) films.
View Article and Find Full Text PDFInt J Mol Sci
December 2024
Department of Wood Science and Thermal Techniques, Faculty of Forestry and Wood Technology, Poznan University of Life Sciences, ul. Wojska Polskiego 38/42, 60-637 Poznan, Poland.
This research investigated the selected properties of nanocellulose films intended to serve as protective patches on fissured surfaces of wooden artefacts. The effects of their plasticisation with glycerol and functionalisation with selected silanes ((3-Glycidyloxypropyl)trimethoxysilane, and Methyltrimethoxysilane) were also determined. The obtained pure cellulose nanopapers (CNPs) had a homogeneous and compact structure but were very brittle, stiff, and wavy.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!