Near-pure samples of (E)-phenylvinylacetylene ((E)-PVA) and (Z)-phenylvinylacetylene ((Z)-PVA) were synthesized, and their ultraviolet spectroscopy was studied under jet-cooled conditions. The fluorescence excitation and UV-UV holeburning (UVHB) spectra of both isomers were recorded. The S0-S1 origin of (E)-PVA occurs at 33,578 cm(-1), whereas that for (Z)-PVA occurs at 33,838 cm(-1), 260 cm(-1) above that for (E)-PVA. The present study focuses primary attention on the vibronic spectroscopy of (E)-PVA. Single vibronic level fluorescence spectra of many prominent bands in the first 1200 cm(-1) of the S0-S1 excitation spectrum of (E)-PVA were recorded, including several hot bands involving low-frequency out-of-plane vibrations. Much of the ground-state vibronic structure observed in these spectra was assigned by comparison with styrene and trans-beta-methylstyrene, assisted by calculations at the DFT B3LYP/6-311++G(d,p) level of theory. Both S0 and S1 states of (E)-PVA are shown to be planar, with intensity appearing only in even overtones of out-of-plane vibrations. Due to its longer conjugated side chain compared with that of its parent styrene, (E)-PVA supports extensive Duschinsky mixing among the four lowest-frequency out-of-plane modes (nu45-nu48), increasing the complexity of this mixing relative to that of styrene. Identification of the v'' = 0-3 levels of nu48, the lowest frequency torsion, provided a means of determining the 1D torsional potential for hindered rotation about the C(ph)-C(vinyl) bond. Vibronic transitions due to (Z)-PVA were first identified as small vibronic bands that did not appear in the UVHB spectrum recorded with the hole-burn laser fixed on the S0-S1 origin of (E)-PVA. The LIF and UVHB spectra of a synthesized sample of (Z)-PVA confirmed this assignment.

Download full-text PDF

Source
http://dx.doi.org/10.1021/jp803254dDOI Listing

Publication Analysis

Top Keywords

e-pva
8
uvhb spectra
8
s0-s1 origin
8
origin e-pva
8
out-of-plane vibrations
8
vibronic
5
spectroscopic characterization
4
characterization structural
4
structural isomers
4
isomers naphthalene
4

Similar Publications

The Mechanical Performance and Reaction Mechanism of Slag-Based Organic-Inorganic Composite Geopolymers.

Materials (Basel)

February 2024

Guangzhou Residential Construction Development Co., Ltd., Guangzhou 510075, China.

A series of organic-inorganic composite geopolymer paste samples were prepared with slag-based geopolymer and three types of hydrophilic organic polymers, i.e., PVA, PAA, and CPAM, by ordinary molding and pressure-mixing processes.

View Article and Find Full Text PDF

Construction of Marigold-like Poly(vinyl alcohol) Microspheres for Catalytic Microreactors.

ACS Appl Mater Interfaces

October 2023

State Key Laboratory of Polymer Materials Engineering, Polymer Research Institute of Sichuan University, Chengdu 610065, China.

It has long been pursued to develop polymer microspheres with various special morphologies and structures for better results in applications such as catalysis, drug delivery, and bioscaffolds. However, it remains a challenge to develop a facile method to produce poly(vinyl alcohol) (PVA) microspheres with special morphologies. Herein, a micron-sized marigold-like poly(vinyl alcohol) (C-PVA) microsphere was engineered and fabricated by a feasible strategy, that is, emulsification-cross-linking, freeze-drying, and secondary acetal reaction steps.

View Article and Find Full Text PDF

Introduction: Peripheral venous access (PVA) is recommended as a first-line vascular approach for therapeutic plasmapheresis with centrifugation methods but not filtration, which usually requires high blood flow. We evaluated the feasibility, efficacy, and safety of double-filtration plasmapheresis (DFPP) with PVA, using ultrasound guidance and regional citrate anticoagulation (RCA), i.e.

View Article and Find Full Text PDF

Photocatalytic and adsorptive performance of polyvinyl alcohol/chitosan/TiO composite for antibiotics removal: single- and multi-pollutant conditions.

Water Sci Technol

August 2022

Environmental and Water Resources Engineering Division, Department of Civil Engineering, IIT Madras, Chennai 600036, India E-mail:

A polymer-TiO macro composite (i.e., PVA-CS-TiO) was synthesized via chemical precipitation of PVA-CS-TiO blend in alkali/solvent medium and applied for the removal of three model antibiotics (i.

View Article and Find Full Text PDF

Poly(vinyl alcohol) (PVA) films annealed at different temperatures are used to explore the effects of the water absorption on the formation of PVA-iodine complexes. It's found that the higher the annealing temperature, the stronger the interaction force between PVA segments, and the smaller the free volume of the PVA films. These mainly lead to the reduction of the amount of PVA segments with a moderate degree of hydration (, PVA segments with moderate mobility), which are the major segments participating in the formation of PVA-iodine complexes.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!