Several different compositions of tellurium-thallium oxide glasses were fabricated and tested for their Raman gain performance. The addition of PbO to the glass matrix increased the surface optical damage threshold by 60-230%. The maximum material Raman gain coefficient experimentally obtained was (58 +/- 3) times higher than the peak Raman gain of a 3.18 mm thick Corning 7980-2F fused silica sample (Deltanu = 13.2 THz). The highest peak in the Raman gain spectrum of the tellurium-thallium glass is attributed to the presence of TeO3 and TeO3+1 structural units with thallium ions in the vicinity at a frequency shift near 21.3 THz.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1364/opex.13.001144 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Engineering of Cd Zn S Nanomaterials for Fabrication of Hybrid Cd Zn S/Si Heterojunction Broadband Photo Detectors.
ACS Omega
January 2025
Department of Physics, Government General Degree College Gopiballavpur-II, Jhargram 721517, India.
Effective engineering of nanostructured materials provides a scope to explore the underlying photoelectric phenomenon completely. A simple cost-effective chemical reduction route is taken to grow nanoparticles of Cd Zn S with varying = 1, 0.7, 0.
View Article and Find Full Text PDFBeyond conventional characterization: Defect engineering role for sensitivity and selectivity of room-temperature UV-assisted graphene-based NO₂ sensors.
Talanta
January 2025
Instituto de Magnetismo Aplicado, UCM-ADIF, Las Rozas, 28230, Spain; Departamento de Física de Materiales, Universidad Complutense de Madrid (UCM), 28040, Madrid, Spain. Electronic address:
The term graphene-based gas sensors may be too broad, as there are many physicochemical differences within the graphene-based materials (GBM) used for chemiresistive gas sensors. These differences condition the sensitivity, selectivity, recovery, and ultimately the sensing performance of these devices towards air pollutants. Continuous ultraviolet irradiation aids in the desorption of gas molecules and enhances sensor performance.
View Article and Find Full Text PDFEnergy-level rich nanorings hybridizing Ag, Au and AgCl as high-performance SERS substrate for numerous molecules.
Talanta
January 2025
MOE Key Laboratory for Analytical Science of Food Safety and Biology, College of Chemistry, Fuzhou University, Fuzhou, China. Electronic address:
The current surface-enhanced Raman scattering (SERS) substrates typically feature a single energy level, posing challenges in coordinating electromagnetic enhancement (EM) and chemical enhancement (CM), thereby limiting the sensitive detection of numerous crucial target molecules. In this study, novel aggregated nanorings (a-NRs) hybridizing Ag, Au and AgCl are constructed as SERS substrates. On one hand, the obtained a-NRs exhibit robust localized surface plasmon resonance absorption, whose wavelength can be tuned to match three commonly used laser wavelengths (532, 633 and 785 nm) to gain strong EM effect.
View Article and Find Full Text PDFHydrogen Bonding Polarization Strengthening the Peptide-Based Hydrogels.
J Phys Chem B
January 2025
Research Institute of Interdisciplinary Science & School of Materials Science and Engineering, Dongguan University of Technology, Dongguan 523808, China.
Peptide-based hydrogels form a kind of promising material broadly used in biomedicine and biotechnology. However, the correlation between their hydrogen bonding dynamics and mechanical properties remains uncertain. In this study, we found that the adoption of β-sheet and α-helix secondary structures by ECF-5 and GFF-5 peptides, respectively, could further form fiber networks to immobilize water molecules into hydrogels.
View Article and Find Full Text PDFRaman microscopy of the Cu/LiAlGe(PO) solid electrolyte interphase.
Chem Commun (Camb)
January 2025
Energy Storage and Distributed Resources Division, Lawrence Berkeley National Laboratory, Berkeley, California 94720, USA.
LiAlGe(PO) (LAGP) is a promising solid-state electrolyte (SSE) for solid-state batteries but suffers from side reactions with Li metal resulting in cracking and interfacial resistance rise which hinders its practical application. Herein, in operando Raman spectroscopy was performed to gain insights into local chemical and structural transformations of the Cu/LAGP interface during cathodic polarization.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!