Motor control of jaw muscles in chewing and in isometric biting with graded narrowing of jaw gape.

When a certain bite force is applied during unilateral chewing, the combination of jaw elevator muscle activities is different than when a comparable force is applied in unilateral isometric biting, e.g. on a force transducer. Masticatory peak force is generated in a nearly isometric phase of the chewing cycle, with a jaw gape of about 1 mm. In contrast, peak force in isometric biting on force measuring equipment usually induces jaw gapes of 6 mm or even more. Therefore, we tested the hypothesis that the jaw gape influences relative activation of elevator muscles in unilateral isometric biting. We further examined whether such influence could explain the different activity combinations of chewing and isometric biting. In thirty asymptomatic males, masseter and temporalis activities were recorded during intermittent isometric biting with jaw gapes of 6, 5, 3, 2 and 1 mm and during unilateral chewing. Activity combinations were described by working/balancing ratios and by temporalis/masseter ratios. With decreasing jaw gape the working/balancing ratio of the posterior temporalis decreased (P < 0.002) while that of the masseter increased (P < 0.001). Likewise, the temporalis/masseter ratio on the balancing side increased (P < 0.001). With decreasing jaw gape, activity ratios of isometric biting approached ratios of chewing. We conclude that: (i) relative jaw muscle activation in isometric biting depends on the jaw gape, (ii) relative muscle activation in chewing resembles relative activation of isometric biting with a small 'chewing-like' gape. This suggests that characteristic activity combinations in chewing are mainly a result of the approximately isometric contraction during the slow closing phase of the chewing cycle.