ECOSAR model performance with a large test set of industrial chemicals.

Chemosphere

Department of Product Safety, BASF SE, 67056 Ludwigshafen, Germany.

Published: May 2008

The widely used ECOSAR computer programme for QSAR prediction of chemical toxicity towards aquatic organisms was evaluated by using large data sets of industrial chemicals with varying molecular structures. Experimentally derived toxicity data covering acute effects on fish, Daphnia and green algae growth inhibition of in total more than 1,000 randomly selected substances were compared to the prediction results of the ECOSAR programme in order (1) to assess the capability of ECOSAR to correctly classify the chemicals into defined classes of aquatic toxicity according to rules of EU regulation and (2) to determine the number of correct predictions within tolerance factors from 2 to 1,000. Regarding ecotoxicity classification, 65% (fish), 52% (Daphnia) and 49% (algae) of the substances were correctly predicted into the classes "not harmful", "harmful", "toxic" and "very toxic". At all trophic levels about 20% of the chemicals were underestimated in their toxicity. The class of "not harmful" substances (experimental LC/EC(50)>100 mg l(-1)) represents nearly half of the whole data set. The percentages for correct predictions of toxic effects on fish, Daphnia and algae growth inhibition were 69%, 64% and 60%, respectively, when a tolerance factor of 10 was allowed. Focussing on those experimental results which were verified by analytically measured concentrations, the predictability for Daphnia and algae toxicity was improved by approximately three percentage points, whereas for fish no improvement was determined. The calculated correlation coefficients demonstrated poor correlation when the complete data set was taken, but showed good results for some of the ECOSAR chemical classes. The results are discussed in the context of literature data on the performance of ECOSAR and other QSAR models.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.chemosphere.2007.12.006DOI Listing

Publication Analysis

Top Keywords

industrial chemicals
8
effects fish
8
fish daphnia
8
algae growth
8
growth inhibition
8
correct predictions
8
"not harmful"
8
data set
8
daphnia algae
8
ecosar
6

Similar Publications

Photolithography is the most widely used micropatterning technique at the micro- and nanoscale in device fabrication. However, traditional photoresists used in photolithography are typically nonaqueous-based toxic substances that require harsh conditions for processing, limiting the development of biofunctional and biocompatible micropatterns. In this study, a protein-based aqueous photoresist derived from chemically modified silk fibroin named SAMA, capable of achieving high-resolution micropatterning (<1.

View Article and Find Full Text PDF

Pulsed-Current Operation Enhances HO Production on a Boron-Doped Diamond Mesh Anode in a Zero-Gap PEM Electrolyzer.

ChemSusChem

January 2025

Department of Chemical Engineering, MESA+ Institute for Nanotechnology, Faculty of Science and Technology, University of Twente, Drienerlolaan 5, 7522 NB, Enschede, The, Netherlands.

A niobium (Nb) mesh electrode was coated with boron-doped diamond (BDD) using chemical vapor deposition in a custom-built hot-filament reactor. The BDD-functionalized mesh was tested in a zero-gap electrolysis configuration and evaluated for the anodic formation of HO by selective oxidation of water, including the analysis of the effects on Faradaic efficiency towards HO (FEH2O2) induced by pulsed electrolysis. A low electrolyte flow rate (V⋅) was found to result in a relatively high concentration of HO in single-pass electrolysis experiments.

View Article and Find Full Text PDF

n-butane (n-C4H10) and isobutane (i-C4H10) are important raw materials in chemical industry. The separation of the two hydrocarbon isomers via distillation is challenging and energy-consuming. Herein we report the adsorption behavior of a microporous cobalt formate framework [Co3(HCOO)6] for potential kinetic separation of butane isomers.

View Article and Find Full Text PDF

Surface Modification of Polyvinylidene Fluoride Latex Nanoparticles through Chain Entanglement by Poly(meth)acrylate Monomer Swelling Seeded Emulsion Polymerization.

Langmuir

January 2025

School of Chemistry and Chemical Engineering, State Key Laboratory of Polyolefins and Catalysis, Shanghai Jiao Tong University, 800 Dongchuan Road, Shanghai 200240, P. R. China.

Polyvinylidene fluoride (PVDF) latex nanoparticles serve as a versatile platform for surface modification due to their role as precursors in PVDF manufacturing. However, the strong chemical stability and poor compatibility of PVDF present significant challenges for effective surface modification. To address this, we developed a method that facilitates surface modification through chain entanglement.

View Article and Find Full Text PDF

The agricultural sector of any country plays a pivotal role in its economy. Irrigation and the provision of appropriate nutrient levels in soil are essential for optimizing plant growth and enhancing crop productivity. To support the increasing need for food due to the growing population worldwide, synthetic fertilizers have been widely used in the agricultural sector.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!