A mass spectrometer was coupled to high-performance ligand-exchange liquid chromatography (HPLEC) for simultaneous analysis of stress associated solutes such as proline, hydroxyproline, methylproline, glycine betaine and trigonelline extracted from leaves of drought stressed oaks and an internal standard namely N-acetylproline. Methanol/chloroform/water extracts were analyzed using an Aminex HPX-87C column and specifically quantified by the positive ion mode of an electrospray ionisation-mass spectrometry (ESI-MS) in single ion monitoring (SIM) mode. The recovery of N-acetyl proline added to oak leaf extracts ranged from 85.2 to 122.1% for an intra-day study. Standard calibration curves showed good linearity in the measured range from 0.3125 to 10micromolL(-1) with the lowest correlation coefficient of 0.99961 for trigonelline. The advantages of this alternative procedure, compared to previously published methods using fluorescence or amperometric detections, are the simultaneous and direct detection of osmoprotectants in a single chromatographic run, a minimal sample preparation, a good specificity and reduced limits of quantification, ranging from 0.1 to 0.6micromolL(-1). Fifty-six days of water deficit exposure resulted in increased foliar free proline levels (2.4-fold, P<0.001, 155micromolg(-1) FW) and glycine betaine contents (2.5-fold, P<0.05, 175micromolg(-1) FW) of drought stressed oak compared to control.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.chroma.2008.12.030DOI Listing

Publication Analysis

Top Keywords

high-performance ligand-exchange
8
simultaneous measurement
4
proline
4
measurement proline
4
proline compounds
4
compounds oak
4
oak leaves
4
leaves high-performance
4
ligand-exchange chromatography
4
chromatography electrospray
4

Similar Publications

Colloidal quantum dot (CQD) near-infrared (NIR) upconversion devices (UCDs) can directly convert low-energy NIR light into higher energy visible light without the need for additional integrated circuits, which is advantageous for NIR sensing and imaging. However, the state-of-the-art CQD NIR upconverters still face challenges, including high turn-on voltage (), low photon-to-photon (p-p) upconversion efficiency, and low current on/off ratio, primarily due to inherent limitations in the device structure and operating mechanisms. In this work, we developed a CQD NIR UCD based on a hole-only injection mechanism.

View Article and Find Full Text PDF

Uncovering the Performance Enhancing Mechanism of Methanesulfonate Ligands in Perovskite Quantum Dots for Light-Emitting Devices.

ACS Appl Mater Interfaces

January 2025

Department of Physics, School of Physics and Information Engineering, Fuzhou University, Fuzhou 350108, P. R. China.

Perovskite quantum dots (PQDs) have attracted more and more attention in light-emitting diode (LED) devices due to their outstanding photoelectric properties. Surface ligands not only enable size control of quantum dots but also enhance their optoelectronic performance. However, the efficiency of exciton recombination in PQDs is often hindered by the desorption dynamics of surface ligands, leading to suboptimal electrical performance.

View Article and Find Full Text PDF

Dual-Phase Ligand Engineering Enables 18.21% FAPbI Quantum Dot Solar Cells.

Adv Mater

January 2025

Institute of Functional Nano & Soft Materials (FUNSOM), Jiangsu Key Laboratory of Advanced Negative Carbon Technologies, Soochow University, 199 Ren-Ai Road, Suzhou Industrial Park, Suzhou, Jiangsu, 215123, P. R. China.

Formamidinium lead triiodide (FAPbI) perovskite quantum dot (PQD) are promising candidate for high-performing quantum dot photovoltaic due to its narrow bandgap, high ambient stability, and long carrier lifetime. However, the carrier transport blockage and nonradiative recombination loss, originating from the high-dielectric ligands and defects/trap states on the FAPbI PQD surface, significantly limit the efficiency and stability of its photovoltaic performance. In this work, through exploring dual-site molecular ligands, namely 2-thiophenemethylammonium iodide (2-TM) and 2-thiopheneethylammonium iodide (2-TE), a dual-phase synergistic ligand exchange (DSLE) protocol consisting of both solution-phase and solid-state ligand engineering is demonstrated.

View Article and Find Full Text PDF

Inorganic ligand capped quantum dot light-emitting diodes: status and perspective.

Nanotechnology

January 2025

School of Energy and Power Engineering, Huazhong University of Science and Technology, Wuhan 430074, People's Republic of China.

Quantum dots (QDs) have shown great application potential in a variety of optoelectronic devices due to their unique optoelectronic properties, especially playing a key role in the development of quantum dot light-emitting diodes (QLEDs). Inorganic ligands, including metal or non-metal chalcogenides, oxoanions, halides, and metal cations, play crucial roles in the synthesis, stabilization, and functionalization of QDs. Compared to long-chain organic ligands, inorganic ligands are shorter and possess higher electron mobility, which facilitates their application in high-performance QLEDs.

View Article and Find Full Text PDF

Exploring the transfer ability of proton carriers at different relative humidity (RH) is vital for the rational design and development of high-performance proton exchange membranes (PEMs). However, the highly humidity-dependent transfer channel and random carrier distribution disqualify most membrane materials. Herein, a series of MIL-53 metal-organic framework (MOF) nanosheets with stable, quantifiable pore structures and different conducting groups are prepared through postsynthetic ligand exchange, followed by spin coating to assemble lamellar membranes.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!