A methodology for monitoring low level of caffeine in aqueous samples via gas chromatography coupled with an ion-trap tandem mass spectrometry detection system (IT-MS/MS) was developed. Four IT-MS/MS operating parameters, including the collision-induced dissociation (CID) voltage, the excitation time (ET), the isolation time (IT) and the maximum ionization time (MIT) were optimized in order to maximize the sensitivity of the IT-MS/MS technique towards the analyte and its isotope-labeled standard. After optimization, a limit of detection of 500 fg microl(-1) with S/N = 3 was achieved. Taking into account blank values and the matrix background, a method detection limit of 1.0-2.0 ng l(-1) was derived and applied to all of the samples analyzed in the study. Various mass spectrometric conditions have been applied to caffeine and its trimethyl-(13)C-labeled standard to elucidate fragmentation pathways for new and commonly occurring product ions observed in the collision-induced dissociation (CID) spectra produced by the ion trap. Ion structures and fragmentation pathway mechanisms have been proposed and compared with previously published data. An isotope dilution method using (13)C-labeled caffeine as a surrogate internal standard was employed to determine and correct the recovery of native caffeine in water samples. The developed methodology has been applied for the determination of caffeine in surface marine and freshwater samples collected on the west coast of Vancouver Island in British Columbia, Canada. The results obtained for the marine water samples indicated a wide variation in the level of caffeine, ranging from 4.5 to 149 ng l(-1), depending on the location of the sampling site within the inlet. The concentrations of caffeine in samples from lakes associated with various residential densities ranged from ND to 6.5, 1.8 to 10.4 and 6.1 to 21.7 ng l(-1) for low, moderate and high residential densities, respectively.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1007/s00216-008-2174-x | DOI Listing |
J Biomater Sci Polym Ed
January 2025
Novel Drug Delivery Systems Laboratory, Faculty of Pharmacy, Medical Sciences/University of Tehran, Tehran, Iran.
Analyzing the chemical composition of different kinds of acrylic cement is necessary to understand their properties and suitability for curing bone defects. Conducting various chemical tests can give valuable insight into the composition, viscosity, and performance characteristics of each kind of cement, Therefore, our study aimed to find safety standards and the effectiveness of these products for medical applications. The polymeric characterization was determined by Nuclear Magnetic Resonance (H-NMR) spectroscopy and Fourier-transform infrared spectroscopy (FTIR).
View Article and Find Full Text PDFSci Total Environ
January 2025
Social Development and Health Promotion Research Center, Health Policy and Promotion Institute, Kermanshah University of Medical Sciences, Kermanshah, Iran. Electronic address:
Nowadays, polyethylene terephthalate (PET) bottles are widely used for packaging drinks and food. However, concerns have been raised about the possible migration of harmful chemicals, particularly phthalates, from these containers into their contents. Therefore, this study investigates the effects of sunlight exposure and PET bottle reuse on phthalate migration, focusing on three common phthalates: bis(2-ethylhexyl) phthalate (DEHP), dibutyl phthalate (DBP), and benzyl butyl phthalate (BBP).
View Article and Find Full Text PDFMethods Mol Biol
January 2025
Laboratory of Analytical Biochemistry & Metabolomics, Biology Centre, Czech Academy of Sciences, České Budějovice, Czech Republic.
A simple analytical workflow is described for gas chromatographic-mass spectrometric (GC-MS)-based chiral profiling of secondary amino acids (AAs) in biological matrices. The sample preparation is carried out directly in aqueous biological sample extracts and involves in situ heptafluorobutyl chloroformate (HFBCF) derivatization-liquid-liquid microextraction of nonpolar products into hexane phase followed by subsequent formation of the corresponding methylamides from the HFB esters by direct treatment with methylamine reagent solution. The (O, N) HFB-butoxycarbonyl-methylamide AA products (HFBOC-MA) are separated on a Chirasil-L-Val capillary column and quantitatively measured by GC-MS operated in selected ion monitoring (SIM) mode.
View Article and Find Full Text PDFArch Toxicol
January 2025
STARTNETICS - Department of Chemical Science and Technologies, University of Rome Tor Vergata, Via della Ricerca Scientifica 1, 00133, Rome, Italy.
Femtosecond lasers represent a novel tool for tattoo removal as sources that can be operated at high power, potentially leading to different removal pathways and products. Consequently, the potential toxicity of its application also needs to be evaluated. In this framework, we present a comparative study of Ti:Sapphire femtosecond laser irradiation, as a function of laser power and exposure time, on water dispersions of Pigment Green 7 (PG7) and the green tattoo ink Green Concentrate (GC), which contains PG7 as its coloring agent.
View Article and Find Full Text PDFJ Food Sci
January 2025
Spice and Beverage Research Institute, Chinese Academy of Tropical Agricultural Sciences, Wanning, China.
Fermentation is crucial for inducing desirable flavor and aroma profiles in cocoa products. This research focused on identifying microbial strains isolated from spontaneous cocoa fermentation in Hainan through 16S and Internal Transcribed Spacer (ITS) sequencing. Pectinase activity was screened, and metabolic dynamics of sugars and organic acids were analyzed using high-performance liquid chromatography.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!