Increasing the structural complexity of chromium(IV) oxides by high-pressure and high-temperature reactions of CrO2.

Inorg Chem

Departamento de Química Inorgánica I, Universidad Complutense de Madrid, 28040 Madrid, Spain.

Published: October 2008

This work presents an overview of a series of increasingly complex oxides synthesized from CrO 2, under high-pressure and high-temperature conditions, having Cr (4+) in octahedral coordination. Although the emphasis is on the structure and microstructure of the compounds as obtained from X-ray diffraction and transmission electron microscopy and diffraction, attention is also given to their interesting electronic and magnetic properties. The study is complemented with an electron energy loss spectroscopic analysis of the different phases. These are the cubic perovskite SrCrO 3, the orthorhombic perovskite CaCrO 3, the solid solution Sr 1-xCa xCrO 3, the Ruddlesden-Popper-type Sr 3Cr 2O 7, the family CrSr 2RECu 2O 8 (RE = rare earth), a compositionally modulated perovskite "PbCrO 3", and the misfit layer oxide SrO 2[CrO 2] 1.85.

Download full-text PDF

Source
http://dx.doi.org/10.1021/ic801015bDOI Listing

Publication Analysis

Top Keywords

high-pressure high-temperature
8
increasing structural
4
structural complexity
4
complexity chromiumiv
4
chromiumiv oxides
4
oxides high-pressure
4
high-temperature reactions
4
reactions cro2
4
cro2 work
4
work presents
4

Similar Publications

Absorption spectroscopy is a widely used non-contact combustion diagnostic technique. HO is frequently used as the target molecule for combustion temperature measurement. However, correcting the baseline in broadened absorption spectroscopy under high pressure remains challenging.

View Article and Find Full Text PDF

Design of High-Temperature Superconducting Ternary Hydride NaY3H20 at Moderate Pressure via Introducing Hydrogen Vacancies.

Inorg Chem

January 2025

State Key Laboratory of Superhard Materials and Key Laboratory of Material Simulation Methods & Software of Ministry of Education, College of Physics, Jilin University, Changchun 130012, China.

Superconducting hydrides exhibiting a high critical temperature () under extreme pressures have garnered significant interest. However, the extremely high pressures required for their stability have limited their practical applications. The current challenge is to identify high- superconducting hydrides that can be stabilized at lower or even ambient pressures.

View Article and Find Full Text PDF

Lattice defect engineering advances n-type PbSe thermoelectrics.

Nat Commun

January 2025

School of Chemistry and Physics, ARC Research Hub in Zero-emission Power Generation for Carbon Neutrality, and Centre for Materials Science, Queensland University of Technology, Brisbane, QLD, Australia.

Te-free thermoelectrics have garnered significant interest due to their immense thermoelectric potential and low cost. However, most Te-free thermoelectrics have relatively low performance because of the strong electrical and thermal transport conflicts and unsatisfactory compatibility of interfaces between device materials. Here, we develop lattice defect engineering through Cu doping to realize a record-high figure of merit of ~1.

View Article and Find Full Text PDF

Poly (lactic acid) (PLA) is a widely produced bio-based polymer known for its biodegradability and renewability, but its brittleness, low heat resistance, and weak mechanical properties limit its broader use. To address these challenges, TEMPO-oxidized cellulose nanofibers (TOCNF) were extracted from dissolving pulp using TEMPO oxidation and high-pressure homogenization. These TOCNF were modified with silane to reduce hydrophilicity and improve compatibility with PLA.

View Article and Find Full Text PDF

Ultra-performance liquid chromatography coupled with quadrupole time-of-flight mass spectrometry(UPLC-Q-TOF-MS/MS) was used to rapidly identify the chemical components in Dracocephalum moldavica, and UPLC was employed to determine the content of its main components. MS analysis was performed using an electrospray ionization(ESI) source and data were collected in the negative ion mode. By comparing the retention time and mass spectra of reference compounds, and using a self-built compound database and the PubChem database, 68 compounds were identified from D.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!