Balance between Coulombic interactions and physical confinement in silica hydrogel encapsulation.

J Phys Chem B

Department of Chemistry and Biochemistry, University of Oklahoma, Norman, Oklahoma 73019, USA.

Published: April 2009

We examined the behavior of various entrapped guest molecules within silica hydrogel and evaluated the effect of Coulombic interactions and physical confinement on molecular mobility. Although rhodamine 6G (R6G) and fluorescein (FL) share similar size and molecular structure, their behavior in silica hydrogel was found to be dramatically different. A good majority of R6G was immobilized with little to no exchangeable molecules, whereas FL displayed a considerable amount of mobility in silica hydrogel. Moreover, silica hydrogel encapsulated R6G failed to gain mobility even under low pH or high ionic strength conditions to minimize Coulombic interactions, implying that encapsulated R6G molecules were inaccessible and likely trapped deep inside the silica matrix of a hydrogel. On the contrary, FL was relatively free to rotate and translate inside a silica hydrogel, implying that FL remained solvated in the solvent phase and was able to maintain its mobility throughout the hydrogel formation process. Fluorescence recovery after photobleaching measurements put the diffusion coefficient of FL in silica hydrogel at ca. 2.1 x 10(-6) cm(2) s(-1), about a factor of 3 slower than that in solution. The substantial difference in mobility between cationic R6G and anionic FL led us to conclude that the effect of Coulombic interactions on mobility is more dominating in hydrogel than in alcogel. Our results also suggest that Coulombic interactions are strong enough to influence the eventual placement of a guest molecule in a silica hydrogel, causing R6G and FL to reside in different microenvironments. This has a profound implication on the use of molecular probes to study silica hydrogel since a slight difference in physical attribute may result in very diverse observations even from identically prepared silica hydrogel samples. As demonstrated, the repulsion between FL and silica renders FL liquid-bound, making FL more suitable for monitoring the change in viscosity and physical confinement during hydrogel formation, whereas other researchers have shown that silica-bound R6G is more suitably used as a reliable probe for monitoring the growth of silica colloids because of its strong attraction toward silica.

Download full-text PDF

Source
http://dx.doi.org/10.1021/jp8036473DOI Listing

Publication Analysis

Top Keywords

silica hydrogel
40
coulombic interactions
20
silica
14
hydrogel
14
physical confinement
12
interactions physical
8
encapsulated r6g
8
inside silica
8
hydrogel formation
8
r6g
7

Similar Publications

In this study, we developed a novel composite catalytic hydrogel, which integrates excellent mechanical properties, catalytic activity, and sensing performance. Discarded hydrogel sensors are reused as templates for in-situ generation of metal nanoparticles, and multifunctional hydrogels combining sensing and catalysis are realized. Polyacrylamide (PAM) provides a three-dimensional network structure, while octadecyl methacrylate (SMA) acts as a hydrophobic association center, enhancing the structural stability of the hydrogel.

View Article and Find Full Text PDF

The application of nanocomposites based on polyacrylamide hydrogels as well as silica nanoparticles in various tasks related to the petroleum industry has been rapidly developing in the last 10-15 years. Analysis of the literature has shown that the introduction of nanoparticles into hydrogels significantly increases their structural and mechanical characteristics and improves their thermal stability. Nanocomposites based on hydrogels are used in different technological processes of oil production: for conformance control, water shutoff in production wells, and well killing with loss circulation control.

View Article and Find Full Text PDF

Conventional wearable flexible sensing systems typically comprise three components: a flexible substrate that contacts the skin, a signal processing module, and a signal output module. These components function relatively independently, resulting in a complex system that lacks sufficient integration. Therefore, developing an integrated wearable flexible sensing system by combining the flexible substrate, the signal processing module, and the signal output module not only enhances performance and comfort, but also reduces manufacturing costs and the risk of failure.

View Article and Find Full Text PDF

Synthesis of potential adsorbent for removal of malachite green dye using alginate hydrogel nanocomposites.

Int J Biol Macromol

December 2024

Department of Chemistry, Division of Science and Technology, University of Education, College Road, Lahore, Pakistan. Electronic address:

Hydrogels are highly porous, hydrophilic, insoluble, 3D networks with a large capacity for water absorption. The goal of this research was to formulate sodium alginate/silica (SA/SiO) hydrogel and hydrogel nanocomposite (SA/SiO/ZnO-NPs) by impregnating the ZnO-NPs and cross-linking was furnished with siloxane network making use of the sol-gel method. The synthesized hydrogel/hydrogel nanocomposite was analyzed with Fourier transform infrared spectroscopy (FTIR), X-ray diffraction (XRD), Zeta-sizer, scanning electron microscopy (SEM), transmission electron microscopy (TEM) and thermo-gravimetric analyzer (TGA).

View Article and Find Full Text PDF

Unilateral antibacterial Janus hydrogel hemostatic dressing prepared by the dragging effect of a brush.

Colloids Surf B Biointerfaces

December 2024

College of Chemistry and Materials Science, Fujian Normal University, Fuzhou 350007, PR China; Fujian Provincial Key Laboratory of Polymer Materials, Fujian Normal University, Fuzhou 350007, PR China. Electronic address:

Hemostasis and subsequent anti-inflammatory measures are essential for wound healing in the human body following trauma or surgical procedures. Here, we try to use the dragging effect of a brush to prepare a Janus hydrogel with the least amount of bacteriostatic agent. The synthesized suspension of polyvinylbenzene-silica@quaternary ammonium salt (PDVB-SiO@NR) Janus particles (JNPs) was selected as ink and brush coated onto one side of a polyacrylic acid (PAA) hydrogel, resulting in Janus hydrogel (JNPs≌PAA).

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!