This paper proposes a novel design for a microfuel cell as an on-chip power source and demonstrates its fabrication and operation to prove the concept. Its simple design is important from the viewpoints of fabrication (e.g., replication), integration, and compatibility with other microdevices. In testing, the prototype cell was able to generate electric power (maximum: ca. 1.4 microW) on methanol without pumps under both neutral and acidic conditions. As for the size, the electrode part of the cell (two cathodes and one anode) is 400 microns in width and 6 mm in length. The evaluation demonstrated that the proposed design is a promising on-chip power source for miniature devices.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1021/ja8024214 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Life Cycle Economic and Environmental Assessment for Emerging Heavy-Duty Truck Powertrain Technologies in China: A Comparative Study of Battery Electric, Fuel Cell Electric, and Hydrogen Combustion Engine Trucks.
Environ Sci Technol
January 2025
Saudi Aramco, Dhahran 31311, Saudi Arabia.
Amid ambitious net-zero goals and growing demands for freight logistics, addressing the climate challenges posed by the heavy-duty truck (HDT) sector is an urgent and pivotal task. This study develops an integrated HDT model by incorporating vehicle dynamic simulation and life cycle analysis to quantify energy consumption, greenhouse gas (GHG) emissions, and total cost of ownership associated with three emerging powertrain technologies in various truck use scenarios in China, including battery electric, fuel cell electric, and hydrogen combustion engine trucks. The results reveal varying levels of economic suitability for these powertrain alternatives depending on required driving ranges and duty cycles: the battery electric for regional-haul applications, the hydrogen fuel cell for longer-haul and low-load driving conditions, and the hydrogen combustion engine to meet high power requirements.
View Article and Find Full Text PDFDry-Solid-Electrochemical Synthesis: A General Method for Large Scale Synthesis of Single-Atom Catalysts with High Metal loadings.
Angew Chem Int Ed Engl
January 2025
Chang Chun Institute of Applied Chemistry Chinese Academy of Sciences, State Key Laboratory of Electroanalytical Chemistry, 5625 Renmin Street, 130022, Changchun, CHINA.
Single-atom catalysts (SACs) with high metal loadings are highly desirable but still challenging for large scale synthesis. Here we report a new technique named as dry-solid-electrochemical synthesis (DSES) for a general large-scale synthesis of SACs with high metal loadings in an energy-conservation and environment-friendly way. With it, a series of pure carbon-supported metal SACs (Platinum up to 35.
View Article and Find Full Text PDFTransfusion efficacy of leucoreduced packed red blood cells prepared by two different methods: A randomized controlled trial in transfusion-dependent thalassaemia patients (FUEL trial).
Vox Sang
January 2025
Department of Transfusion Medicine, Postgraduate Institute of Medical Education and Research (PGIMER), Chandigarh, India.
Background And Objectives: Great variations may be observed in the haemoglobin (Hb) content of packed red blood cell (PRBC) units prepared by different methods. This study aimed to assess the Hb increment in thalassaemia major patients transfused with leucoreduced PRBCs (LPRBCs) prepared by two different methods: (i) standard leucoreduced PRBCs (SLPRBCs) and (ii) leucoreduced PRBCs prepared by a new method where leucoreduction of whole blood is done first (NLPRBCs).
Materials And Methods: This prospective, randomized, controlled trial included 80 adult thalassaemia major patients who were randomized into two groups of 40 each.
Study of the self-degradation performance of a passive direct methanol fuel cell with an Fe-N-C catalyst.
Dalton Trans
January 2025
School of Astronautics, Harbin Institute of Technology, Harbin, China.
Fe-N-C catalysts are considered promising substitutes for Pt-based catalysts at the cathode in direct methanol fuel cells (DMFCs) owing to their great methanol tolerance. However, Fe-N-C-based DMFCs commonly suffer from a decreased performance under extremely high methanol concentrations and exhibit poor stability, while the underlying mechanism remains controversial. In this study, a self-degradation phenomenon in a passive Fe-N-C-based DMFC was investigated in detail.
View Article and Find Full Text PDFDesigning High Content Carbonylated β-Cyclodextrin/PBI Mixed Matrix Membrane as HT-PEM to Reduce HPO Loss.
Langmuir
January 2025
Department of Chemistry and Chemical Engineering, Hunan Institute of Science and Technology, Yueyang, 414000 Hunan, P. R. China.
The high-temperature proton exchange membranes suffer from weak binding strength for phosphoric acid molecules, which seriously reduce the fuel cell efficiency, especially operation stability. Introduction of microporous material in the membrane can effectively reduce the leaching of phosphoric acid. However, due to the poor compatibility between the polymer and fillers, the membrane's performance significantly reduced at high fillers content.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!