Purpose: The purposes of this study were to determine the relation between the graft tension and the knee flexion angle in the anteromedial (AM) and posterolateral (PL) bundles of a clinically simulated anatomic double-bundle anterior cruciate ligament (ACL) reconstruction procedure and to clarify the effect of initial tension on the tension-versus-flexion curve of each graft, as well as the effect of internal rotation of the tibia on the tension of the 2 grafts.

Methods: During ACL reconstruction in 30 patients, 2 suture anchors with a No. 1 polyester suture were firmly screwed into the center of the anatomic attachment of the AM and PL bundles on the femur, respectively, and each graft tension was measured with a strain gauge-type tensiometer attached at the end of the suture under 2 conditions of initial tension.

Results: The averaged tension-versus-flexion curves were significantly different between the AM and PL grafts under each initial tension condition (P < .0001). The initial tension applied at 30 degrees of knee flexion significantly affected the absolute values of each graft tension at each knee flexion angle (P < .0001) but did not significantly affect the tension-versus-flexion curve pattern of each graft. The maximal internal rotation of the tibia significantly increased the tension on both the AM and PL grafts at knee flexion angles of less than 60 degrees under each initial tension condition (P < .0001).

Conclusions: The tension-versus-flexion curves of the 2 sutures, which mimicked the AM and PL grafts reconstructed clinically with the anatomic double-bundle ACL reconstruction procedure, were significantly different in the tension values. Differences in initial tension applied to the 2 grafts significantly affected the absolute values of each graft tension at each knee flexion angle but did not significantly affect the tension-versus-flexion curve pattern. The maximal internal rotation of the tibia significantly increased the tension on both the AM and PL suture grafts at knee flexion angles of less than 60 degrees .

Level Of Evidence: Level I, testing of previously developed diagnostic criteria in series of consecutive patients with universally applied gold standard.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.arthro.2007.08.031DOI Listing

Publication Analysis

Top Keywords

initial tension
24
knee flexion
24
flexion angle
16
graft tension
16
tension
14
anatomic double-bundle
12
tension knee
12
acl reconstruction
12
tension-versus-flexion curve
12
internal rotation
12

Similar Publications

Migrasome formation is initiated preferentially in tubular junctions by membrane tension.

Biophys J

January 2025

Department of Physiology and Pharmacology, Sackler Faculty of Medicine, Tel Aviv University, Tel Aviv, Israel; Center for Physics and Chemistry of Living Systems, Tel Aviv University, Tel Aviv, Israel. Electronic address:

Migrasomes, the vesicle-like membrane micro-structures, arise on the retraction fibers (RFs), the branched nano-tubules pulled out of cell plasma membranes during cell migration and shaped by membrane tension. Migrasomes form in two steps: a local RF bulging is followed by a protein-dependent stabilization of the emerging spherical bulge. Here we addressed theoretically and experimentally the previously unexplored mechanism of bulging of membrane tubular systems.

View Article and Find Full Text PDF

To address the challenge of reusing foaming agents in foam drainage gas production processes, we developed a redox-responsive surfactant with a straightforward preparation method based on molecular electrostatic interaction assembly. The redox response mechanism of the surfactant was investigated through surface tension, absorbance, particle size, and Zeta potential analyses. Results indicate that the minimum surface tension in the oxidized state can reach 26.

View Article and Find Full Text PDF

Electroporation ablation is a minimally invasive nonthermal ablation technology that is applied to tumor ablation therapy. Given the varied morphologies of tumor cells, when an electric field is applied to the cell membrane surface, the direction of the electric field produces various angles with normal to the tangential plane of the cell membrane. In this study, we investigated the impact of cell morphology on membrane electroporation characteristics by adjusting the angle of the electric field relative to the cell membrane by using molecular dynamics simulations.

View Article and Find Full Text PDF

Background: Little attention has been paid to the experiences of clinicians and health personnel who provide heroin-assisted treatment (HAT). This study provides the first empirical findings about the clinicians' experiences of providing HAT in the Norwegian context.

Methods: 23 qualitative interviews were conducted with 31 clinicians shortly after HAT clinics opened in Norway's two largest cities: Oslo and Bergen.

View Article and Find Full Text PDF

Statement Of Problem: The angled screw channel (ASC) design has been well accepted for implant prostheses. However, investigation into the behavior of the ASC connection is sparse.

Purpose: The purpose of this in vitro study was to assess the effect of cyclic loading on the internal connection of an ASC system compared with straight access systems by measuring reverse torque values (RTVs) and using microcomputed tomography (µCT) imaging.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!