The crystal structure of the single-component molecular metal [Au(tmdt)(2)] was examined at pressures up to 10.7 GPa in order to examine whether the high-pressure structure reflects the crystal's metallic nature. Crystal structure analyses were performed at 0.2, 0.8, 1.3, 3.0, 5.5, and 10.7 GPa on the basis of the powder X-ray diffraction data obtained by using the synchrotron radiation source SPring-8. The unit cell volume at 10.7 GPa was approximately 75% of the initial volume, indicating that [Au(tmdt)(2)] is a 'soft material' like a typical molecular crystal in spite of its metallic nature. The pressure dependences of the bond lengths of the Au(tmdt)(2) molecule were found to be approximately 1 order of magnitude smaller than those of the intermolecular atomic distances. These results seem to justify the commonly accepted conjecture that the molecule usually behaves almost like a rigid body up to a fairly high pressure. It was found that the anisotropy of the lattice compression of the insulating I(2) crystal below 20 GPa can be essentially interpreted on the basis of a very simple 'interatomic repulsion model', which assumes that the molecules in the crystal are packed such that as far as possible, an increase in the interatomic repulsions between neighboring molecules is avoided. However, the maximum decrease in the intermolecular distance in [Au(tmdt)(2)] was observed along the a direction although there were many intermolecular S...S contacts shorter than the van der Waals distance (3.70 A) along this direction. The shortest intermolecular S...S distance was 2.73 A at 10.7 GPa, which is approximately 1 A shorter than the S...S van der Waals distance (3.70 A). The crystal lattice of [Au(tmdt)(2)] is considered to be stabilized by the enhancement of the intermolecular overlapping of the conduction molecular orbitals having large amplitudes on peripheral S atoms. Although the crystal is composed of 'isolated molecules' like a typical insulating molecular crystal, its compressibility behavior seems to reflect its metallic nature.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1021/ja9010018 | DOI Listing |
Int J Biol Macromol
January 2025
Beijing Key Laboratory of Lignocellulosic Chemistry, Beijing Forestry University, Beijing 100083, China; State Key Laboratory of Efficient Production of Forest Resources, Beijing Forestry University, Beijing 100083, China. Electronic address:
Due to the emphasis on the environmental and health issues caused by petroleum-based plastics, renewable lignocellulosic materials emerge as promising substitutes. However, their practical application remains hindered by unsatisfactory properties such as fragility and sensitivity to water. Dealing with the challenge of non-thermal processing of xylan and addressing the issue of performance degradation resulting from the hygroscopicity of materials.
View Article and Find Full Text PDFNanomaterials (Basel)
December 2024
School of Intelligent Manufacturing, Luoyang Institute of Science and Technology, Luoyang 471023, China.
(AlCrMoNiTi)N high-entropy alloy nitride (HEAN) films were synthesized at various bias voltages using the co-filter cathodic vacuum arc (co-FCVA) deposition technique. This study systematically investigates the effect of bias voltage on the microstructure and performance of HEAN films. The results indicate that an increase in bias voltage enhances the energy of ions while concomitantly reducing the deposition rate.
View Article and Find Full Text PDFNanomaterials (Basel)
December 2024
School of Power & Mechanical Engineering, Wuhan University, Wuhan 430072, China.
TiZrMoC coatings were deposited on Si(100) substrates using a DC dual magnetron sputtering. The composition was controlled by adjusting the sputtering parameters of the TiZrMo and graphite targets. The influence of graphite target current on the resulting coating properties was explored.
View Article and Find Full Text PDFAllergol Select
November 2024
Department of Dermatology and Allergy Biederstein, School of Medicine and Health, Technical University of Munich TUM).
Background: Anaphylaxis is a systemic allergic reaction that is potentially life-threatening. Occupational anaphylaxis is an anaphylaxis that occurs in an occupational context. In this position paper, we propose diagnostic criteria for occupational anaphylaxis and provide an overview of the current state of knowledge in terms of prevalence, triggers, prevention, and management.
View Article and Find Full Text PDFAngew Chem Int Ed Engl
November 2024
Polymer Synthesis Laboratory, Chemistry Program, KAUST Catalysis Center, Physical Sciences and Engineering Division, King Abdullah University of Science and Technology (KAUST), 23955, Thuwal, Saudi Arabia.
This study introduces a novel approach to inverse vulcanization by utilizing a commercially available triaziridine crosslinker as an alternative to conventional olefin-based crosslinkers. The model reactions reveal a self-catalyzed ring-opening of "unactivated" aziridine with elemental sulfur, forming oligosulfide-functionalized diamines. The triaziridine-derived polysulfides exhibit impressive mechanical properties, achieving a maximum stress of ~8.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!