The total hip prosthesis has evolved from the initial monoblock system developed by Charnley. Modularity of both the femoral and acetabular components, which allows the surgeon to assemble the prostheses just before or during the course of implantation, has now become standard. Modularity increases the number of implant parameter variables, allowing semicustom devices to be constructed. Component interfaces, however, are subject to significant stresses, micromotion manifesting as fretting, may produce wear debris, and at times may experience macromotion leading to catastrophic failure. We report 3 cases of stem-sleeve junction failure in otherwise uncomplicated primary total hip arthroplasties. Two of the failures occurred in the S-ROM (Joint Medical Products, Stamford, Conn) femoral stem design and the other in an Apex stem (Omni Life Science, Raynham, Mass). To our knowledge, there have been no previous reports of clinical failures at femoral stem-sleeve junction.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1016/j.arth.2008.09.006 | DOI Listing |
J Orthop Case Rep
December 2024
Department of Orthopaedics, Apollo Hospitals, Bannerghatta Road, Bengaluru, Karnataka, India.
Introduction: It is rare to encounter a patient with severe valgus deformity of the greater trochanter with severe osteoarthritis of the hip joint. The treatment, that is total hip arthroplasty (THA) in such a case presents with a surgical challenge in proper placement of the femoral stem. Traditionally, an osteotomy procedure to correct the femoral deformity was warranted followed by THA.
View Article and Find Full Text PDFJ Arthroplasty
April 2024
Department of Orthopedic Surgery, Kangbuk Samsung Hospital, Sungkyunkwan University School of Medicine, Seoul, Korea.
Background: Although the modular sleeve concept for femoral implants has several advantages, studies reporting on greater than 20-year outcomes are limited. This study aimed to report the mean 23-year results of total hip arthroplasty (THA) using a modular stem with metaphyseal fixation sleeve.
Methods: This study reviewed primary THAs performed using a modular stem between October 1994 and April 1998.
Arthroplast Today
September 2018
Hospital for Special Surgery, New York, NY, USA.
Fracture of a well-ingrown femoral component is a rare and often challenging complication. Modular junctions and sleeve interfaces have been identified as one potential point of weakness with corrosion and fretting being contributing factors to ultimate femoral component fracture. Stem fractures at the sleeve interface were reported occasionally for the proximal ingrowth modular Emperion System (Smith and Nephew, Memphis, TN).
View Article and Find Full Text PDFJ Arthroplasty
October 2017
Department of Orthopedic Surgery, Illinois Bone & Joint Institute, Morton Grove, Illinois; Department of Orthopedic Surgery, Advocate Lutheran General Hospital, Park Ridge, Illinois; Department of Orthopedic Surgery, NorthShore University HealthSystem - Skokie Hospital, Skokie, Illinois.
Background: Reports of implant fracture at the modular junction have been seen in modular neck designs, stem-sleeve modular femoral stems, and diaphyseal engaging bi-body modular stems. To date, however, there has never been a direct comparison between 2 different implant designs from the same modular family. The purpose of this study is to compare the rate of implant failure of 2 such stem-sleeve modular femoral stem designs, the S-ROM and Emperion, to further identify factors which increase the risk of this mode of failure.
View Article and Find Full Text PDFJ Orthop Sci
January 2019
Department of Orthopedics Surgery, Toyama Prefectural Central Hospital, Japan.
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!