Vertical indium phosphide nanowires have been grown epitaxially on silicon (111) by metalorganic vapor-phase epitaxy. Liquid indium droplets were formed in situ and used to catalyze deposition. For growth at 350 degrees C, about 70% of the wires were vertical, while the remaining ones were distributed in the 3 other <111> directions. The vertical fraction, growth rate, and tapering of the wires increased with temperature and V/III ratio. At 370 degrees C and V/III equal to 200, 100% of the wires were vertical with a density of approximately 1.0 x 10(9) cm(-2) and average dimensions of 3.9 mum in length, 45 nm in base width, and 15 nm in tip width. X-ray diffraction and transmission electron microscopy revealed that the wires were single-crystal zinc blende, although they contained a high density of rotational twins perpendicular to the <111> growth direction. The room temperature photoluminescence spectrum exhibited one peak centered at 912 +/- 10 nm with a FWHM of approximately 60 nm.

Download full-text PDF

Source
http://dx.doi.org/10.1021/nl803567vDOI Listing

Publication Analysis

Top Keywords

vertical indium
8
indium phosphide
8
phosphide nanowires
8
wires vertical
8
vertical
5
self-catalyzed epitaxial
4
growth
4
epitaxial growth
4
growth vertical
4
nanowires silicon
4

Similar Publications

Transparent energy-saving windows based on broadband directional thermal emission.

Nanophotonics

March 2024

School of Electrical Engineering and Computer Science, Gwangju Institute of Science and Technology (GIST), Cheomdangwagi-ro 123, Buk-gu, Gwangju 61005, Republic of Korea.

Article Synopsis
  • * The new directional radiative cooling glass (DRCG) uses a multilayer structure with specific materials to efficiently release heat by controlling the angles of thermal emissions.
  • * The DRCG has been shown to lower temperatures by over 1.5°C in hot urban settings and improves space-cooling performance as a window, contributing to the fight against urban heat islands.
View Article and Find Full Text PDF

Manipulation of trions to enhance the excitonic emission in monolayer p-MoS and its hetero-bilayer by reverse charge injection.

Nanoscale

December 2024

Department of Physics, BITS-Pilani K. K. Birla Goa Campus, Zuarinagar, Goa-403726, India.

Monolayer 2D transition metal dichalcogenides (TMDs) are known for their direct bandgaps and pronounced excitonic effects, which facilitate efficient light absorption and high photoluminescence (PL). In this study, we report a significant enhancement in PL emission from monolayers of p-type molybdenum disulfide (p-MoS), fabricated on conductive substrates-such as indium tin oxide (ITO) and gold (Au). We attribute this behaviour to the reverse injection of charge carriers from substrates to p-MoS and the subsequent localization of electrons and holes in the substrate and p-MoS, respectively.

View Article and Find Full Text PDF

Nanochannel confined graphene quantum dots/platinum nanoparticles boosts electrochemiluminescence of luminal-O system for sensitive immunoassay.

Talanta

November 2024

General Surgery, Cancer Center, Department of Gastrointestinal and Pancreatic Surgery, Zhejiang Provincial People's Hospital, Hangzhou Medical College, Hangzhou 310014, China. Electronic address:

Sensitive detection of tumor biomarkers is of great significance for early cancer diagnosis, treatment evaluation, and recurrence monitoring. Development of convenient electrochemiluminescence (ECL) immunosensor using dissolved oxygen (O) as an endogenous co-reactant of luminol combined with efficient nanocatalysts to boost ECL signal in neutral media is highly desirable. Herein, sensitive detection of tumor biomarker using ECL of luminal-O enhanced by confinement of nitrogen-doped graphene quantum dots (N-GQDs) and platinum nanoparticles (PtNPs) on nanochannel array was demonstrated.

View Article and Find Full Text PDF

Single vertical InP nanowire diodes with low ideality factors contacted in-array for high-resolution optoelectronics.

Nanotechnology

December 2024

Division of Synchrotron Radiation Research and NanoLund, Department of Physics, Lund University, Box 118, 22100 Lund, Sweden.

Nanowire (NW) optoelectronic and electrical devices offer unique advantages over bulk materials but are generally made by contacting entire NW arrays in parallel. In contrast, ultra-high-resolution displays and photodetectors require electrical connections to individual NWs inside an array. Here, we demonstrate a scheme for fabricating such single NW vertical devices by contacting individual NWs within a dense NW array.

View Article and Find Full Text PDF

Here, we introduce an optically transparent and flexible metasurface designed for effective absorption within the microwave spectrum. Indium tin oxide (ITO) films with varying square resistances fabricate a metasurface ground layer and a lossy pattern layers. Polydimethylsiloxane (PDMS) with a low refractive index, high transparency, and high flexibility is chosen as the dielectric layer.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!