New tailormade BODIPY dyes have been synthesized by a simple protocol to reach wavelength finely tunable laser action from 540 to 625 nm while maintaining highly efficient and photostable laser emission. The new dyes are analogues of the commercial dye PM597 with the eight position free (PTH8) or substituted by the groups acetoxymethyl (PTAlk) or p-acetoxymethylphenyl (PTAr). The photophysical properties strongly depend on the geometrical distortion from planarity of the indacene core generated by the presence of the bulky 2,6-di-tert-butyl groups and the eight substituent. In both liquid and polymeric solid solutions, lasing efficiencies of up to 63 and 48%, respectively, were observed under transversal pumping at 532 nm with high photostabilities. In the case of PTAlk incorporated into silicon-containing solid organic matrices, the laser emission remained at 92% of its initial intensity value after 100,000 pumping pulses in the same position of the sample at 30 Hz repetition rate. The laser action of the new dyes enhances that of the parent dye PM597 and outperforms the lasing behavior of dyes considered to be benchmarks over the green-yellow to red spectral region.

Download full-text PDF

Source
http://dx.doi.org/10.1021/jp902734mDOI Listing

Publication Analysis

Top Keywords

dye pm597
12
laser action
8
laser emission
8
analogues bodipy
4
bodipy dye
4
pm597 photophysical
4
photophysical lasing
4
lasing properties
4
properties liquid
4
liquid solutions
4

Similar Publications

Lasing in an assembled array of silver nanocubes.

Nanoscale Horiz

December 2024

Institute of Materials Science, Kaunas University of Technology, K. Baršausko St. 59, Kaunas LT-51432, Lithuania.

We demonstrate a surface lattice resonance (SLR)-based plasmonic nanolaser that leverages bulk production of colloidal nanoparticles and assembly on templates with single particle resolution. SLRs emerge from the hybridization of the plasmonic and photonic modes when nanoparticles are arranged into periodic arrays and this can provide feedback for stimulated emission. It has been shown that perfect arrays are not a strict prerequisite for producing lasing.

View Article and Find Full Text PDF

Random lasers are highly configurable light sources that are promising for imaging and photonic integration. In this study, random lasing action was generated by optically pumping N-(4-methoxybenzylidene)-4-butylaniline (MBBA) liquid crystals infiltrated with gold nanoparticles and a laser dye (pyrromethene 597 (PM597)). By varying the pump energy near a lasing threshold, we show that it is possible to control intensity correlations between random lasing modes.

View Article and Find Full Text PDF

Surfactant mediated suppression of aggregation and excited state ring puckering process in Pyrromethene 597-Application in water based dye laser.

Spectrochim Acta A Mol Biomol Spectrosc

December 2022

Radiation & Photochemistry Division, Bhabha Atomic Research Centre, Trombay, Mumbai 400 085, India; Homi Bhabha National Institute, Anushaktinagar, Mumbai 400 094, India. Electronic address:

Water is being considered as an economical, safe and environmental friendly alternative solvent for dye lasers. However, the use of water in dye laser is restricted due to the formation of non-emissive aggregates of dye molecules. In the present study we have explored the possibility of the use of commercially available surfactant molecules for the water based laser of Pyrromethene 597 (PM597) dye, which has emerged as an alternative for more commonly used Rhodamine dyes in dye laser systems.

View Article and Find Full Text PDF

Fluorescence Anisotropy Studies on Bodipy (Pyrromethene 546) Dye as a Novel Thermal Probe.

J Fluoresc

March 2022

Department of Mechanical Engineering, Faculty of Engineering, Tokyo University of Science, 6-3-1, Niijuku, Katsushika-ku, Tokyo, 125-8585, Japan.

In the present work, fluorescence anisotropy studies of BODIPY (pyrromethene 546 or CHBFN) dye have been performed and found that it has a potential to be used as a thermal probe to measure the temperature of microfluid. It is well-known that a dye rotates in its excited state, so to control the molecular rotation of the dye in the excited state, sorbitol is used in the solution. It has been found that adding sorbitol, fluorescence anisotropy increases, fluorescence lifetime decreases.

View Article and Find Full Text PDF

The fluorescence spectra of dye solutions change their spectral signature with temperature. This effect is frequently used for temperature imaging in liquids and sprays based on two-color laser-induced fluorescence (2cLIF) measurements by simultaneously detecting the fluorescence intensity in two separate wavelength channels resulting in a temperature-sensitive ratio. In this work, we recorded temperature-dependent absorption and fluorescence spectra of solutions of five laser dyes (coumarin 152, coumarin 153, rhodamine B, pyrromethene 597, and DCM) dissolved in ethanol, a 35/65 vol.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!